Search NASA⌕ Search

Engineering topics

Smith, B. T.

Publications and source records attributed to Smith, B. T..

22 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Thermodynamic limits for solar energy conversion by a quantum-thermal hybrid system

The limits are presented fo air mass 1.5 conditions. A maximum conversion efficiency of 74 percent is thermodynamically achievable for the quantum device operating at 3500 K and the heat engine in contact with a reservoir at 0 K. The efficiency drops to 56 percent for a cold reservoir at approximately room temperature conditions. Hybrid system efficiencies exceed 50 percent over receiver temperatures ranging from 1400 K to 4000 K, suggesting little benefit is gained in operating the system above 1400 K. The results are applied to a system consisting of a photovoltaic solar cell in series with a heat engine.

Byvik, C. E.↗
NASA NTRS1981

Thermodynamic limits to the efficiency of solar energy conversion by quantum devices

The second law of thermodynamics imposes a strict limitation to the energy converted from direct solar radiation to useful work by a quantum device. This limitation requires that the amount of energy converted to useful work (energy in any form other than heat) can be no greater than the change in free energy of the radiation fields. Futhermore, in any real energy conversion device, not all of this available free energy in the radiation field can be converted to work because of basic limitations inherent in the device itself. A thermodynamic analysis of solar energy conversion by a completely general prototypical quantum device is presented. This device is completely described by two parameters, its operating temperature T sub R and the energy threshold of its absorption spectrum. An expression for the maximum thermodynamic efficiency of a quantum solar converter was derived in terms of these two parameters and the incident radiation spectrum. Efficiency curves for assumed solar spectral irradiance corresponding to air mass zero and air mass 1.5 are presented.

Buoncristiani, A. M.↗
NASA NTRS1978

A comparison of two recent approaches to machine parameterization for mathematical software

Two proposals for expressing the dependence of numerical software on the environment are examined. The approaches are briefly summarized and the differences and similarities are discussed. One proposal characterizes the dependence of the software on the machine architecture essentially in terms of the representation of floating point entities in the machine. The second characterizes the dependence of the software on the environment in terms of models both of the floating point numbers and of the behavior of the arithmetic unit of the machine.

Smith, B. T.↗