Engineering topics

Snyder, H. A.

Publications and source records attributed to Snyder, H. A..

7 records

NASA NTRS1992

Self-driven cooling loop for a large superconducting magnet in space

Pressurized cooling loops in which superfluid helium circulation is driven by the heat being removed have been previously demonstrated in laboratory tests. A simpler and lighter version which eliminates a heat exchanger by mixing the returning fluid directly with the superfluid helium bath was analyzed. A carefully designed flow restriction must be used to prevent boiling in this low-pressure system. A candidate design for Astromag is shown that can keep the magnet below 2.0 K during magnet charging. This gives a greater margin against accidental quench than approaches that allow the coolant to warm above the lambda point. A detailed analysis of one candidate design is presented.

Mord, A. J.↗

NASA NTRS1992

End-to-end modelling of He II flow systems

A practical computer code has been developed which uses the accepted two-fluid model to simulate He II flow in complicated systems. The full set of equations are used, retaining the coupling between the pressure, temperature and velocity fields. This permits modeling He II flow over the full range of conditions, from strongly or weakly driven flow through large pipes, narrow channels and porous media. The system may include most of the components used in modern superfluid flow systems: non-ideal thermomechanical pumps, tapered sections, constrictions, lines with heated side walls and heat exchangers. The model is validated by comparison with published experimental data. It is applied to a complex system to show some of the non-intuitive feedback effects that can occur. This code is ready to be used as a design tool for practical applications of He II. It can also be used for the design of He II experiments and as a tool for comparison of experimental data with the standard two-fluid model.

Mord, A. J.↗

NASA NTRS1991

Flow of superfluid helium in tubes with heated walls

The equations for superfluid helium flowing through a straight tube with heated walls are integrated. The model equations are based on those of Landau as modified for superfluid turbulence by Gorter and Mellink (1949). The model is implemented by the program SUPERFLOW which runs on a personal computer. The effect of the heating level on the mass flux, the energy flux, and the pressure and temperature profiles is investigated. The four types of profiles which occur without sidewall heating are also found with heated walls. The progression through these four types is shown to depend primarily on the dimensionless parameter, defined previously to characterize the unheated profiles, and a dimensionless ratio of heat fluxes. The pressure and temperature maxima which rise well above the boundary values increase significantly with sidewall heating. Approximate design equations for estimating the mass flux and the profiles are presented. The physical basis of the results is discussed. These results are useful in the design of optimal cooling loops and other superfluid flow systems.

Snyder, H. A.↗

NASA NTRS1990

Co-operative oscillations of bubbles

A closed cryogenic storage tank in space may contain several bubbles. It is shown that these bubbles can oscillate in volume with n-1 resonant frequencies for n bubbles. The resonances can be excited by a sudden change in pressure, such as withdrawing fluid or venting, or by motion of the vehicle. In situations in which the ac accelerations dominate, such as in large space structures, the potential for harmful coupling of these oscillations to the spacecraft structure must be examined. Experimental data are presented which support the theoretical predictions.

Snyder, H. A.↗

NASA NTRS1988

Dewar to dewar model for superfluid helium transfer

A model has been developed to predict the flow of He II between a source and a receiving dewar. The model uses a finite difference aproximation to integrate the describing equations. The transfer path may contain porous plugs or mechanical pumps, heater sections, heat leaks, constrictions due to valves, and bends. These line elements may occur in any order and in any quantity. The line elements are easily reconfigured by changing the input data. The input consists of the number of finite element cells, the pressure in each dewar, the heat input to each section and the dimensions of each section. The output is the temperature, pressure, flow rate, velocities and heat flux in each section. An internal reference table provides the properties of He II. The model is programmed for a LOTUS work sheet. It converges rapidly and usually requires 10 to 15 iterations. For most applications an iteration takes 30 s on an AT. The predictions agree well with experimental data.

Snyder, H. A.↗

NASA NTRS1986

Concepts for on-orbit servicing of SIRTF

The usable lifetime of the Space Infrared Telescope Facility (SIRTF) has been assumed to be limited to about two years by the lifetime of the superfluid helium carried in the telescope dewar. Concepts are presented for extending the system life by replenishing the cryogen on orbit, and for replacing the focal plane instruments. The operational aspects and the modifications to the baseline SIRTF are examined. It appears to be feasible to perform these servicing operations based on either the Space Shuttle or on the Space Station.

Mord, A. J.↗

NASA NTRS1985

BASD: SIRTF Telescope Instrument Changeout and Cryogen Replenishment (STICCR) study

The Space Infrared Telescope Facility (SIRTF) is a long-life cryogenically cooled space-based telescope for infrared astronomy from 2 micrometer to 700 miocrometers currently under study by NASA-ARC, and planned for launch in approximately the mid 90's. SIRTF will operate as a multi-user facility, initially carrying 3 instruments at the focal plane. It will be cooled to below 2 K by superfluid liquid helium to achieve radiometric sensitivity limited only by the statistical fluctuations in the natural infrared background radiation over most of its spectral range. The lifetime of the mission will be limited by the lifetime of the liquid helium supply, and is currently baselined to be 2 years. The telescope changes required to allow in-space replenishment of the 2,000 liter superfluid helium tank are investigated. A preliminary design for the space services equipment is also developed. The impacts of basing the equipment and servicing on the space station are investigated. Space replenishment and changeout of instruments requires changes to the telescope design and preliminary concepts are presented.

Mord, A. J.↗