Search NASA⌕ Search

Engineering topics

Souers, P. Clark

Publications and source records attributed to Souers, P. Clark.

Gurney Equation Change for the Symmetric Sandwich

Sixteen symmetric sandwiches of explosive/copper have been fired. The traditional Gurney equation for energy density is found to be 3–8 % low compared to Cylinder test results. The suggestion is made to divide the Gurney energy by the square of the cosine of the edge angle caused by the fanning out of the metal. Finally, this introduces a fundamental correction to the Gurney equation for the unidirectional nature of detonation.

45 MILITARY TECHNOLOGY, WEAPONRY, AND NATIONAL DEF↗

Optimizing Code Calibration of the JWL Explosive Equation-of-State to the Cylinder Test

Recent analysis of high explosives using the cylinder test has resulted in an increased understanding of the experimental uncertainty for the cylinder test. To fit the Jones-Wilkins-Lee equation-of-state model to less than experimental uncertainty, an optimization process is developed in this paper. This process, when applied to a large range of explosives, seems to show that the exponent R 1 increases with increasing energy density and is grouped based on ideality. Finally, the optimal parameters are shown to increase the accuracy of an analytic equation-of-state tool.

45 MILITARY TECHNOLOGY, WEAPONRY, AND NATIONAL DEF↗

Statistics of Density, Temperature and Air Gaps on the TATB Cylinder Test

In this paper, duplicate cylinder tests (CYLEX) have been run on PBX 9502 and LX-17. The 95 % error in the absolute value of the derived detonation energy density is about ±1 % whereas the 95 % error of the difference error is ±0.5 % or better. The analytic model has been upgraded with a better strain description. The effect of the air gap between a pressed solid explosive and the inner copper wall has been measured and modeled. An off-center effect has also been seen. Density effects on the energy density from 1.82 to 1.92 g cm -3 are described for LX-17. Data has also been taken at -55, 75 and 125 °C. Finally, the last temperature gives a large enough difference to show that the mechanism appears to be only density change.

45 MILITARY TECHNOLOGY, WEAPONRY, AND NATIONAL DEF↗

Cylinder Test Correction for Copper Work Hardening and Spall

As a basis for the corrections to be discussed, an analytical equation is first presented for calculating detonation energy densities from copper wall velocities in the Cylinder test. Steinberg-Guinan work hardening is sufficient for the Cylinder problem, between 1 and 60 GPa, with a change of Y o to 0.10 kJ cm –3 for annealed copper. An air gap correction was the first to be applied, which is a function of the initial air gap width and the tilt angle of the cylinder. Irreversible heat loss was also found to be a small error. Spall is calibrated using new copper gun shot data and this energy is also small. The model up through work hardening agrees with the code, which does not contain heat loss or spall, both of which equal the error of repetitive calculation. In conclusion, the effect of the many additions to the original Gurney energy is shown.

45 MILITARY TECHNOLOGY, WEAPONRY, AND NATIONAL DEF↗

Upgraded Analytical Model of the Cylinder Test

A Gurney-type equation was previously corrected for wall thinning and angle of tilt, and now we have added shock wave attenuation in the copper wall and air gap energy loss. Extensive calculations were undertaken to calibrate the two new energy loss mechanisms across all explosives. The corrected Gurney equation is recommended for cylinder use over the original 1943 form. The effect of these corrections is to add more energy to the adiabat values from a relative volume of 2 to 7, with low energy explosives having the largest correction. The data was pushed up to a relative volume of about 15 and the JWL parameter ω was obtained directly. Finally, the total detonation energy density was locked to the v = 7 adiabat energy density, so that the Cylinder test gives all necessary values needed to make a JWL.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

TARANTULA 2011 in JWL++

Using square zoning, the 2011 version of the kinetic package Tarantula matches cylinder data, cylinder dead zones, and cylinder failure with the same settings for the first time. The key is the use of maximum pressure rather than instantaneous pressure. Runs are at 40, 200 and 360 z/cm using JWL++ as the host model. The model also does run-to-detonation, thin-pulse initiation with a P-t curve and air gap crossing, all in cylindrical geometry. Two sizes of MSAD/LX-10/LX-17 snowballs work somewhat with these settings, but are too weak, so that divergent detonation is a challenge for the future. Butterfly meshes are considered but do not appear to solve the issue.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗