Engineering topics
Singh, Kaustabh
Publications and source records attributed to Singh, Kaustabh.
Thermal testing of a Mars 2020 enhanced engineering camera
The upcoming Mars 2020 rover mission is introducing a new generation of engineering cameras (ECAMs) called the enhanced engineering cameras (EECAMs), which have advanced imaging capability over the previous ECAMs used on the Spirit, Opportunity, and Curiosity rovers. The Mars 2020 rover will have nine EECAMs – six upgraded HazCams used for hazard avoidance, two upgraded NavCams used for navigation, and a single CacheCam used to take images of samples obtained by the rover’s Sampling and Caching Subsystem (SCS). The detailed EECAM design was completed in April 2017, and since then the EECAM Subsystem has been in the process of fabrication, integration, and testing. This paper describes two thermal tests that were done for thermal model correlation and validation of the EECAM thermal design during Mars surface operations.
Thermal Operability Improvements for the Mars 2020 Rover Surface Mission
The Mars 2020 Rover is scheduled to land on Mars on February 18, 2021. One of the primary mission objectives for the Mars 2020 Rover is to perform in-situ science and collect a set of Martian regolith samples for possible future return to Earth. In order to meet mission requirements, 20 samples must be collected, assessed, and sealed during the prime mission (1.5 Martian years, approximately 1000 Sols). This requires that the Mars 2020 Rover operate in a much more efficient and autonomous manner than its predecessor, the Mars Science Laboratory (MSL) Rover, Curiosity. The thermal designs of both Curiosity and the Mars 2020 Rover utilize warmup heaters to bring the actuators and cameras, located on the outside of the vehicle, up to their operating temperatures prior to use. These heaters consume energy during the mission. The Rover energy balance, between energy production and consumption, must be maintained in order to keep the mission moving safely forward. Increased efficiency in the way this warmup heater energy is allocated and used in the Mars 2020 Rover operations plan will result in more energy available for science and engineering activities. This paper discusses the improvements that were made in both hardware and software to improve the way the Mars 2020 Rover will operate thermally on Mars.
Thermal Development of the Mars 2020 Enhanced Engineering Cameras
The engineering cameras (ECAMs) of the 2003 Mars Exploration Rover (MER) mission were re-flown on the Mars Science Laboratory (MSL) mission that launched in 2011. The upcoming Mars 2020 rover mission will introduce a new fleet of cameras called the enhanced engineering cameras (EECAMs). These EECAMs will have improved imaging capability, as the technology of the past ECAMs flown on Mars surface missions have become outdated. The EECAMs include six upgraded HazCams, two upgraded NavCams, and a single, newly-conceived CacheCam. The purposes of the HazCams and NavCams remain the same as they were for MER and MSL: to detect hazards to the front and rear of the rover, and to help in navigation across the Martian surface. The CacheCam will be used to take images of samples obtained by the rover’s Sample Caching System. This paper compares the differences in the thermal designs of the ECAMs and EECAMs, their design drivers, and their implications for the mission operations of the Mars 2020 rover.