Engineering topics

Smits, A. J.

Publications and source records attributed to Smits, A. J..

24 records · Page 2

NASA NTRS1984

The behaviour of a compressible turbulent boundary layer under incipient separation conditions

This paper presents an experimental study of a turbulent boundary-layer/shock-wave interaction. The interaction was generated by a two-dimensional compression corner, and the flow was on the point of separating. Measurements were made using both normal and inclined hot wires, and the data include measurements of the longitudinal mass-flow fluctuation intensity and the mass-weighted Reynolds shear stress.

Muck, K. C.↗

NASA NTRS1984

The static response of a bowed inclined hot wire

The directional sensitivity of a bowed, inclined hot wire is investigated using a simple model for the convective heat transfer. The static response is analyzed for subsonic and supersonic flows. It is shown that the effects of both end conduction and wire bowing are greater in supersonic flow. Regardless of the Mach number, however, these two phenomena have distinctly different effects; end conduction appears to be responsible for reducing the nonlinearity of the response, whereas bowing increases the directional sensitivity. Comparison with the available data suggests that the analysis is useful for interpreting the experimental results.

Smits, A. J.↗

NASA NTRS1983

Constant-temperature hot-wire anemometer practice in supersonic flows. I - The normal wire

The performance of a constant-temperature normal hot-wire in a supersonic flow is critically examined. It is shown that this instrument is inherently unsuitable for measuring turbulent temperature correlations because of the highly nonlinear response to temperature fluctuations, particularly at low overheat ratios. The instrument is therefore limited to measurements of mean and fluctuating mass-flow rates. Suitable calibration procedures, as well as the limits on spatial and temporal resolution are discussed, and corrections for mean stagnation temperature changes are suggested.

Smits, A. J.↗

NASA NTRS1983

Constant-temperature hot-wire anemometer practice in supersonic flows. II - The inclined wire

The performance of a constant-temperature inclined hot-wire in a supersonic flow is critically examined. It is shown that calibration techniques applicable to subsonic flow, such as the cosine cooling law cannot be used when the flow is supersonic. Calibration and measurement procedures appropriate to supersonic flow are suggested, together with the possible limits on their validity. Experimental results for different wires indicate that the sensitivities do not seem to depend on flow direction according to any simple correlation. When the sensitivity exhibits a strong dependence on flow direction, the wire should be discarded to avoid errors due to nonlinear effects.

Smits, A. J.↗

NASA NTRS1983

Turbulence measurements in a compressible reattaching shear layer

Detailed hot-wire measurements of the longitudinal component of the mass-flow fluctuations have been made in an approximately self-preserving free shear layer reattaching on a 20 degree ramp at Mach number of 2.9. The experimental configuration is especially designed to provide a well-defined initial condition for the reattachment process. The absolute mass-flow turbulence intensity increases dramatically through the compression in the reattachment region, which is in sharp contrast to similar subsonic reattachments. It is clear that the mean dilatation contributes significantly to the turbulence amplification. In addition, the length scale is affected strongly by the presence of extra strain rates. Prediction of this flow will require some sophisticated modelling, and the challenge to the predictor is clear.

Hayakawa, K.↗

NASA NTRS1983

Turbulence measurements in two shock-wave/shear-layer interactions

Measurements of the longitudinal component of the mass-flow fluctuations have been made in an 8-deg compression corner flow and a reattaching shear layer at a Mach number of approximately 2.9 and unit Reynolds number of about 7 x 10 to the 7th per m. The data include turbulence intensities and probability density distributions. Significant turbulence amplification occurs in both interactions. A qualitative explanation in terms of direct shock effects, extra strain rates, and their relative contribution, is suggested.

Hayakawa, K.↗