Search NASA⌕ Search

Engineering topics

Stewart, Warner L

Publications and source records attributed to Stewart, Warner L.

32 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1954

Analytical investigation of off-design performance of a transonic turbine

The off-design performance and a breakdown of the losses of a transonic turbine were determined by an analytical method that was previously developed for turbines of more conservative design. The analytically obtained performance map is compared with the performance map obtained from an experimental investigation of the turbine. The rotor hub conditions of incidence angle, relative Mach number, and reaction calculated from the analytical results are compared with those calculated from experimental data. The loss breakdown obtained for the transonic turbine did not differ substantially from that previously obtained from a turbine of more conservative design, except that large stator-exit shock losses were predicted for the transonic turbine at low speeds. The trends of the rotor hub incidence angle, relative Mach number, and reaction calculated from the analytical results agreed well with those calculated from the experimental data over the performance range. These trends indicate that, compared with a turbine of more conservative design, the transonic turbine operated over a much smaller range of incidence angle, a much wider range of rotor relative Mach number, and at a considerably lower level of reaction. Good over-all agreement was obtained between the analytically predicted performance and the experimental performance, except at 40-percent design speed, where in the analysis the stator reached limiting loading before the rotor choked. Since this discrepancy resulted from errors in the simplifying assumptions used in the analysis, it is regarded as a limitation in the analytical method as applied to a transonic turbine.

Whitney, Warren J↗
NASA NTRS1954

Analytical Study of Losses at Off-design Conditions for a Fixed Geometry Turbine

An analytical investigation was made to determine the off-design loss characteristics of a fixed-geometry turbine of which the experimental performance was known. The method of analysis utilized an effective loss parameter and assumed that the velocity normal to the blade entrance angle was lost as a total-pressure loss. The method also assumed constant tangential component of velocity between the station just upstream and just downstream of the stator and rotor trailing edge. Good correlation between the analytically and experimentally obtained performance was found over the entire map until limiting loading was approached. The large decrease in efficiency at low-speed high pressure ratios and at high-speed low pressure ratios was found in the analysis to be almost entirely due to the rotor incidence and turbine exit whirl losses. From the results of the investigation it was concluded that for turbines designed to operate efficiently at more than one point, the design must compromise rotor incidence angle and exit whirl losses.

Stewart, Warner L↗
NASA NTRS1953

Investigation of Turbines for Driving Supersonic Compressors III : First Configuration with Four Nozzle Settings and One Nozzle Modification

A turbine designed to power a supersonic compressor was investigated with four nozzle settings and one nozzle modification to determine the effect on turbine performance. With the correct ratio of nozzle throat area to rotor effective throat area, the design specific work was obtained near the peak efficiency. From the results of the investigation it was concluded that the convex in sweep of the rotor inner wall and high degree of blade taper caused the turbine configuration to have two aerodynamic disadvantages in comparison with a turbine configuration with an axial inner wall at the rotor outlet and little axial taper.

TURBINES - MIXED-FLOW↗
NASA NTRS1952

Investigation of turbines for driving supersonic compressors II : performance of first configuration with 2.2 percent reduction in nozzle flow area / Warner L. Stewart, Harold J. Schum, Robert Y. Wong

The experimental performance of a modified turbine for driving a supersonic compressor is presented and compared with the performance of the original configuration to illustrate the effect of small changes in the ratio of nozzle-throat area to rotor-throat area. Performance is based on the performance of turbines designed to operate with both blade rows close to choking. On the basis of the results of this investigation, the ratio of areas is concluded to become especially critical in the design of turbines such as those designed to drive high-speed, high-specific weight-flow compressors where the turbine nozzles and rotor are both very close to choking.

TURBINES--MIXED FLOW↗
NASA NTRS1951

Analytical Investigation of Flow Through High-speed Mixed-flow Turbine

An analysis was made of the flow trough a high-speed mixed-flow turbine based on axially symmetric conditions. The calculated weight flow was lower than that used in the two-dimensional design. The rotor could be redesigned to increase the weight flow and a flow and alleviate undesirable pressure gradients at the expense of increased rotor blade stresses.

TURBINES - MIXED FLOW↗