Search NASA⌕ Search

Engineering topics

Smith, P. R.

Publications and source records attributed to Smith, P. R..

Process Knowledge Summary Report for Advanced Test Reactor Complex Contact-Handled Transuranic Waste Drum TRA010029

This Process Knowledge Summary Report summarizes information collected to satisfy the transportation and waste acceptance requirements for the transfer of one drum containing contact-handled transuranic (TRU) actinide standards generated by the Idaho National Laboratory at the Advanced Test Reactor (ATR) Complex to the Advanced Mixed Waste Treatment Project (AMWTP) for storage and subsequent shipment to the Waste Isolation Pilot Plant for final disposal. The drum (i.e., Integrated Waste Tracking System Bar Code Number TRA010029) is currently stored at the Materials and Fuels Complex. The information collected includes documentation that addresses the requirements for AMWTP and applicable sections of their Resource Conservation and Recovery Act permits for receipt and disposal of this TRU waste generated from ATR. This Process Knowledge Summary Report includes information regarding, but not limited to, the generation process, the physical form, radiological characteristics, and chemical contaminants of the TRU waste, prohibited items, and packaging configuration. This report, along with the referenced supporting documents, will create a defensible and auditable record for this TRU waste originating from ATR.

99 GENERAL AND MISCELLANEOUS↗

Numerical optimization - An assessment of its role in transport aircraft aerodynamic design through a case study

An efficient transonic wing design procedure based upon numerical optimization together with three-dimensional transonic methods has been developed and used to design an advanced transport wing. The method development included an examination of the use of both full potential and extended small disturbance analysis codes and demonstrated that the former formulation was more reliable. In either case, the design procedure is economical and easy to use. Design verification in a unique semi-span test arrangement demonstrated that the design method produced a wing which satisfied the study design requirements. However, aeroelastic deformation of the wing occurred during the wind tunnel test. The computational methods used in the design procedure were employed to assess the effect of the aeroelastic deformation. The paper concludes with an evaluation of the design procedure and recommendation for its improvement.

Lores, M. E.↗

Supercritical wing design using numerical optimization and comparisons with experiment

A numerical minimization scheme is used in conjunction with two-dimensional and three-dimensional inviscid transonic flow analysis codes to provide procedures for wing leading edge aerodynamic design. The procedures are demonstrated in the design of a new leading edge to improve C-141 cruise performance. For the high aspect ratio moderately swept C-141 wing, the 2-D procedure is shown to yield results which are in close agreement with those obtained using the 3-D technique. Although the 2-D approach uses much less computation time than the 3-D technique, the latter requires fewer manhours than the former. Comparisons of predicted and wind tunnel measured performance improvements are presented which verify the design procedures.

Lores, M. E.↗

Evaluation of advanced lift concepts and fuel conservative short-haul aircraft, volume 1

The performance and economics of a twin-engine augmentor wing airplane were evaluated in two phases. Design aspects of the over-the-wing/internally blown flap hybrid, augmentor wing, and mechanical flap aircraft were investigated for 910 m. field length with parametric extension to other field lengths. Fuel savings achievable by application of advanced lift concepts to short-haul aircraft were evaluated and the effect of different field lengths, cruise requirements, and noise levels on fuel consumption and airplane economics at higher fuel prices were determined. Conclusions and recommendations are presented.

Renshaw, J. H.↗