Search NASA⌕ Search

Engineering topics

Spetzler, H.

Publications and source records attributed to Spetzler, H..

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2000

Earthworks: Educating Teachers in Earth System Sciences

Earthworks is a national community of teachers and scientists. Initiated in 1998 with funding from NASA, our summer workshops in the Rocky Mountains each year provide unique opportunities for teachers to design and conduct field research projects, working closely with scientists. Teachers then develop plans for classroom implementation during the school year, sharing their ideas and experiences with other community members through e-mail and a listserv. Scientists, from graduate students to expert senior researchers, share their knowledge of field methods in environmental science, and learn how to better communicate and teach about their research.

Spetzler, H.↗
NASA NTRS1986

Improved acoustic emission locations

A technique for locating acoustic emission in brittle rock specimens is described. An array of eight piezoelectric transducers was used to detect acoustic emission and to receive velocity measurement pulses. Axial and transverse velocities were calculated from the transmission data; the use of the velocity data to locate the acoustic emissions is discussed. Waveforms were recorded for about 140 acoustic emissions during the deformation of the Westerly granite specimen and about 100 acoustic emissions were located. The effect of transducer size and incident angle on apparent arrival times is evaluated using a lead zirconium titinate transducer bonded to a small brass rider with a curved surface matched to the brass specimen. The relation between location accuracy in various regions of the specimen and the geometry of the receiver array is studied. It is observed that for incidence angles away from the normal, the velocity appears to be higher than for normal incidences.

Getting, I. C.↗
NASA NTRS1985

A solid-state framework for terrestrial upper mantles

A framework is proposed for understanding the upper mantle structure of the terrestrial planets which is based on solid state dislocation processes. It is proposed that the base of the lithosphere on any planet with a Mg-Fe silicate rich upper mantle is defined by the threshold temperatures of low energy dislocation glide systems in olivine and the pyroxenes. This threshold temperature is approximately 1100 to 1200 K and is directly tied to the mobility of olivine and pyroxene dislocations. Using this definition, all terrestrial planets of the Inner Solar System are expected to have mantle lithospheres. Second, the anomalous properties of the asthenosphere in the Earth are related to the rheological properties of an olivine rich differentiate approximately 220 km thick. All of these properties can be the result of the abundant low energy glide systems in olivine which are mobile at temperatures above approximately 1200 K. It is proposed that a true planetary asthenosphere must be both olivine rich and at temperatures above approximately 1200 K. This mode for the asthenosphere does not require partial melting and is therefore less sensitive to the constraints of volatile content in the upper mantle. The thickness of planetary lithospheres is estimated as is maximum thickness of the olivine rich differentiate on each planet. The cooling of the olivine rich layer on Mars (and hence disappearance of the asthenosphere) may coincide with the cessation of global tectonic activity approximately 1 Gyr ago.

Estey, L.↗
NASA NTRS1984

Ultrasonic probing of the fracture process zone in rock using surface waves

A microcrack process zone is frequently suggested to accompany macrofractures in rock and play an important role in the resistance to fracture propagation. Attenuation of surface waves propagating through mode I fractures in wedge-loaded double-cantilever beam specimens of Westerly granite has been recorded in an attempt to characterize the structure of the fracture process zone. The ultrasonic measurements do not support the generally accepted model of a macroscopic fracture that incrementally propagates with the accompaniment of a cloud of microcracks. Instead, fractures in Westerly granite appear to form as gradually separating surfaces within a zone having a width of a few millimeters and a length of several tens of millimeters. A fracture process zone of this size would necessitate the use of meter-sized specimens in order for linear elastic fracture mechanics to be applicable.

Swanson, P. L.↗
NASA NTRS1979

Time dependent deformation of a basalt at low differential stress

A detailed study of linear elastic deformation in Ralston basalt during triaxial loading has been made as a function of strain rate (8 x 10 to the -8th per sec to 5 x 10 to the -5th per sec) and moisture content under constant confining pressure (500 bars) and temperature (20 C). Young's modulus was found to be constant and independent of moisture content and strain rate; however, Poisson's ratio decreased 5.7 plus or minus 1.6% and 6.7 plus or minus 1.6% per order of magnitude increase in strain rate for two suites of dry samples and 1.4 plus or minus 1.2% per equivalent change in strain rate for one suite of wet rocks. Lateral expansion in dry rocks is therefore a more sensitive function of strain rate than it is in wet rocks. It is suggested that this strain-rate dependence is related to microcracking.

Brodsky, N.↗
NASA NTRS1979

Comparison of single crack propagation in lunar analogue glass and the failure strength of rocks

New data of crack propagation in lunar analogue glass provides important input for the construction of deformation maps (maps which delineate the rates and principal means of material deformation under various environmental conditions) applicable to the lunar crust. Comparison of single crack propagation data obtained on flat plates of glass and failure strength data obtained on fine grained rock samples show that single crack propagation velocities are directly related to the failure strength of rocks. The chemical reaction between water and silicon-oxygen bonds at the crack tip seems to be of first order. This greatly simplifies extrapolation to low partial pressures of H2O

Soga, N.↗
NASA NTRS1978

The effect of dilatancy on velocity anisotropy in Westerly granite

Jacketed samples of Westerly granite were fractured at confining pressures up to 1 kbar, and compressional and horizontally as well as vertically polarized shear velocities were measured in orthogonal directions perpendicular to the compression axis. Changes occurring with increased strain are described, and the velocity data were analyzed by application of the Anderson et al (1974) approach. Observed and calculated velocities are found to be in good agreement, and the degree of dilatancy was determined from the differences between the strains measured perpendicularly to the compression axis and the estimated elastic strains in those directions.

Soga, N.↗
NASA NTRS1978

Precursors to failure in rocks while undergoing anelastic deformations

Specimens of pyrophyllite, which exhibits large anelastic deformation before brittle failure, were stressed to failure in a biaxial press to model stress accumulation prior to an earthquake. Optical holography, sound velocity measurements and photography through transparent pistons were used to study the specimens. A zone of preferential deformation around the incipient fault was monitored at 50% or more of ultimate failure strength; reversals of seismic velocities and formation of en echelon cracks near the coming macrocrack were also observed. The dependence of the seismic velocity reversals on moisture was noted.

Sobolev, G.↗
NASA NTRS1977

The effect of outgassing upon the closure of cracks and the strength of lunar analogues

The effect of an ultrahigh vacuum and low water vapor pressure on the stress-strain relation in rocks was studied in order to understand geologic and tectonic processes of the moon. Terrestrial basaltic rocks carefully outgassed in high vacuum provided the sample material for the compression tests reported here. The tests were conducted either under 1 atm air saturated with moisture, or under high vacuum. Results of the stress-strain determinations indicated that the dry rocks could show as much as twice the strength of the wet rocks. The data may also provide a means of reconciling the high strength and high temperature exhibited by the lunar interior.

Mizutani, H.↗
NASA NTRS1976

Determination of strains in optical windows of a high-pressure chamber by holographic interferometry and finite element analysis

Holographic interferometry and finite element analysis have been applied to determine the strain in a large optical window installed in a high-pressure chamber. Two different shapes of windows were chosen, and the outside and inside surface strains of the windows were followed as a function of internal pressure by taking double exposed holograms at 69-bar intervals up to 483 bars. The results were compared with the values calculated by a standard finite element code with an assumption of no displacement at the load-bearing edge. The agreement between two results was found to be good for both cases.

Soga, N.↗