Search NASASearch

Engineering topics

Silverberg, Robert

Publications and source records attributed to Silverberg, Robert.

Testbed for LISA Photodetectors

The Laser Interferometer Space Antenna (LISA) is a gravitational wave observatory consisting of three spacecraft separated by 5 million km in an equilateral triangle whose center follows the Earth in orbit around the Sun but offset in orbital phase by 20 degrees. LISA is designed to observe sources in the frequency range of 0.1 mHz-100 mHz by measuring fluctuations of the inter-spacecraft separation with laser interferometry. Quadrant photodetectors are used to measure both separation and angular orientation. Noise level, phase and amplitude inhomogeneities of the semiconductor response, and channel cross-talk between quadrant cells need to be assessed in order to ensure the 10 pm/Square root(Hz) sensitivity required for the interferometric length measurement in LISA. To this end, we are currently developing a testbed that allows us to evaluate photodetectors to the sensitivity levels required for LISA. A detailed description of the testbed and preliminary results will be presented.

Guzman, Felipe

Microshutter Arrays for NIRSpec

A primary science goal of the 6.5 m James Webb Space Telescope is to characterize the epoch of initial galaxy formation, observing the early universe as the first stars and galaxies formed. This program will be accomplished using a combination of multi-band imaging and spectroscopic measurements of large numbers of faint galaxies. Since these objects are in general sparse on the sky, a multi object spectrometer is required to enable this critical scientific investigation. We have developed a microshutter array which is to be used as a high contrast, remotely programmable field selector for the Near Infrared Spectrometer (NIRSpec) on JWST. This device allows slits to be opened at the locations of selected galaxies in the field of view, and blocks sources and background light from the rest of the field. The first flight design devices have been built and were tested. These first generation of devices were used to demonstrate performance and flight readiness. Devices of the same design will be delivered to ESA for installation into the NIRSpec instrument.

Silverberg, Robert

MEMS Microshutter Arrays for James Webb Space Telescope

MEMS microshutter arrays are being developed at NASA Goddard Space Flight Center for use as an aperture array for a Near-Infrared Spectrometer (NirSpec). The instruments will be carried on the James Webb Space Telescope (JWST), the next generation of space telescope after Hubble Space Telescope retires. The microshutter arrays are designed for the selective transmission of light with high efficiency and high contrast, Arrays are close-packed silicon nitride membranes with a pixel size of 100x200 microns. Individual shutters are patterned with a torsion flexure permitting shutters to open 90 degrees with a minimized mechanical stress concentration. Light shields are made on to each shutter for light leak prevention so to enhance optical contrast, Shutters are actuated magnetically, latched and addressed electrostatically. The shutter arrays are fabricated using MEMS technologies.

Li, Mary J.

Microshutters Arrays for the JWST Near Infrared Spectrometer

The Near Infrared Spectrograph (NIRSpec) for the James Webb Space Telescope (JWST) is an essential instrument for measuring the number and density evolution of galaxies following the epoch of initial formation. The NIRSpec is a multi-object spectrograph, allowing simultaneous observation of more than 100 candidate high redshift galaxies. A critical element of the instrument is the programmable field selector, the Microshutter Array. The system consists of four 175 x 384 arrays of individually openable shutters, close packed on a 100 x 200 micron pitch, which allow selection of over 200 candidate objects over the 3 min x 3 min field of the NIRSpec. We will describe the development, production, and test of this critical element of the NIRSpec.

Moseley, Harvey

The Design and Performance of the 384: Element Submillimeter Detector Array for SHARC II

We report on the performance of the SHARC II detector, a 12 x 32 array of ion implanted Si pop-up bolometers. This 384 element detector array was built as a prototype for the High Angular Resolution Widefield Camera (HAWC) for the Stratospheric Observatory for Infrared Astronomy (SOFIA). We will discuss the design process, the characterization of the detectors, and the performance of the array in the SHARC II instrument. SHARC II is now a facility instrument on the Caltech Submillimeter Observatory, providing background-limited imaging at 350 and 450 microns.

Moseley, Samuel H.