Engineering topics

Stocker, P. J.

Publications and source records attributed to Stocker, P. J..

4 records

NASA NTRS1989

Teflon lubrication of liquid oxygen turbopump bearings

Ball bearings with glass fiber reinforced Teflon ball retainers from hot-fired liquid oxygen turbopumps were analyzed by X-ray photoelectron spectroscopy to determine the extent of Teflon transfer and/or chemical reaction at the bearing surface. No Teflon, but metal fluorides could be found on the metal surface. This indicates that Teflon decomposes and reacts with the bearing steel to form fluorides. Hence, Teflon does not appear to function directly as a lubricant under these operating conditions.

Naerheim, Y.↗

NASA NTRS1988

Determination of the SSME high pressure oxidizer turbopump bearing temperature

The SSME high pressure liquid oxygen turbopump (HPOTP) bearings sometimes wear and experience heating and oxidation of the ball and raceway surfaces. So far it has been impossible to measure the temperature of the bearings directly during operation of the turbopumps. However, a method was developed for determining the surface temperature of the bearings from the composition of the oxides using oxidation samples for calibration and Auger Electron Spectroscopy (AES) for chemical analysis.

Naerheim, Y.↗

NASA NTRS1988

Determining the surface temperature of liquid oxygen cooled bearings

This paper presents a method for determining the surface temperature of liquid-oxygen turbopump bearings during the operation of the turbopump. The method relies on the fact that the surface temperature of a bearing can be correlated with the composition of oxides used to cover the bearings, using oxidation samples for calibration and AES for chemical analysis. Using this method, it was found that, for the bearings studied, the maximum temperature reached by stainless steel bearings was 600 C, which is well below the 1100-C autoignition temperature of the AISI stainless steel.

Naerheim, Y.↗

NASA NTRS1977

Laser extensometer

A drift compensated and intensity averaged extensometer for measuring the diameter or other properties of a substantially cylindrical sample based upon the shadow of the sample is described. A beam of laser light is shaped to provide a beam with a uniform intensity along an axis normal to the sample. After passing the sample, the portion of the beam not striking said sample is divided by a beam splitter into a reference signal and a measurement signal. Both of these beams are then chopped by a light chopper to fall upon two photodiode detectors. The resulting ac currents are rectified and then divided into one another, with the final output being proportional to the size of the sample shadow.

Stocker, P. J.↗