Engineering topics

Stiles, J. A.

Publications and source records attributed to Stiles, J. A..

13 records

NASA NTRS1984

Performance and Safety Characteristics of Lithium-molybdenum Disulfide Cells

The lithium-molybdenum disulfide system offers attractive characteristics including high rate capability, successful operation up to 75 C, a very low self-discharge rate, a good cycle life and safety characteristics which compare favorably to those of other lithium cells. Moreover, the materials and manufacturing costs for the system is effectively controlled, so the cells should ultimately be competitive with currently marketed rechargeable cells.

Stiles, J. A.↗

NASA NTRS1982

The recognition of extended targets - SAR images for level and hilly terrain

Radar image simulation techniques are used to determine the character of SAR images of area-extensive targets, for the cases of flat underlying terrain and of moderate relief, with a view to the severity of elevation change effects on the detection and recognition of boundaries and shapes. The experiment, which demonstrated these effects on shapes and boundaries, was performed in order to establish Seasat-A SAR performance. Attention is given to the geometry/propagation effects in range perspective imaging that must be known for information extraction.

Stiles, J. A.↗

NASA NTRS1982

A model for radar images and its application to adaptive digital filtering of multiplicative noise

Standard image processing techniques which are used to enhance noncoherent optically produced images are not applicable to radar images due to the coherent nature of the radar imaging process. A model for the radar imaging process is derived in this paper and a method for smoothing noisy radar images is also presented. The imaging model shows that the radar image is corrupted by multiplicative noise. The model leads to the functional form of an optimum (minimum MSE) filter for smoothing radar images. By using locally estimated parameter values the filter is made adaptive so that it provides minimum MSE estimates inside homogeneous areas of an image while preserving the edge structure. It is shown that the filter can be easily implemented in the spatial domain and is computationally efficient. The performance of the adaptive filter is compared (qualitatively and quantitatively) with several standard filters using real and simulated radar images.

Frost, V. S.↗

NASA NTRS1982

Analysis of geologic terrain models for determination of optimum SAR sensor configuration and optimum information extraction for exploration of global non-renewable resources. Pilot study: Arkansas Remote Sensing Laboratory, part 1, part 2, and part 3

Computer-generated radar simulations and mathematical geologic terrain models were used to establish the optimum radar sensor operating parameters for geologic research. An initial set of mathematical geologic terrain models was created for three basic landforms and families of simulated radar images were prepared from these models for numerous interacting sensor, platform, and terrain variables. The tradeoffs between the various sensor parameters and the quantity and quality of the extractable geologic data were investigated as well as the development of automated techniques of digital SAR image analysis. Initial work on a texture analysis of SEASAT SAR imagery is reported. Computer-generated radar simulations are shown for combinations of two geologic models and three SAR angles of incidence.

Kaupp, V. H.↗

NASA NTRS1982

A statistical model for radar images of agricultural scenes

The presently derived and validated statistical model for radar images containing many different homogeneous fields predicts the probability density functions of radar images of entire agricultural scenes, thereby allowing histograms of large scenes composed of a variety of crops to be described. Seasat-A SAR images of agricultural scenes are accurately predicted by the model on the basis of three assumptions: each field has the same SNR, all target classes cover approximately the same area, and the true reflectivity characterizing each individual target class is a uniformly distributed random variable. The model is expected to be useful in the design of data processing algorithms and for scene analysis using radar images.

Frost, V. S.↗

NASA NTRS1981

Textural features for radar image analysis

Texture is seen as an important spatial feature useful for identifying objects or regions of interest in an image. While textural features have been widely used in analyzing a variety of photographic images, they have not been used in processing radar images. A procedure for extracting a set of textural features for characterizing small areas in radar images is presented, and it is shown that these features can be used in classifying segments of radar images corresponding to different geological formations.

Shanmugan, K. S.↗

NASA NTRS1981

Adaptive filtering of radar images for autofocus applications

Autofocus techniques are being designed at the Jet Propulsion Laboratory to automatically choose the filter parameters (i.e., the focus) for the digital synthetic aperture radar correlator; currently, processing relies upon interaction with a human operator who uses his subjective assessment of the quality of the processed SAR data. Algorithms were devised applying image cross-correlation to aid in the choice of filter parameters, but this method also has its drawbacks in that the cross-correlation result may not be readily interpretable. Enhanced performance of the cross-correlation techniques of JPL was hypothesized given that the images to be cross-correlated were first filtered to improve the signal-to-noise ratio for the pair of scenes. The results of experiments are described and images are shown.

Stiles, J. A.↗

NASA NTRS1981

Evaluation of the soil moisture prediction accuracy of a space radar using simulation techniques

Image simulation techniques were employed to generate synthetic aperture radar images of a 17.7 km x 19.3 km test site located east of Lawrence, Kansas. The simulations were performed for a space SAR at an orbital altitude of 600 km, with the following sensor parameters: frequency = 4.75 GHz, polarization = HH, and angle of incidence range = 7 deg to 22 deg from nadir. Three sets of images were produced corresponding to three different spatial resolutions; 20 m x 20 m with 12 looks, 100 m x 100 m with 23 looks, and 1 km x 1 km with 1000 looks. Each set consisted of images for four different soil moisture distributions across the test site. Results indicate that, for the agricultural portion of the test site, the soil moisture in about 90% of the pixels can be predicted with an accuracy of = + or - 20% of field capacity. Among the three spatial resolutions, the 1 km x 1 km resolution gave the best results for most cases, however, for very dry soil conditions, the 100 m x 100 m resolution was slightly superior.

Ulaby, F. T.↗

NASA NTRS1981

An adaptive filter for smoothing noisy radar images

A spatial domain adaptive Wiener filter for smoothing radar images corrupted by multiplicative noise is presented. The filter is optimum in a minimum mean squared error sense, computationally efficient, and preserves edges in the image better than other filters. The proposed algorithm can also be used for processing optical images with illumination variations that have a multiplicative effect.

Frost, V. S.↗

NASA NTRS1981

A model for simulation and processing of radar images

A model for recording, processing, presentation, and analysis of radar images in digital form is presented. The observed image is represented as having two random components, one which models the variation due to the coherent addition of electromagnetic energy scattered from different objects in the illuminated areas. This component is referred to as fading. The other component is a representation of the terrain variation which can be described as the actual signal which the radar is attempting to measure. The combination of these two components provides a description of radar images as being the output of a linear space-variant filter operating on the product of the fading and terrain random processes. In addition, the model is applied to a digital image processing problem using the design and implementation of enhancement scene. Finally, parallel approaches are being employed as possible means of solving other processing problems such as SAR image map-matching, data compression, and pattern recognition.

Stiles, J. A.↗

NASA NTRS1980

Radar image enhancement and simulation as an aid to interpretation and training

Greatly increased activity in the field of radar image applications in the coming years demands that techniques of radar image analysis, enhancement, and simulation be developed now. Since the statistical nature of radar imagery differs from that of photographic imagery, one finds that the required digital image processing algorithms (e.g., for improved viewing and feature extraction) differ from those currently existing. This paper addresses these problems and discusses work at the Remote Sensing Laboratory in image simulation and processing, especially for systems comparable to the formerly operational SEASAT synthetic aperture radar.

Frost, V. S.↗

NASA NTRS1980

Digital preprocessing of SEASAT imagery

A model for radar image data is derived for use in developing enhancement techniques. This model describes the image data as the result of a multiplicative-convolved noise process. This information is then used to design a minimum mean square error (MMSE) filter. The resulting filter is implemented adaptively to change with local statistics. A radar image processing technique which provides the MMSE estimate inside homogeneous areas and tends to preserve edge structure is thus developed. This technique has been implemented and tested using digitally correlated SEASAT-A synthetic aperture radar (SAR) imagery.

Frost, V. S.↗

NASA NTRS1980

Radar image preprocessing

Standard image processing techniques are not applicable to radar images because of the coherent nature of the sensor. Therefore there is a need to develop preprocessing techniques for radar images which will then allow these standard methods to be applied. A random field model for radar image data is developed. This model describes the image data as the result of a multiplicative-convolved process. Standard techniques, those based on additive noise and homomorphic processing are not directly applicable to this class of sensor data. Therefore, a minimum mean square error (MMSE) filter was designed to treat this class of sensor data. The resulting filter was implemented in an adaptive format to account for changes in local statistics and edges. A radar image processing technique which provides the MMSE estimate inside homogeneous areas and tends to preserve edge structure was the result of this study. Digitally correlated Seasat-A synthetic aperture radar (SAR) imagery was used to test the technique.

Frost, V. S.↗