Search NASA⌕ Search

Engineering topics

Smith, D. D.

Publications and source records attributed to Smith, D. D..

17 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2018

Prospects for the Development of Fast-Light Inertial Sensors

Next-generation space missions are constrained by existing spacecraft navigation systems which are not fully autonomous. These systems suffer from accumulated dead-reckoning errors and must therefore rely on periodic updates provided by supplementary technologies that depend on line-of-sight signals from Earth, satellites, or other celestial bodies (e.g., GPS, star-trackers) for absolute attitude and position determination, which can be spoofed, incorrectly identified, occluded, obscured, attenuated, or insufficiently available. These dead-reckoning errors originate in the accelerometers and ring laser gyros (RLGs) themselves, which constitute inertial measurement units (IMUs). Increasing the time for standalone spacecraft navigation therefore requires fundamental improvements in the precision of inertial sensors. The conventional method of increasing the precision of an optical gyro is to increase its size, but this is problematic in spaceflight where size and weight are at a premium. One promising solution to enhance gyro precision without increasing size is to place an anomalous dispersion or fast-light (FL) material inside the gyro cavity. The FL essentially provides a positive feedback to the gyro response, resulting in a larger measured beat frequency for a given rotation rate as shown in figure 1.

Smith, D. D.↗
NASA NTRS2015

Temperature Sensitivity of an Atomic Vapor Cell-Based Dispersion-Enhanced Optical Cavity

Enhancement of the response of an optical cavity to a change in optical path length, through the use of an intracavity fast-light medium, has previously been demonstrated experimentally and described theoretically for an atomic vapor cell as the intracavity resonant absorber. This phenomenon may be used to enhance both the scale factor and sensitivity of an optical cavity mode to the change in path length, e.g. in gyroscopic applications. We study the temperature sensitivity of the on-resonant scale factor enhancement, S(sub o), due to the thermal sensitivity of the lower-level atom density in an atomic vapor cell, specifically for the case of the Rb-87 D(sub 2) transition. A semi-empirical model of the temperature-dependence of the absorption profile, characterized by two parameters, a(sub o)(T) and gamma(sub a)(T) allows the temperature-dependence of the cavity response, S(sub o)(T) and dS(sub o)/dT to be predicted over a range of temperature. We compare the predictions to experiment. Our model will be useful in determining the useful range for S(sub o), given the practical constraints on temperature stability for an atomic vapor cell.

Myneni, K.↗
NASA NTRS2004

Coherence Phenomena in Coupled Optical Resonators

We predict a variety of photonic coherence phenomena in passive and active coupled ring resonators. Specifically, the effective dispersive and absorptive steady-state response of coupled resonators is derived, and used to determine the conditions for coupled-resonator-induced transparency and absorption, lasing without gain, and cooperative cavity emission. These effects rely on coherent photon trapping, in direct analogy with coherent population trapping phenomena in atomic systems. We also demonstrate that the coupled-mode equations are formally identical to the two-level atom Schrodinger equation in the rotating-wave approximation, and use this result for the analysis of coupled-resonator photon dynamics. Notably, because these effects are predicted directly from coupled-mode theory, they are not unique to atoms, but rather are fundamental to systems of coherently coupled resonators.

Smith, D. D.↗
NASA NTRS2001

The Effect of Microgravity on the Growth of Silica Nanostructures

The process of the formation of structures from coagulating ensembles is fundamentally important since the collective behavior of the constituents often results in dramatically improved or unusual mechanical, thermal, chemical, and optical properties. In this study we examine the effect of microgravity on the formation of silica structures, specifically particles and gels.

Smith, D. D.↗
NASA NTRS2001

Porosity and Variations in Microgravity Aerogel Nano-Structures: New Laser Speckle Characterization Methods - 2

The transition from sol to gel is a process that is critical to the properties of engineered nanomaterials, but one with few available techniques for observing the dynamic processes occurring during the evolution of the gel network. Specifically, the observation of various cluster aggregation models, such as diffusion-limited and reaction-limited cluster growth can be quite difficult. This can be rather important as the actual aggregation model can dramatically influence the mechanical properties of gels, and is significantly affected by the presence of convective flows, or their absence in microgravity. We have developed two new non-intrusive optical methods for observing the aggregation processes within gels in real time. These make use of the dynamic behavior of laser speckle patterns produced when an intense laser source is passed through a gelling sol. The first method is a simplified time-correlation measurement, where the speckle pattern is observed using a CCD camera and information on the movement of the scattering objects is readily apparent. This approach is extremely sensitive to minute variations in the flow field as the observed speckle pattern is a diffraction-based image, and is therefore sensitive to motions within the sol on the order of the wavelength of the probing light. Additionally, this method has proven useful in determining a precise time for the gel-point, an event often difficult to measure. Monitoring the evolution of contrast within the speckle field is another method that has proven useful for studying aeration. In this case, speckle contrast is dependent upon the size (correlation length) and number of scattering centers, increasing with increasing size, and decreasing with increasing numbers. The dynamic behavior of cluster growth in gels causes both of these to change simultaneously with time, the exact rate of which is determined by the specific aggregation model involved. Actual growth processes can now be observed, and the effects of varying gravity fields on the growth processes qualitatively described. Results on preliminary ground-based measurements have been obtained.

Hunt, A. J.↗
NASA NTRS2000

The Influence of Microgravity on Silica Sol-Gel Formation

We discuss space-flight experiments involving the growth of silica particles and gels. The effect of microgravity on the growth of silica particles via the sol-gel route is profound. In four different recipes spanning a large range of the parameter space that typically produces silica nanoparticles in unit-gravity, low-density gel structures were instead formed in microgravity. The particles that did form were generally smaller and more polydisperse than those grown on the ground. These observations suggest that microgravity reduces the particle growth rate, allowing unincorporated species to form aggregates and ultimately gel. Hence microgravity favors the formation of more rarefied structures, providing a bias towards diffusion-limited cluster-cluster aggregation. These results further suggest that in unit gravity, fluid flows and sedimentation can significantly perturb sol-gel substructures prior to gelation and these deleterious perturbations may be "frozen" into the resulting microstructure. Hence, sol-gel pores may be expected to be smaller, more uniform, and less rough when formed in microgravity.

Sibille, L.↗
NASA NTRS2000

Electrophoretic Porosimetry of Sol-Gels

It has been hypothesized that gravity has an effect on the formation and resulting microstructure of sol-gels. In order to more clearly resolve the effect of gravity, pores may be non-destructively analyzed in the wet gel, circumventing the shrinkage and coarsening associated with the drying procedure. We discuss the development of an electrophoretic technique, analogous to affinity chromatography, for the determination of pore size distribution and its application to silica gels. Specifically a monodisperse charged dye is monitored by an optical densitometer as it moves through the wet gel under the influence of an electric field. The transmittance data (output) represents the convolution of the dye concentration profile at the beginning of the run (input) with the pore size distribution (transfer function), i.e. linear systems theory applies. Because of the practical difficulty in producing a delta function input dye profile we prefer instead to use a step function. Average pore size is then related to the velocity of this dye front, while the pore size distribution is related to the spreading of the front. Preliminary results of this electrophoretic porosimetry and its application to ground and space-grown samples will be discussed.

Snow, L. A.↗
NASA NTRS1985

Reducing Thermal Expansivity of Composite Panels

Coefficient of thermal expansion of laminated graphite/epoxy composite panels altered after panels cured by postcuring heat treatment. Postcure decreases coefficient of thermal expansion by increasing crosslinking between molecules. Treatment makes it possible to reprocess costly panels for requisite thermal expansivity instead of discarding them.

Smith, D. D.↗
NASA NTRS1980

Solar electric propulsion - A versatile stage for earth orbiting missions

The paper examines recent developments in solar array and ion propulsion systems which make possible the utilization of readily available solar energy for spacecraft propulsion and operation. The Solar Electric Propulsion System (SEPS) stage represents a substantial increase in capability to perform interplanetary and earth orbiting missions due to the combination of high performance and low thrust. SEPS is an important augmentation to the Space Transportation System (STS) for numerous earth orbit missions because it can deliver a greatly increased total satellite mass to a geosynchronous orbit or greatly increase the on-orbit delta V capability.

Smith, D. D.↗
NASA NTRS1980

A space stable optical bench structure for the space telescope wide field and planetary camera

The design, fabrication, and verification tests of two optical bench structures fabricated under contract to the Jet Propulsion Laboratory are discussed. It is noted that graphite-epoxy and invar have been selected as the structural materials for the bench. The ability to manufacture a precise graphite-epoxy optical system platform has been demonstrated. It is noted that the 19 channel laser interferometer was used to measure the CTE of the bench structure graphite-epoxy components and the two invar bulkheads.

Smith, D. D.↗
NASA NTRS1973

Evaluation of a metal shear web selectively reinforced with filamentary composites for space shuttle application. Phase 2: summary report: Shear web component fabrication

The fabrication of two shear web test elements and three large scale shear web test components are reported. In addition, the fabrication of test fixtures for the elements and components is described. The center-loaded beam test fixtures were configured to have a test side and a dummy or permanent side. The test fixtures were fabricated from standard extruded aluminum sections and plates and were designed to be reuseable.

Laakso, J. H.↗
NASA NTRS1971

Legal aspects of satellite teleconferencing

The application of satellite communications for teleconferencing purposes is discussed. The legal framework within which such a system or series of systems could be developed is considered. The analysis is based on: (1) satellite teleconferencing regulation, (2) the options available for such a system, (3) regulatory alternatives, and (4) ownership and management aspects. The system is designed to provide a capability for professional education, remote medical diagnosis, business conferences, and computer techniques.

Smith, D. D.↗