Shenoy, PS | Search NASA

DOE OSTI2013

Differential Power Processing for Increased Energy Production and Reliability of Photovoltaic Systems

Conventional energy conversion architectures in photovoltaic (PV) systems are often forced to tradeoff conversion efficiency and power production. This paper introduces an energy conversion approach that enables each PV element to operate at its maximum power point (MPP) while processing only a small fraction of the total power produced. This is accomplished by providing only the mismatch in the MPP current of a set of series-connected PV elements. Differential power processing increases overall conversion efficiency and overcomes the challenges associated with unmatched MPPs (due to partial shading, damage, manufacturing tolerances, etc.). Several differential power processing architectures are analyzed and compared with Monte Carlo simulations. Local control of the differential converters enables distributed protection and monitoring. Reliability analysis shows significantly increased overall system reliability. Simulation and experimental results are included to demonstrate the benefits of this approach at both the panel and subpanel level.

Shenoy, PS↗

DOE OSTI2013

Differential Power Processing for DC Systems

This paper introduces an approach to dc power delivery that reduces power loss by minimizing redundant energy conversion. Existing power distribution techniques tend to increase the number of cascaded conversion stages, which limits overall efficiency. Differential power processing enables independent load regulation, while processing only a small portion of the total load power. Bulk power conversion occurs once. Load voltage domains are connected in series, and differential converters act as controllable current sources to regulate intermediate nodes. This enables independent, low supply voltages, which can reduce system energy consumption, especially in digital circuits and solid-state lighting. Since differential voltage regulators process a fraction of the load power, decreased size, cost, and conversion losses are attainable. Under balanced load conditions, secondary differential converters do not process any power. This paper analyzes several differential power delivery architectures that can be applied to homogenous and heterogeneous loads at various levels: chip, board, blade, etc. A variety of operating conditions for a test system with four series voltage domains are examined in simulation and verified with experimental hardware. Results in a reference application show a 7-8% decrease in input power and 6-7 percentage points increase in overall conversion efficiency as compared to a conventional cascaded approach.

Shenoy, PS↗