Engineering topics

Snoj, L.

Publications and source records attributed to Snoj, L..

7 records

DOE OSTI2022

Application of the bRapid fission matrix burnup methodology to the JSI TRIGA Mark II research reactor

The novel burnup methodology, bRAPID, of the RAPID code system has been applied to the TRIGA Mark II research reactor at the 'Jozef Stefan' Institute. This paper presents the first step in our goal for on-line determination of isotope inventory and burnup, that the RAPID code system with its Fission Matrix (FM) method enables. Burnup analysis of changes in FM coefficients due to TRIGA fuel burnup at different irradiation times and specific power distribution in the reactor core is presented. Our results demonstrate that primary contribution for changes of FM coefficients is the burnup of the destination s, while the spectrum differences, that arise due to fuel's core location, have negligible effect on FM coefficients. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

DOE OSTI2022

On the novel 3-D neutron transport kinetic tRAPID algorithm and its validation

The Real-time Analysis for Particle-transport and In-situ Detection (RAPID) Code System, based on the Multi-stage Response-function Transport (MRT) methodology, allows for real-time simulation of nuclear systems based on 3-D continuous-energy particle transport. RAPID's steady-state (criticality) neutron transport algorithm is based on the Fission Matrix (FM) method, and has been extensively verified and validated against computational benchmarks and experiments. This paper introduces the novel 3-D time-dependent transport algorithm that has been implemented into the code, tRAPID, and its validation using the JSI TRIGA Mark-II reactor. tRAPID accurately and efficiently calculates neutron kinetics parameters (such as β{sub eff}, l{sub eff} , Λ, α{sub Rossi}) and 3-D time-dependent neutron fission source distribution and neutron importances for both prompt and delayed neutrons. tRAPID is used to simulate a rod insertion experiment performed at the JSI TRIGA Mark-II reactor, during which signals from four fission chambers at four different locations in the core were collected. The results demonstrate how tRAPID is capable of calculating detailed and accurate results with only a minimal use computational resources and time.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗

DOE OSTI2022

Benchmark evaluation of one dimensional array of HEU moderated and reflected by Lucite

The evaluation of two HEU-Lucite experiments is presented. The critical experiments were performed using the Planet Universal Critical Assembly Machine at Los Alamos National Laboratory in 2019. In these experiments, HEU foils were interleaved with Lucite in a column stack and were moderated and reflected from the square Lucite plates. The neutron data produced were used to approximate the multiplication of each measured configuration. The evaluation of the experiments using calculational techniques is presented in the paper. A Monte-Carlo computational model to be used with MCNP6 was developed for the determination of uncertainties and the effects of various uncertainties on the multiplication factor were studied. The evaluation of the benchmark was performed for comparison of calculation results with the experimental data and validation of calculation techniques in particular the newly available thermal scattering data for the Lucite material. The sensitivity studies include parametric variations of material composition and geometry. Experimental uncertainties were low, with the overall height of the HEU/Lucite stack being the largest contributor to the overall uncertainty in k{sub eff}. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

DOE OSTI2022

Predicting deviations in ex-core detector response in Krsko NPP during an earthquake with Monte-Carlo neutron transport methods

To study the response of ex-core detectors during an earthquake, an approach using Monte Carlo code MCNP was developed. As a first step to predict the response of the ex-core detectors a detailed MCNP model of the Krsko reactor core was created. A detailed MCNP core model was used to calculate 3D power distributions inside the core. Calculated power distributions were verified by comparison to the CORD-2 calculations, which is currently used for core design calculation verification of the Krsko nuclear power plant. Due to the outside the core position of the neutron detectors, the hybrid code ADVANTG is used to generate weight windows to speed up neutron transport outside the reactor core. To be able to use ADVANTG, fixed neutron source had to be reconstructed from the criticality core calculation. It was found that the power range ex-core detector movement has a negligible effect on the value of the thermal neutron flux at the active part of the detector. However, the 5 cm radial movement of the intermediate-range detector leads to 7 % - 8 % change in thermal neutron flux within the active intermediate-range detector region. The analysis continued with the evaluation of the effect of core barrel movement on the ex-core detector response. It was determined that the 2 mm core barrel radial oscillation can lead to ∼ 4% change in thermal neutron flux within the active detector region. It was evaluated that reactor core movement inside the baffle can lead up to ∼ 1.9% and ∼ 1.3% deviation in power-range and intermediate-range detector signal respectively. Analysis showed that the mechanical movement of ex-core neutron detectors could not explain the fluctuations in the ex-core detector signal. However, combined core barrel and reactor core inside baffle oscillations could be a probable reason for the observed fluctuations in the ex-core detector signal during an earthquake. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

DOE OSTI2022

Reactor physics benchmark experiments at the JSI TRIGA MARK II reactor - Current status and future outlook

Full text of publication follows. With the development of new high-fidelity computational methods, improvement of nuclear data, and multiphysics modelling, there is an increased need for benchmark experiments to experimentally validate the models, methods and input data. Many of the nuclear facilities designed to perform reactor physics benchmark experiments have been shut down. Therefore, research reactors offer a great opportunity for benchmark experiments, if they are well designed and performed with great care and accuracy. In this presentation we provide an overview of the past and ongoing activities related to benchmark experiments at the Jozef Stefan Institute TRIGA Mark II research reactor. The following experiments have been performed: criticality with fresh fuel, {sup 197}Au(n,γ) and {sup 27}Al(n,α) reaction rates in irradiation channels, absolute and relative {sup 197}Au(n,γ), {sup 235}U(n,f) and {sup 238}U(n,f) reaction rates in the core, burnup, kinetic parameters, control rod worth, isothermal reactivity coefficient, self-shielding, slow and fast (pulse) transients, nuclear heating, delayed and prompt gamma ray production, temperature profiles for multi-physics. Since the existing fleet of research reactors is ageing very rapidly and new experiments are needed, new research reactors should be designed and built to meet the needs of future advanced reactors, education and training, and other technologies in the coming years. We will review planned activities at the JSI TRIGA reactors and plans for the new research reactor in Slovenia. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

DOE OSTI2022

Validation of realistic Monte Carlo plasma gamma-ray source on JET discharges

A novel modelling methodology has been developed for the creation of a realistic plasma gamma-ray source for Monte Carlo transport simulations in the tokamak JET. The methodology couples the TRANSP code for plasma transport calculations with the MCNP Monte Carlo particle transport code, thus connecting plasma physics with gamma-ray transport. Here, we present the validation of the developed source methodology by comparing calculated gamma-ray spectra with measurements performed at JET. The validation focuses on gamma-ray spectra measured by the tangential gamma-ray spectrometer during two JET three ion RF scenario discharges, performed in the JET 2019 deuterium experimental campaign. For validation the calculated plasma gamma-ray spectrum was combined with the neutron induced prompt gamma-ray background, originating in the vacuum vessel, and scaled to absolute values calculating the total number of plasma gamma-ray and neutron emitting reactions. The comparison between calculated and measured gamma-ray spectra shows good agreement with the shape of the calculated gamma-ray spectra matching that of measurements for both studied discharges. Moreover, the calculated absolute values of the gamma-ray spectra were of the same order of magnitude at the position of the gamma-ray detector located at the end of a long line-of-sight in a biological shield. Finally, the comparison has validated the developed plasma gamma-ray source methodology for MCNP photon transport calculations at JET. The validation provides a basis for the developed plasma gamma-ray source to be used as a support for the development of future tokamaks such as DEMO.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Experimental validation of an integrated modelling approach to neutron emission studies at JET

An integrated modelling methodology for the calculation of realistic plasma neutron sources for the JET tokamak has been developed. The computational chain comprises TRANSP plasma transport and DRESS neutron spectrum calculations, and their coupling to the MCNP neutron transport code, bridging plasma physics and neutronics. Here, we apply the developed methodology to the analysis of neutron emission properties of deuterium and helium plasmas at JET, and validate individual modelling steps against neutron diagnostic measurements. Two types of JET discharges are modelled—baseline-like and three-ion radio-frequency scenarios—due to their diversity in plasma heating, characteristics of the induced fast ion population, and the imprint of these on neutron emission properties. The neutron emission modelling results are quantitatively compared to the total neutron yield from fission chambers, neutron emissivity profiles from the neutron camera, neutron spectra from the time-of-flight spectrometer, and neutron activation measurements. The agreement between measured and calculated quantities is found to be satisfactory for all four diagnostic systems within the estimated experimental and computational uncertainties. Additionally, the effect of neutrons not originating from the dominating D(D, n) 3 He reactions is studied through modelling of triton burnup DT neutrons, and, in mixed D- 3 He plasmas, neutrons produced in the 9 Be(D, nγ) 10 B reaction on impurities. It is found that these reactions can contribute up to several percent to the total neutron yield and dominate the neutron activation of samples. Finally, the effect of MeV-range fast ions on the neutron activation of 115 In and 27 Al samples is measured and computationally validated.

integrated modelling↗