Engineering topics

Smith, Hannah L.

Publications and source records attributed to Smith, Hannah L..

4 records

DOE OSTI2022

Powerful Organic Molecular Oxidants and Reductants Enable Ambipolar Injection in a Large-Gap Organic Homojunction Diode

Doping has proven to be a critical tool for enhancing the performance of organic semiconductors in devices like organic light-emitting diodes. However, the challenge in working with high-ionization-energy (IE) organic semiconductors is to find p-dopants with correspondingly high electron affinity (EA) that will improve the conductivity and charge carrier transport in a film. Here, we use an oxidant that has been recently recognized to be a very strong p-type dopant, hexacyano-1,2,3-trimethylene-cyclopropane (CN6-CP). The EA of CN6-CP has been previously estimated via cyclic voltammetry to be 5.87 eV, almost 300 meV higher than other known high-EA organic molecular oxidants. We measure the frontier orbitals of CN6-CP using ultraviolet and inverse photoemission spectroscopy techniques and confirm a high EA value of 5.88 eV in the condensed phase. The introduction of CN6-CP in a film of large-band-gap, large-IE phenyldi(pyren-1-yl)phosphine oxide (POPy 2 ) leads to a significant shift of the Fermi level toward the highest occupied molecular orbital and a 2 orders of magnitude increase in conductivity. Using CN6-CP and n-dopant (pentamethylcyclopentadienyl)(1,3,5-trimethylbenzene)ruthenium (RuCp*Mes)2, we fabricate a POPy 2 -based rectifying p–i–n homojunction diode with a 2.9 V built-in potential. Blue light emission is achieved under forward bias. Furthermore, this effect demonstrates the dopant-enabled hole injection from the CN6-CP-doped layer and electron injection from the (RuCp*Mes) 2 -doped layer in the diode.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Controlled n –Doping of Naphthalene Diimide–Based Two–Dimensional Polymers

Two-dimensional polymers (2DPs) are promising as structurally well-defined, permanently porous, organic semiconductors. However, 2DPs are nearly always isolated as closed shell organic species with limited charge carriers, which leads to low bulk conductivities. Here, we enhance the bulk conductivity of two naphthalene diimide (NDI)-containing 2DP semiconductors by controllably n-doping the NDI units using cobaltocene (CoCp 2 ). Optical and transient microwave spectroscopy reveals that both as-prepared NDI-containing 2DPs are semiconducting with sub-2 eV optical bandgaps and photoexcited charge-carrier lifetimes of tens of nanoseconds. Following reduction with CoCp 2 , both 2DPs largely retain their periodic structures and exhibit optical and electron-spin resonance spectroscopic features consistent with the presence of NDI-radical anions. Here, while the native NDI-based 2DPs are electronically insulating, maximum bulk conductivities of >10 –4 S cm –1 are achieved by substoichiometric levels of n-doping. Density functional theory calculations show that the strongest electronic couplings in these 2DPs exist in the out-of-plane (π-stacking) crystallographic directions, which indicates that cross-plane electronic transport through NDI stacks is primarily responsible for the observed electronic conductivity. Taken together, this study underlines that controlled molecular doping is a useful approach to access structurally well-defined, paramagnetic, 2DP n-type semiconductors with measurable bulk electronic conductivities of interest for electronic or spintronic devices.

2D polymers↗

DOE OSTI2021

Molecular dopants: Tools to control the electronic structure of metal halide perovskite interfaces

In the standard configurations of metal halide perovskite solar cell, the active layer, or absorber, follows a p-i-n or n-i-p electronic structure that is designed to enhance the separation and extraction of photo-induced charge carriers. The control of the Fermi level position across the film, between electron and hole transport layers, is therefore of paramount importance. Direct localized doping in metal halide perovskites being still elusive, the design of n-i-p and p-i-n structures has so far relied predominantly on surface and interface doping of the perovskite as well as on the control of the work function of the substrate and transport layers on which, or between which, the absorber is being placed. We provide here a short review of that work, emphasizing the fundamental studies of electronic structure performed on systems modified with organic molecular dopants. The review starts with a justification for the effectiveness of interface doping, based on the ability to move the Fermi level across the gap of the perovskite. We then review work done on the deposition of molecular oxidants and reductants on perovskite surfaces, including the mitigation of the surface states, and the impact of these dopants on energy level alignment with substrate and charge transport layers. The second part of the review focuses on the use of molecular dopants to either modify the work function of electron or hole transport layers to establish the boundary conditions for a p-i-n or n-i-p structure, or to enhance the conductivity of these layers in order to facilitate charge carrier extraction. Final considerations are also given on recent work on bulk doping of the perovskite layer with molecular dopants.

14 SOLAR ENERGY↗

DOE OSTI2020

n–Doping of a Low–Electron–Affinity Polymer Used as an Electron–Transport Layer in Organic Light–Emitting Diodes

n-Doping electron-transport layers (ETLs) increases their conductivity and improves electron injection into organic light-emitting diodes (OLEDs). Because of the low electron affinity and large bandgaps of ETLs used in green and blue OLEDs, n-doping has been notoriously more difficult for these materials. In this work, n-doping of the polymer poly[(9,9-dioctylfluorene-2,7-diyl)-alt-(benzo[2,1,3]thiadiazol-4,7-diyl)] (F8BT) is demonstrated via solution processing, using the air-stable n-dopant (pentamethylcyclopentadienyl)(1,3,5-trimethylbenzene)ruthenium dimer [RuCp*Mes] 2 . Undoped and doped F8BT films are characterized using ultraviolet and inverse photoelectron spectroscopy. The ionization energy and electron affinity of the undoped F8BT are found to be 5.8 and 2.8 eV, respectively. Upon doping F8BT with [RuCp*Mes] 2 , the Fermi level shifts to within 0.25 eV of the F8BT lowest unoccupied molecular orbital, which is indicative of n-doping. Conductivity measurements reveal a four orders of magnitude increase in the conductivity upon doping and irradiation with ultraviolet light. Here, the [RuCp*Mes] 2 -doped F8BT films are incorporated as an ETL into phosphorescent green OLEDs, and the luminance is improved by three orders of magnitude when compared to identical devices with an undoped F8BT ETL.

36 MATERIALS SCIENCE↗