Search NASA⌕ Search

Engineering topics

Sood, A.

Publications and source records attributed to Sood, A..

Structure of Low-spin States in \(^{45}\)Sc Studied via Coulomb Excitation

The electromagnetic structure of 45 Sc at low excitation energy was investigated via low-energy Coulomb excitation at the Heavy Ion Laboratory (HIL) of the University of Warsaw and at the Inter-University Accelerator Centre (IUAC) in New Delhi. A set of reduced E2, E3, and M1 matrix elements was extracted from the collected data using the GOSIA code. The reduced transition probability B(E2; 11/2 – → 7/2 – ) has been determined, allowing us to deduce the lifetime of the 11/2 – state at 1237 keV. In addition, the upper limit on the reduced transition probability B(E3; 7/2 – → 5/2 + ) has been determined for the first time. Finally, new large-scale shellmodel and beyond-mean-field calculations were performed to interpret the structure of this nucleus.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Multi-scale time-resolved electron diffraction: A case study in moiré materials

Ultrafast-optical-pump — structural-probe measurements, including ultrafast electron and x-ray scattering, provide direct experimental access to the fundamental timescales of atomic motion, and are thus foundational techniques for studying matter out of equilibrium. High-performance detectors are needed in scattering experiments to obtain maximum scientific value from every probe particle. Here we deploy a hybrid pixel array direct electron detector to perform ultrafast electron diffraction experiments on a WSe 2 /MoSe 2 2D heterobilayer, resolving the weak features of diffuse scattering and moiré superlattice structure without saturating the zero order peak. Enabled by the detector’s high frame rate, we show that a chopping technique provides diffraction difference images with signal-to-noise at the shot noise limit. Finally, we demonstrate that a fast detector frame rate coupled with a high repetition rate probe can provide continuous time resolution from femtoseconds to seconds, enabling us to perform a scanning ultrafast electron diffraction experiment that maps thermal transport in WSe 2 /MoSe 2 and resolves distinct diffusion mechanisms in space and time.

36 MATERIALS SCIENCE↗

Characterizing scintillator detector response for correlated fission experiments with MCNP and associated packages

When multiple neutrons are emitted in a fission event they are correlated in both energy and their relative angle, which may impact the design of safeguards equipment and other instrumentation for non-proliferation applications. The most recent release of MCNP 6 . 2 contains the capability to simulate correlated fission neutrons using the event generators CGMF and FREYA . These radiation transport simulations will be post-processed by the detector response code, DRiFT , and compared directly to correlated fission measurements. DRiFT has been previously compared to single detector measurements, its capabilities have been recently expanded with correlated fission simulations in mind. Finally, this paper details updates to DRiFT specific to correlated fission measurements, including tracking source particle energy of all detector events (and non-events), expanded output formats, and digitizer waveform generation.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Correlated prompt fission data in transport simulations

Detailed information on the fission process can be inferred from the observation, modeling and theoretical understanding of prompt fission neutron and γ-ray observables. Beyond simple average quantities, the study of distributions and correlations in prompt data, e.g., multiplicity-dependent neutron and γ-ray spectra, angular distributions of the emitted particles, n -n, n - γ, and γ - γ correlations, can place stringent constraints on fission models and parameters that would otherwise be free to be tuned separately to represent individual fission observables. The FREYA and CGMF codes have been developed to follow the sequential emissions of prompt neutrons and γ rays from the initial excited fission fragments produced right after scission. Both codes implement Monte Carlo techniques to sample initial fission fragment configurations in mass, charge and kinetic energy and sample probabilities of neutron and γ emission at each stage of the decay. This approach naturally leads to using simple but powerful statistical techniques to infer distributions and correlations among many observables and model parameters. The comparison of model calculations with experimental data provides a rich arena for testing various nuclear physics models such as those related to the nuclear structure and level densities of neutron-rich nuclei, the γ-ray strength functions of dipole and quadrupole transitions, the mechanism for dividing the excitation energy between the two nascent fragments near scission, and the mechanisms behind the production of angular momentum in the fragments, etc. Beyond the obvious interest from a fundamental physics point of view, such studies are also important for addressing data needs in various nuclear applications. The inclusion of the FREYA and CGMF codes into the MCNP6.2 and MCNPX - PoliMi transport codes, for instance, provides a new and powerful tool to simulate correlated fission events in neutron transport calculations important in nonproliferation, safeguards, nuclear energy, and defense programs. Here, this review provides an overview of the topic, starting from theoretical considerations of the fission process, with a focus on correlated signatures. It then explores the status of experimental correlated fission data and current efforts to address some of the known shortcomings. Numerical simulations employing the FREYA and CGMF codes are compared to experimental data for a wide range of correlated fission quantities. The inclusion of those codes into the MCNP6.2 and MCNPX - PoliMi transport codes is described and discussed in the context of relevant applications. The accuracy of the model predictions and their sensitivity to model assumptions and input parameters are discussed. Lastly, a series of important experimental and theoretical questions that remain unanswered are presented, suggesting a renewed effort to address these shortcomings.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Thermal conductivity measurement of amorphous dielectric multilayers for phase-change memory power reduction

In this work, we investigate the temperature-dependent thermal conductivities of few nanometer thick alternating stacks of amorphous dielectrics, specifically SiO{sub 2}/Al{sub 2}O{sub 3} and SiO{sub 2}/Si{sub 3}N{sub 4}. Experiments using steady-state Joule-heating and electrical thermometry, while using a micro-miniature refrigerator over a wide temperature range (100–500 K), show that amorphous thin-film multilayer SiO{sub 2}/Si{sub 3}N{sub 4} and SiO{sub 2}/Al{sub 2}O{sub 3} exhibit through-plane room temperature effective thermal conductivities of about 1.14 and 0.48 W/(m × K), respectively. In the case of SiO{sub 2}/Al{sub 2}O{sub 3}, the reduced conductivity is attributed to lowered film density (7.03 → 5.44 × 10{sup 28 }m{sup –3} for SiO{sub 2} and 10.2 → 8.27 × 10{sup 28 }m{sup –3} for Al{sub 2}O{sub 3}) caused by atomic layer deposition of thin-films as well as a small, finite, and repeating thermal boundary resistance (TBR) of 1.5 m{sup 2} K/GW between dielectric layers. Molecular dynamics simulations reveal that vibrational mismatch between amorphous oxide layers is small, and that the TBR between layers is largely due to imperfect interfaces. Finally, the impact of using this multilayer dielectric in a dash-type phase-change memory device is studied using finite-element simulations.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Subcritical Benchmark of the BeRP Ball Reflected by Tungsten

In September 2012, eight subcritical configurations were measured with the clad a-phase plutonium sphere known as the Beryllium-Reflected Plutonium (BeRP) ball at the National Criticality Experiments Research Center (NCERC). The configurations had varying tungsten thicknesses including: 0 (bare), 0.5, 1.0, 1.5, 2.0, 2.5, 2.75, and 3.0 inches. Measurements were conducted to provide subcritical benchmark data. This work includes measured and simulated results from the International Handbook of Evaluated Criticality Safety Benchmark Experiments (ICSBEP) evaluation. (authors)

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Development of a Research Reactor Protocol for Neutron Multiplication Measurements

Establishing a protocol for measurements on research reactors is the next step in advanced subcritical neutron multiplication inference measurements. Such measurements can help identify deficiencies and quantify uncertainties in nuclear data and validate predictive Monte Carlo radiation transport simulation capabilities related to subcritical neutron multiplication inference techniques. This work expands on previous benchmark-quality efforts performed at the National Criticality Experiments Research Center (NCERC) located in Nevada, including subcritical experiments with a 4.5-kg {alpha}-phase plutonium sphere surrounded by copper, tungsten and nickel. Evaluations of the nickel and tungsten measurements have both been accepted into the International Criticality Safety Benchmark Evaluation Project (ICSBEP) Handbook. The nickel benchmark was the first ICSBEP-accepted evaluation of measurements using the Feynman Variance-to-Mean method based on the Hage-Cifarelli formulism, and was the culmination of many years of subcritical experiment research. To help establish a protocol for research reactor-based subcritical measurements, a series of Critical and Subcritical {Phi}-Power Experiments at Rensselaer (CaSPER) have been designed. This neutron multiplication measurement series will be executed at the Rensselaer Polytechnic Institute Walthousen Reactor Critical Facility (RPI-RCF) in upstate New York. The RPI reactor facility can provide benchmark-quality integral experimental configurations where different reactivity states can be achieved by varying the control rod height/water height in the reactor. The diversity of achievable configurations are also unique in contrast to previous subcritical benchmark measurements in that they are spatially complex, involve different materials (fuel, moderator), and are characterized by system-specific neutron cross section sensitivities (various energy ranges and neutron reaction contributions). It is worth noting that previous proof-of-concept subcritical measurements have been performed on thermal systems at NCERC, at a variety of reactivity states by separation distance, yet it was not possible to know the reactivity of various configurations accurately for benchmarking (there are no control rod worth curves as there are no control rods). (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

Joint neutron measurements on the flat-top HEU critical assembly machine - 14388

Flat-Top is a critical assembly with a spherical core (either ∼17 kg of HEU or ∼6 kg of δ-phase Pu) surrounded by a spherical 1000 kg natural uranium reflector. In 2013, joint LANL and CEA measurements were conducted to measure Flat-Top configurations with the HEU core using He-3 detector systems. Similar experiments were previously documented in which the Caliban and Godiva critical assemblies were measured. The core and reflector of Flat-Top have a glory hole in which nuclear material or non-nuclear material may be placed. Five configurations were measured and included subcritical configurations at various reactivity states as well as a configuration at delayed critical. The various reactivity states were achieved by varying the placement of the safety blocks and control rods (composed of natural uranium). A description of the assembly and the specific configurations measured will be presented. The subcritical and delayed critical measurements were analyzed using the Hage-Cifarelli formalism of the Feynman Variance-to-Mean method. This analysis can be used to calculate the multiplication of each configuration, from which the multiplication factor and reactivity are determined. These results are compared to the reactivity states based upon control rod worth curves and MCNP simulations. For this work, a new MCNP model was made to accurately represent the measured configurations. The ICSBEP handbook contains a benchmark of Flat-Top but all models are very simple and do not have the required fidelity to accurately represent the measured configurations. This work also examines the number of neutrons emitted per fission for this assembly (which has a significant contribution of induced fissions in U-238 due to the large natural uranium reflector). (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗