Engineering topics

Soldo, Yan

Publications and source records attributed to Soldo, Yan.

6 records

NASA NTRS2019

Detection of Residual “Hot Spots” in RFI-Filtered SMAP Data

Radio frequency interference (RFI) is a well-documented problem for passive remote sensing of the Earth at L-band even though the measurements are made in the protected band at 1.413 GHz. Consequently, filtering for RFI is an important early step in the processing of measurements made by the SMAP (Soil Moisture Active/Passive) radiometer. However, the filtered data still include regions with suspiciously high antenna temperatures. One possible cause of these “hot spots” is interference not fully detected during RFI filtering. This paper presents evidence supporting this hypothesis and describes an algorithm to identify these “hot spots” so that they can be removed from the measurements. The impact of removing these “hot spots” is generally small, but evidence is presented that the brightness temperature and soil moisture improve when the hot spots are removed.

Soldo, Yan↗

NASA NTRS2019

Sea Surface Salinity Retrievals from Aquarius Using Neural Networks

Even though the Sea Surface Salinity (SSS) retrieved from Aquarius are generally very close to in-situ measurements, the level of similarity varies with the region and with the circumstances of the observations (wind speed, sea surface temperature, etc.). SSS is currently retrieved from the brightness temperatures measured by Aquarius and applying the current theoretical model for the propagation and emission of the natural thermal radiation. In this contribution we consider an alternative retrieval approach based on a Neural Network (NN) with the goal of improving the subsets of Aquarius SSS data that are in poorer agreement within-situ measurements. The subset considered here are the SSS retrieved at latitudes higher than 30 ̊. The output of the NN approach are compared against in-situ measurements using four statistical metrics (correlation coefficient, bias, RMSD and 5% trimmed range). The output of the NN and the nominal Aquarius SSS are compared against SSS values from in-situ measurements and from ocean models. From these comparisons it appears that the output of the NN matches the in-situ measurements better than the nominal Aquarius SSS.

Soldo, Yan↗

NASA NTRS2017

Localization of L-Band RFI Sources from SMAP Data

RFI (Radio-Frequency Interference) in the 1400-1427 MHz band degrades the quality of measurements made by satellite missions such as SMAP (Soil Moisture Active/Passive), Aquarius and SMOS (Soil Moisture and Ocean Salinity). A technique is presented here to estimate the location on the ground of RFI sources using SMAP measurements. The results of this technique have been validated against data derived by other means.

Soldo, Yan↗

NASA NTRS2017

L-band RFI Detected by SMOS and Aquarius

Ocean salinity and soil moisture are key parameters for understanding the global water cycle, weather, and climate. These parameters are being measured with spaceborne radiometers operating in the L-band window at 14001427 MHz. Although man-made activity in this band is prohibited, radio frequency interference (RFI) is still a problem over significant portions of the earth. This paper reports a comparison of the RFI environment in this window as observed by two L-band radiometer systems, Aquarius and Soil Moisture and Ocean Salinity. The observed RFI environment depends on the sources and also on the characteristics of the instrument. Comparing the observations provides insight into the extent of the problem (actual sources), the influence of the instrument on the observation of RFI, and on potential ways of mitigating the effects. As this report shows, the global distribution of RFI is largely consistent between the two instruments, but the details, especially at low levels of RFI, depend on the characteristics of the instrument.

microwave radiometry↗

NASA NTRS2016

L-Band RFI in Japan

In recent years, three instruments have been launched into orbit with the aim of producing global maps of sea surface salinity and soil moisture using the 1400-1427 MHz band: SMOS, Aquarius and SMAP. Although this frequency band is allocated to passive measurements only, RFI (Radio-Frequency Interference) is present in the data of all three missions. On a global scale, the three sensors have observed approximately the same distribution of RFI. Japan is an important exception that has implications for the design of RFI detection algorithms. RFI in Japan is caused by a large number of emitters belonging to the same system (TV receivers) and for this reason some traditional RFI detection strategies detect little to no RFI over Japan. The study of this case has led to an improvement of the approach to detect RFI in Aquarius data.

Aquarius↗

NASA NTRS2016

Analysis of RFI Statistics for Aquarius RFI Detection and Mitigation Improvements

Aquarius is an L-band active/passive sensor designed to globally map sea surface salinity from space. Two instruments, a radar scatterometer and a radiometer, observe the same surface footprint almost simultaneously. The radiometer is the primary instrument for sensing sea surface salinity (SSS), while the scatterometer is included to provide a correction for sea surface roughness, which is a primary source of error in the salinity retrieval. Although the primary objective is the measurement of SSS, the instrument combination operates continuously, acquiring data over land and sea ice as well. An important feature of the data processing includes detection and mitigation of Radio Frequency Interference (RFI) which is done separately for both active and passive instruments. Correcting for RFI is particularly critical over ocean because of the high accuracy required in the brightness temperature measurements for SSS retrieval. It is also necessary for applications of the Aquarius data over land, where man-made interference is widespread, even though less accuracy is required in this case. This paper will provide an overview of the current status of the Aquarius RFI processing and an update on the ongoing work on the improvement of the RFI detection and mitigation performance.

Microwave remote sensing↗