Search NASASearch

Engineering topics

Stern, Ryan

Publications and source records attributed to Stern, Ryan.

Mars Helicopter Technology Demonstrator

Aerial exploration of Mars with helicopters could provide mission capabilities that go beyond that of orbiting satellites, landed spacecraft and rovers. Helicopters allow examination of Mars at visual resolutions comparable to landers and rovers but over much longer ranges. They could access and land at designated targets in a controlled manner and could be used to carry or retrieve small payloads. Helicopters could enhance rover missions by quickly scouting out safe traverse routes or providing reconnaissance on possible science target destinations and, as standalone systems, could be used to explore areas that may not be reachable by rovers. Mars helicopters may also be considered as elements of a sample return architecture where they could be used for timely retrieval of small science samples back to a Mars ascent vehicle for return to Earth. The challenge to helicopter use on Mars is the thin carbon dioxide atmosphere with approximately 1% of the density of Earth’s atmosphere. Much like the Sojourner rover on the Pathfinder mission paved the way for the Spirit, Opportunity, Curiosity and the Mars 2020 rovers, an initial demonstration on Mars is desirable so as to inform the development of future helicopter missions. The Jet Propulsion Laboratory is leading a collaborative effort with AeroVironment Inc., and NASA centers Ames, Langley and Glenn to develop a small helicopter as a technology demonstrator. In this paper we briefly describe the results of this effort including results from controlled free-flight of a full-scale (approx 850 g) prototype flown in a test chamber under Mars conditions, the design and development of the 1800 g (not-to-exceed mass) technology demonstrator helicopter, and the operation of the helicopter.

Balaram, J. (Bob)

Distributed Motor Controller (DMC) for Operation in Extreme Environments

This paper presents an extreme environment capable Distributed Motor Controller (DMC) module suitable for operation with a distributed architecture of future spacecraft systems. This motor controller is designed to be a bus-based electronics module capable of operating a single Brushless DC motor in extreme space environments: temperature (-120 C to +85 C required, -180 C to +100 C stretch goal); radiation (>;20K required, >;100KRad stretch goal); >;360 cycles of operation. Achieving this objective will result in a scalable modular configuration for motor control with enhanced reliability that will greatly lower cost during the design, fabrication and ATLO phases of future missions. Within the heart of the DMC lies a pair of cold-capable Application Specific Integrated Circuits (ASICs) and a Field Programmable Gate Array (FPGA) that enable its miniaturization and operation in extreme environments. The ASICs are fabricated in the IBM 0.5 micron Silicon Germanium (SiGe) BiCMOS process and are comprised of Analog circuitry to provide telemetry information, sensor interface, and health and status of DMC. The FPGA contains logic to provide motor control, status monitoring and spacecraft interface. The testing and characterization of these ASICs have yielded excellent functionality in cold temperatures (-135 C). The DMC module has demonstrated successful operation of a motor at temperature.

SiGe

Operation of FPGAs at Extremely Low Temperatures

This paper describes the operation of FPGAs at very low temperatures eg -160(deg)C. Both Actel and Xilinx parts are tested It was found that low temperature operations is not a problem with the parts tested, but there is a problem with powering on an FPGA at cold temperatures.

Field-Programmable Gate Array (FPGA)