Engineering topics
Publications and source records attributed to Shiller, Zvi.
Method of planning motions of object to prevent collisions with other moving objects derived from concept of collision cones in relative-velocity space. Collision cones computed, then maneuvers chosen to avoid these cones. Method considered prototype of automated method of planning motions in diverse applications, including complex manufacturing tasks involving coordination of multiple robots and controlling land, air, and sea traffic.
This paper presents a new approach for robot motion planning in dynamic.
A method for computing the time-optimal motions of robotic manipulators is presented that considers the nonlinear manipulator dynamics, actuator constraints, joint limits, and obstacles. The optimization problem is reduced to a search for the time-optimal path in the n-dimensional position space. A small set of near-optimal paths is first efficiently selected from a grid, using a branch and bound search and a series of lower bound estimates on the traveling time along a given path. These paths are further optimized with a local path optimization to yield the global optimal solution. Obstacles are considered by eliminating the collision points from the tessellated space and by adding a penalty function to the motion time in the local optimization. The computational efficiency of the method stems from the reduced dimensionality of the searched spaced and from combining the grid search with a local optimization. The method is demonstrated in several examples for two- and six-degree-of-freedom manipulators with obstacles.
A method is presented to obtain the time-optimal motions for robotic manipulators. It considers the full nonlinear dynamics of the manipulator, its actuator saturation limits, and gripper and payload constraints. It also accounts for both the presence of obstacles in the work space and restrictions on the motion of the manipulator's joints. The method is computationally practical and has been implemented for the optimal trajectory planning of general six degree-of-freedom manipulators. Examples are presented that demonstrate the substantial improvement in manipulator performance that can be achieved using this method.
A practical method to obtain the global time optimal motions of robotic manipulators is presented. This method takes into account the nonlinear manipulator dynamics, actuator constraints, joint limits, and obstacles. Previously developed methods of optimizing manipulator motions along given paths and a local path optimization are utilized. A set of best paths is obtained first in a global search over the manipulator workspace, using graph search and hierarchical pruning techniques. These paths are used as initial conditions for a continuous path optimization to yield the global optimal motion. Examples of optimized motions of a six-degree-of-freedom manipulator, operating in a three-dimensional space with obstacles, are presented.
The concept of acceleration lines and their correlation with time-optimal paths of robotic manipulators is presented. The acceleration lines represent the directions of maximum tip acceleration from a point in the manipulator work-space, starting at a zero velocity. These lines can suggest the number and shapes of time-optimal paths for a class of manipulators. It is shown that nonsingular time-optimal paths are tangent to one of the acceleration lines near the end-points. A procedure for obtaining near-optimal paths, utilizing the acceleration lines, is developed. These paths are obtained by connecting the end-points with B splines tangent to the acceleration lines. The near-minimum paths are shown to yield better traveling times than the straight-line path between the same end-points. The near-minimum paths can be used as initial conditions in existing optimization methods to speed-up convergence and computation time. This method can be used for online robot path planning and for interactive designs of robotic-cell layouts. Examples of time-optimal paths of a two-link manipulator, obtained by other optimization procedures and their acceleration lines, are shown.