Search NASA⌕ Search

Engineering topics

Soukhanovskii, V. A.

Publications and source records attributed to Soukhanovskii, V. A..

6 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

Recycling Measurements for the Lithium Tokamak Experiment

The lithium tokamak experiment (LTX) is a spherical torus designed to investigate a low-recycling wall regime for magnetically confined plasmas. Traditional measurements of recycling using Dα emission are not feasible in LTX due to reflections off the plasma-facing-components: stainless-steel shell, liquid lithium layer, and molybdenum limiters. Since lithium has low VUV reflectivity, LTX will use Lyman-α emission to measure particle recycling. LTX will use 10- and 20-channel AXUV diode arrays with Lyman-α filters to view recycling off the inboard and outboard shells. A single detector views recycling off a limiter. Measurements will be used with neutral modeling to calculate recycling and neutral deposition. To investigate the performance of an AXUV diode with directly-deposited filter, measurements were obtained with this detector and a visible detector viewing a calibration plasma then compared with emission calculated using a collisional-radiative model.

Physics - Plasma physics↗
DOE OSTI2022

First snowflake divertor experiments in MAST-U tokamak

First snowflake (SF) divertor experiments in the MAST-U tokamak demonstrated steady-state snowflake-plus divertor configurations in 450 kA ohmic L-mode plasmas. The SF divertor configuration features a second poloidal field (PF) null in the divertor region close by or overlapping with the main X-point. The resulting low PF region and two additional divertor legs (strike points) may lead to additional power and particle flux sharing via a hypothesized convective cell, and increased plasma-wetted area and radiation. The free-boundary Grad–Shafranov equilibrium code FIESTA was used to design SF configurations with several inter-null distances and orientations. In the experiment, the SF configurations with inter-null distances 0.13–0.20 m and lasting 0.2–0.3 s were obtained. Parallel connection lengths between the midplane and the outer strike point in the SF configurations (evaluated at field lines 1–2 mm from the separatrix in the midplane) were 25–30 m, higher than in the standard divertor (20–25 m) or the Super-X divertor (25 m). Diagnostic measurements highlighted salient SF features. The infra-red video bolometer diagnostic showed that the radiated power peaking in the PF null region was not as pronounces as in the standard divertor. Divertor ion fluxes measured by target Langmuir probes showed increased ion flux in the plate region where a secondary SF strike point landed, concomitantly with the SF formation. These measurements may suggest that some particle and heat redistribution was taking place in the convective SF zone. The first SF experiments provide a basis for future SF studies in MAST-U tokamak with higher input power, improved plasma control and diagnostic measurements, to be compared with the modeling predictions of plasma convective SF mixing and lower density strike point detachment threshold.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Modeling of deuterium and carbon radiation transport in MAST-U tokamak advanced divertors

Modest effects of deuterium and carbon radiation opacity in the Super-X and snowflake divertor plasmas are predicted for MAST Upgrade tokamak with core plasma input power 2.5–5 MW and plasma current 1 MA. The radiation transport modeling is based on the SOLPS-EIRENE and UEDGE code divertor plasma predictions. Two radiation transport models are used: one is based on a full radiation transport equation implemented in the radiation transport and collisional-radiative code CRETIN (without feedback on the background plasma), and another is an internal self-consistent UEDGE model with ionization, recombination, and heating rates corrected for Ly α line trapping based on the escape probability model implemented in CRETIN. In MAST-U, the Super-X and snowflake divertor plasmas are predicted to reach detached regimes at lower upstream densities than the standard divertor, and the conclusion still holds with radiation transport effects included. At neutral densities m -3 , modest Ly α deuterium line trapping with optical depths 10–15 is predicted in the Super-X divertor. Divertor plasmas are optically thin to other Lyman and Balmer lines, as well as to strong C III and C IV lines that are responsible for most of divertor radiated power. Insignificant changes (within a few percent) to divertor deuterium ionization and recombination rates are found. Radiation fluxes on outer divertor target are modified within a factor of 2–3 when the radiation transport is accounted for, and a similar variation is found due to the line shape models that define the absorption and emission line profiles in the radiation transport modeling. The predicted Lyman and Balmer spectral intensities are significantly modified due to radiation trapping. A measurement of divertor radiation transport effects is discussed using the Ly β /Ba α line ratio. In the snowflake divertor configuration, divertor plasmas are found to be optically thin to Lyman series lines within a large range of parameter variations that include upstream density, divertor transport coefficients, and magnetic configurations. Finally, modest radiation transport effects are only found in a few cases with strongest divertor transport and magnetic configurations closest to the ideal snowflake configuration, however, the plasma background models that were used are yet to be validated with an experiment.

74 ATOMIC AND MOLECULAR PHYSICS↗
DOE OSTI2021

Modeling Snowflake Divertors in MAST-U Tokamak

We report that in a snowflake (SF) divertor, two magnetic field nulls are placed close to each other, creating four strike points (SPs) compared to two in a standard X-point divertor. In preparation for MAST-U experiments, magnetic configurations with the standard and SF divertors with various locations and separation distances of the nulls were modeled using the two-dimensional multi-fluid code UEDGE with a full plasma transport model featuring charge-state-resolved sputtered carbon impurities. The complex interplay of the plasma transport and magnetic configurations was comprehensively studied using a simple model for the theoretically predicted fast plasma mixing driven by the 'churning' mode instability in the two-null SF region. The modeling results show that (1) all SF-plus configurations and SF-minus configuration with closely located nulls produce the same plasma parameters and heat fluxes at the same SPs; (2) SF divertors approach the outer and inner SP detachment conditions at lower upstream density w.r.t. the standard divertor; (3) heat flux profiles at primary SPs are substantially broadened and peak values are reduced in SF configurations w.r.t. SN divertors; this broadening becomes more pronounced with the fast plasma mixing increase.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2021

Outer midplane neutral density measurements and H-mode fueling studies in NSTX-U

Neutral density profiles are measured on the outboard midplane of the National Spherical Torus Experiment Upgrade (NSTX-U) using a two dimensional camera (ENDD, edge neutral density diagnostic) filtered for deuterium Balmer α (D α ) emission interpreted via simulations using the Monte Carlo neutral transport code DEGAS 2. Deuterium atomic densities n D are calculated by inverting the line-integrated D α brightness and using local measurements of electron density ne and temperature T e to determine atomic rate coefficients. The assumptions used in the derivation of n D from D α emissivity are validated using DEGAS 2 to estimate contributions to emissivity due to electron impact excitation and molecular processes. In this work, experimental measurements and DEGAS 2 simulations are compared over a database of L- and H-mode discharges, showing good agreement in D α emissivity profiles. Residual disagreement between experiment and simulations is suggestive of the possible role of intermittent transport and uncertainties in the molecular data. DEGAS 2 simulations are further used to complement the ENDD diagnostic, extracting neutral (atomic and molecular) densities at locations where the ENDD measurement are not made or where the assumptions used in the ENDD analysis are not valid. Deuterium atomic densities and ionization profiles on the outer midplane are compared for L-mode and H-mode discharges in NSTX-U. One-way coupling of DEGAS 2 to UEDGE multi-fluid simulations constrained by experimental data is used to study edge fueling and neutral penetration in NSTX-U discharges.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗