Search NASA⌕ Search

Engineering topics

Sievers, Carsten

Publications and source records attributed to Sievers, Carsten.

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Evaluating the Role of Metastable Surfaces in Mechanochemical Reduction of Molybdenum Oxide

Mechanochemistry and mechanocatalysis are gaining increasing attention as environmentally friendly chemical processes because of their solvent-free nature and scalability. Significant effort has been devoted for studying continuum-scale phenomena in mechanochemistry, such as temperature and pressure gradients, but the atomic-scale mechanisms remain relatively unexplored. In this work, we focus on the mechanochemical reduction of MoO3 as a case study. We use experimental techniques to determine the mechanochemical reduction conditions and density functional theory (DFT) simulations to establish an atomistic framework for identifying the metastable surfaces that are most likely to enable this process. Our results show that metastable surfaces can significantly lower or remove thermodynamic barriers for surface reduction and that kinetic energy from milling can facilitate the formation of metastable surfaces that have high surface fracture energies and are not thermally accessible. These findings indicate that metastable surfaces are an important aspect of mechanochemistry along with hot spots and other continuum-scale phenomena.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Mechanocatalytic Hydrogenolysis of the Lignin Model Dimer Benzyl Phenyl Ether over Supported Palladium Catalysts

This work demonstrates the mechanocatalytic hydrogenolysis of the ether bond in the lignin model compound benzyl phenyl ether (BPE) and hardwood lignin isolated by hydrolysis with supercritical water. Pd catalysts with 4 wt % loading on Al 2 O 3 and SiO 2 supports achieve 100% conversion of BPE with a toluene production rate of (2.6–2.9) × 10 –5 mol·min –1 . The formation of palladium hydrides under H 2 gas flow contributes to an increase in the turnover frequency by a factor of up to 300 compared to Ni on silica–alumina. While a near-quantitative toluene yield is obtained, some of the phenolic products remain adsorbed on the catalyst.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Insights into the Oxidative Degradation Mechanism of Solid Amine Sorbents for CO 2 Capture from Air: Roles of Atmospheric Water

Abstract Direct air capture (DAC) processes for extraction of CO 2 from ambient air are unique among chemical processes in that they operate outdoors with minimal feed pretreatments. Here, the impact of humidity on the oxidative degradation of a prototypical solid supported amine sorbent, poly(ethylenimine) (PEI) supported on Al 2 O 3 , is explored in detail. By combining CO 2 adsorption measurements, oxidative degradation rates, elemental analyses, solid‐state NMR and in situ IR spectroscopic analysis in conjunction with 18 O labeling of water, a comprehensive picture of sorbent oxidation is achieved under accelerated conditions. We demonstrated that the presence of water vapor can play an important role in accelerating the degradation reactions. From the study we inferred the identity and kinetics of formation of the major oxidative products, and the role(s) of humidity. Our data are consistent with a radical mediated autooxidative degradation mechanism.

Carneiro, Juliana S. A.↗
DOE OSTI2023

Insights into the Oxidative Degradation Mechanism of Solid Amine Sorbents for CO 2 Capture from Air: Roles of Atmospheric Water

Direct air capture (DAC) processes for extraction of CO 2 from ambient air are unique among chemical processes in that they operate outdoors with minimal feed pretreatments. Here, the impact of humidity on the oxidative degradation of a prototypical solid supported amine sorbent, poly(ethylenimine) (PEI) supported on Al 2 O 3 , is explored in detail. By combining CO 2 adsorption measurements, oxidative degradation rates, elemental analyses, solid-state NMR and in situ IR spectroscopic analysis in conjunction with 18 O labeling of water, a comprehensive picture of sorbent oxidation is achieved under accelerated conditions. Here we demonstrated that the presence of water vapor can play an important role in accelerating the degradation reactions. From the study we inferred the identity and kinetics of formation of the major oxidative products, and the role(s) of humidity. Our data are consistent with a radical mediated autooxidative degradation mechanism.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

Supported molybdenum oxides for the aldol condensation reaction of acetaldehyde

The (retro-)aldol condensation reaction is an important chemical transformation in the upgrading of biomass-derived compounds into fuels and valuable specialty chemicals. In this study, we found that supported molybdenum oxide (MoO x ) catalysts were active and selective for the aldol condensation of acetaldehyde to crotonaldehyde under steady-state reactor conditions. Through a combination of transmission electron microscopy (TEM), ultraviolet–visible (UV–VIS) diffuse reflectance spectroscopy, Fourier transform infrared (FTIR) spectroscopy of adsorbed pyridine, and steady-state reactor testing, we determined that highly dispersed MoO x has a strong interaction with a γ-Al 2 O 3 support resulting in optimal catalyst performance at low weight loadings. In contrast, MoO x particles supported on SiO 2 have a weaker interaction with the support, resulting in a monotonic relationship between Mo loading and aldol condensation activity. The Lewis acid site density and strength are important parameters for predicting aldol condensation activity across all samples. The concentration of weak acid sites had a poor correlation with aldol condensation activity, most likely because these sites are too weak to activate acetaldehyde for the reaction. Medium and strong acid sites both had good correlations to aldol condensation activity. Results from X-ray absorption near edge structure (XANES) and acetaldehyde temperature programmed desorption (TPD) indicated that partially reduced MoO x was more active for aldol condensation, but pretreatment in reducing or oxidizing environments had no significant effect on steady-state catalytic activity. Finally, characterization of spent catalyst samples through temperature programmed oxidation (TPO) and thermogravimetric analysis (TGA) revealed that catalysts with high densities of strong acid sites tended to form more carbonaceous deposits on the surface over the course of the reaction.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Reaction paths of methane activation and oxidation of surface intermediates over NiO on Ceria-Zirconia catalysts studied by In-situ FTIR spectroscopy

Methane activation over NiO/Ce 0.82 Zr 0.18 O 2 catalysts synthesized by combustion synthesis is studied by in-situ IR spectroscopy and correlated to the properties and oxygen speciation of the catalyst. Through XRD, H 2 -TPR, and pyridine adsorption followed by FTIR spectroscopy, the reducibility and Lewis acidity of the catalysts are assessed. In-situ FTIR spectroscopy is used to monitor the methane activation on catalyst surfaces. Complex IR features of methane-derived surface species are observed and are attributed to the formation of surface alkyl/alkoxy, aldehyde, formate/carbonate, and aromatic species. A data analysis algorithm is developed to evaluate the evolution of different surface species over time. The formation of formate and carbonate species is driven by adsorbed surface oxygen, while less reactive oxygen species associated with NiO allow for the production of aromatics and alkoxy intermediates. Finally, by tuning the reducibility and Lewis acidity of the catalyst, the selectivity to alkoxy intermediates can be improved.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Active oxygen species in heterogeneously catalyzed oxidation reactions

Active oxygen species generation in heterogeneously catalyzed hydrocarbon oxidation reactions have not been fully characterized. There is little consensus as to which the most active or selective species are. However, electron localization at a single oxygen atom—rather than shared over several—is necessary to activate very stable hydrocarbons like methane. This paper presents an overview of oxygen species formed on various catalytic surfaces and their role in hydrocarbon oxidation reactions. Since limitations of analytical methods are a significant bottleneck for understanding and engineering active oxygen species, approaches for characterizing and quantifying active oxygen are discussed. While several methods are effective for describing certain oxygen species, there is no method that comprehensively characterizes all active oxygen species. Here, the most promising approach is oxygen isotope exchange coupled with infrared spectrometry and inline mass spectrometry.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

In-situ IR Spectroscopy Study of Reactions of C3 Oxygenates on Heteroatom (Sn, Mo, and W) doped BEA Zeolites and the Effect of Co-adsorbed Water

The reactions of acetone and hydroxyacetone over heteroatom doped BEA zeolites (Sn, Mo, and W) in the presence and absence of H 2 O vapor are investigated using infrared spectroscopy. Acetone is converted to mesityl oxide over Sn-BEA exclusively. At higher temperatures, larger oxygenates such as phorones, aromatics, and coke form. The presence of co-adsorbed water in Sn-BEA suppresses tautomerization. H 2 O vapor is also beneficial for minimizing coke formation at high temperatures. Hydroxyacetone is converted into 2-hydroxypropanal over Sn-BEA, exhibiting high affinity to Sn sites up to 400 °C. Sn-BEA catalyzes conversion of hydroxyacetone into the enol in the absence of H 2 O, but exposure to H 2 O induces the formation of 2-hydroxypropanal and subsequent conversion to acrolein. Furthermore, the Lewis acid descriptors are used to rationalize the reaction pathways. For the isomerization of hydroxyacetone into 2-hydroxypropanal, the hardness of acid sites influences the reaction and correlates with the overall Lewis acidity of the catalysts, respectively. However, the size of the exchanged metal significantly affects aldol condensation, where keto and enol forms of acetone adsorb to active sites simultaneously.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Mechanocatalytic Ammonia Synthesis over TiN in Transient Microenvironments

Environmentally friendly and energy-efficient ways to produce ammonia are essential to meet global food demands. In this study, a new approach for ammonia production at nominally ambient conditions is introduced. As proof of concept, ammonia is synthesized mechanocatalytically by ball milling titanium in a continuous gas flow. The ammonia synthesis reaction is proposed to follow a transient Mars–van Krevelen mechanism under mechanically activated conditions, where molecular nitrogen incorporation into the titanium lattice and titanium nitride hydrogenation occur in thermodynamically distinct environments. X-ray powder diffraction and X-ray absorption spectroscopy confirm the formation of titanium nitride from titanium and N2. The reactivity of nitrided titanium supports that lattice nitrogen plays a role in ammonia formation. The in situ formed titanium nitride is catalytically active, and the nitride regeneration reaction is determined to be the rate-limiting step. A preliminary technoeconomic analysis shows that this approach could be feasible for distributed ammonia production.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗