Search NASA⌕ Search

Engineering topics

Steffen, Fred W

Publications and source records attributed to Steffen, Fred W.

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1957

Summary of Scale-Model Thrust-Reverser Investigation

An investigation was undertaken to determine the characteristics of several basic types of thrust-reverser. Models of three types, target, tailpipe cascade, and ring cascade, were tested with unheated air. The effects of design variables on reverse-thrust performance, reversed-flow boundaries, and thrust modulation characteristics were determined.

Povolny, John H↗
NASA NTRS1956

Performance Characteristics of Cylindrical Target-type Thrust Reversers

From tests on cylindrical target-type thrust reversers, it was found that the reverser frontal area, lip angle, end-plate angle, and end-plate depth had important effects on reverse-thrust performance. Frontal area, reverser depth, lip angle, and end-plate angele had important effects on the spacing required for unrestricted nozzle flow. For reverse-thrust ratios greater than 64 percent, the reversed flow attached to the 7 degree cowl in quiescent air. Swept-type cylindrical reversers were generally unstable. The thrust-modulation characteristics of a cylindrical target-type thrust reverser were found to be satisfactory.

Steffen, Fred W↗
NASA NTRS1954

Preliminary Investigation of Performance of Variable-throat Extended-plug-type Nozzles over Wide Range of Nozzle Pressure Ratios

As part of an overall program for the experimental investigation of large-scale jet nozzles, a preliminary evaluation of the internal performance characteristics of several variable-throat extended-plug-type nozzles was obtained over a range of nozzle pressure rations from 2 to 15 with nozzle throat variations as great as 2:1. The extended-plug nozzle attained peak thrust coefficients as high as those which have been attained with fixed-geometry convergent-divergent nozzles. The thrust coefficients of the extended-plug nozzles were relatively insensitive to both nozzle pressure ratio and throat area over the range investigated. The lack of sensitivity of thrust coefficient to nozzle pressure ratio and throat area was due primarily to the absence of severe decreases in thrust coefficient, which are normally observed at low nozzle pressure ratios for convergent-divergent nozzles because of overexpansion. For choked flow, the flow coefficients of the extended-plug nozzles varied from 0.95 to 0.997. A ratio of the outer-shell exit area to nozzle throat area was found to be an important variable affecting nozzle performance. Most of the configurations reported herein showed a small decrease in thrust coefficient at low nozzle pressure ratios; however, it is believed that this characteristic can nearly be eliminated by proper nozzle design.

NOZZLES↗