Search NASA⌕ Search

Engineering topics

Shiriyev, Javid

Publications and source records attributed to Shiriyev, Javid.

Inversion of downhole electrical measurements for proppant mapping using very fast simulated annealing

Proppant mapping is critical for optimizing fracture treatment design and improving wells’ productivity. An electrode-based resistivity tool concept was developed earlier for proppant mapping in cased-hole wells. An array of insulating gaps is installed and cemented in place as a permanent part of the casing string. The electrical measurements are performed by imposing a voltage across each insulating gap, one at a time, before and after hydraulic fracture operations. The voltages across other insulating gaps near the transmitter gap are recorded. The method relies on direct excitation of the casing, which is expected to overcome the severe limitations of induction tools in cased-hole wells. A forward model based on a finite volume method has been developed to simulate the tool’s response to one or multiple fractures. To enable the implementation of such a practical system in multistage fractured horizontal wells, a fast and robust inversion approach is required. To that end, we have developed a divide-and-conquer approach based on a global optimization algorithm very fast simulated annealing (VFSA). Specifically, the original inverse problem is divided into subproblems and each subproblem can be solved separately using VFSA. The results indicate that our approach can invert the data and output widths and radii of multiple fractures without requiring a large number of forward simulations. The robustness of the inverse solver is also tested by adding Gaussian noise to the synthetic data. We tested example cases that demonstrate that when up to 5% noise is introduced, VFSA still provides very accurate inversion results with moderate uncertainties. Inversion results with some more realistic conditions, e.g., tilted fractures, complex fractures, and so on, are also presented.

Geochemistry & Geophysics↗

Fracture Diagnostics Using Low Frequency Electromagnetic Induction and Electrically Conductive Proppants

The monitoring and diagnostics of induced fractures are important for the real-time performance evaluation of hydraulic fracturing operations. Previous electromagnetic (EM) based studies show that single backbone tri-axial induction logging tools are promising candidates for real-time monitoring and diagnosis of fractures in open-hole wells. To support the development of field deployable tools, the concept must be tested in experiments, in a controllable environment, before it is tested under field-like conditions. To this end, we have developed numerical tools which can simulate any wellbore environment while logging hydraulic fractures with the induction tool. We have designed and built a prototype induction tool and performed two sets of tests to compare with numerical simulation results. The computational and experimental setup consists of tri-axial transmitter- and receiver-coils in co-axial, co-planar and cross-polarized configurations. Both lab and shallow earth measurements are shown to be in good agreement with simulations for all examined cases. The average relative and maximum discrepancies of the measured signals from the simulated ones were lower than 3% and 10%, respectively. With the prototype tool, strong signals sensitive to the fracture’s surface area and dip-angle were measured in co-axial coil configuration, while weaker signals sensitive to the fracture’s aspect ratio were observed in the co-planar configuration. Cross-polarized signals are also shown to be strong and sensitive to the fracture’s dip. Lastly, we resolved the detectable components of the signal tensor to obtain parameters of simplified fracture geometries. The inversion algorithm, a derivative free directional search model, uses an objective function defined as a combination of co-axial and cross-polarized signals from different tool spacings to provide a well behaved global minimum. The robustness of inversion algorithm is tested on synthetic data for single cluster fractures in homogeneous and heterogeneous background electrical conductivity. All the effective model parameters for different cases, fracture conductivity (width), propped area (length) and dip-angle, are shown to be recovered with sufficient accuracy. We also evaluated the effect of multiple neighboring fractures and suggested a multi-cluster inversion algorithm that can accurately recover the proppant distribution in each fracture. Based on these results we provide a downhole tool design, with detailed specifications, that can effectively recover far-field proppant distribution in hydraulic fractures.

02 PETROLEUM↗