Search NASA⌕ Search

Engineering topics

Stoeckl, Christian

Publications and source records attributed to Stoeckl, Christian.

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Impact of mid- Z gas fill on dynamics and performance of shock-driven implosions at the OMEGA laser

Shock-driven implosions with 100% deuterium (D 2 ) gas fill compared to implosions with 50:50 nitrogen-deuterium (N 2 ⁢D 2 ) gas fill have been performed at the OMEGA laser facility to test the impact of the added mid-Ζ fill gas on implosion performance. Ion temperature (Τ ion ) as inferred from the width of measured DD-neutron spectra is seen to be 34%±6% higher for the N 2⁢ D 2 implosions than for the D 2 -only case, while the DD-neutron yield from the D 2 -only implosion is 7.2±0.5 times higher than from the N 2⁢ D 2 gas fill. The T ion enhancement for N 2 ⁢D 2 is observed in spite of the higher Z, which might be expected to lead to higher radiative loss, and higher shock strength for the D 2 -only versus N 2 ⁢D 2 implosions due to lower mass, and is understood in terms of increased shock heating of N compared to D, heat transfer from N to D prior to burn, and limited amount of ion-electron-equilibration-mediated additional radiative loss due to the added higher-Z material. Further, this picture is supported by interspecies equilibration timescales for these implosions, constrained by experimental observables. The one-dimensional (1D) kinetic Vlasov-Fokker-Planck code ifp and the radiation hydrodynamic simulation codes hyades (1D) and xrage [1D, two-dimensional (2D)] are brought to bear to understand the observed yield ratio. Comparing measurements and simulations, the yield loss in the N 2 ⁢D 2 implosions relative to the pure D 2 -fill implosion is determined to result from the reduced amount of D 2 in the fill (fourfold effect on yield) combined with a lower fraction of the D 2 fuel being hot enough to burn in the N 2 ⁢D 2 case. The experimental yield and T ion ratio observations are relatively well matched by the kinetic simulations, which suggest interspecies diffusion is responsible for the lower fraction of hot D 2 in the N 2 ⁢D 2 relative to the D 2 -only case. The simulated absolute yields are higher than measured; a comparison of 1D versus 2D XRAGE simulations suggest that this can be explained by dimensional effects. The hydrodynamic simulations suggest that radiative losses primarily impact the implosion edges, with ion-electron equilibration times being too long in the implosion cores. The observations of increased T ion and limited additional yield loss (on top of the fourfold expected from the difference in D content) for the N 2 ⁢D 2 versus D 2 -only fill suggest it is feasible to develop the platform for studying CNO-cycle-relevant nuclear reactions in a plasma environment.

47 OTHER INSTRUMENTATION↗
DOE OSTI2024

Silicon x-ray backlighter improvement by targets with spike-like microstructures

In order to accurately probe high energy density matter states, it is vital to create powerful x-ray backlighters. One approach to create such x-ray sources is based on the usage of short-pulse, high-energy lasers, which greatly benefits from an optimization of the laser target coupling. Here, the spectral and temporal x-ray emission profiles of structured silicon targets with micron-sized spikes on the front surface are studied at laser intensities of 10 17 W cm -2 . The laser pulse length is varied between 1 and 20 ps with an energy of up to 1 kJ. The structured targets show an up to 13× enhancement of silicon He α emission compared to flat foils with a well-defined, sharp emission pulse profile. Furthermore, the performance of the microstructured targets is compared to targets with a CH shield as well as foils irradiated with a UV prepulse.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2023

Evidence of non-Maxwellian ion velocity distributions in spherical shock-driven implosions

The ion velocity distribution functions of thermonuclear plasmas generated by spherical laser direct drive implosions are studied using deuterium-tritium (DT) and deuterium-deuterium (DD) fusion neutron energy spectrum measurements. A hydrodynamic Maxwellian plasma model accurately describes measurements made from lower temperature (< 10 keV), hydrodynamiclike plasmas, but is insufficient to describe measurements made from higher temperature more kineticlike plasmas. The high temperature measurements are more consistent with Vlasov-Fokker-Planck (VFP) simulation results which predict the presence of a bimodal plasma ion velocity distribution near peak neutron production. Furthermore, these measurements provide direct experimental evidence of non-Maxwellian ion velocity distributions in spherical shock driven implosions and provide useful data for benchmarking kinetic VFP simulations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2023

Hot electron preheat in hydrodynamically scaled direct-drive inertial confinement fusion implosions on the NIF and OMEGA

Hot electron preheat has been quantified in warm, directly driven inertial confinement fusion implosions on OMEGA and the National Ignition Facility (NIF), to support hydrodynamic scaling studies. These CH-shell experiments were designed to be hydrodynamically equivalent, spanning a factor of 40 in laser energy and a factor of 3.4 in spatial and temporal scales, while preserving the incident laser intensity of 10 15 W/cm 2 . Experiments with similarly low levels of beam smoothing on OMEGA and NIF show a similar fraction (~0.2%) of laser energy deposited as hot electron preheat in the unablated shell on both OMEGA and NIF and similar preheat per mass (~2 kJ/mg), despite the NIF experiments generating a factor of three more hot electrons (~1.5% of laser energy) than on OMEGA (~0.5% of laser energy). This is plausibly explained by more absorption of hot electron energy in the ablated CH plasma on NIF due to larger areal density, as well as a smaller solid angle of the imploding shell as viewed from the hot electron generating region due to the hot electrons being produced at a larger standoff distance in lower-density regions by stimulated Raman scattering, in contrast to in higher-density regions by two-plasmon decay on OMEGA. Finally, the results indicate that for warm implosions at intensities of around 10 15 W/cm 2 , hydrodynamic equivalence is not violated by hot electron preheat, though for cryogenic implosions, the reduced attenuation of hot electrons in deuterium–tritium plasma will have to be considered.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2023

Understanding the fusion yield dependencies in OMEGA DT-layered implosion experiments using a physics-based statistical mapping model

Improving the performance of inertial confinement fusion implosions requires physics models that can accurately predict the response to changes in the experimental inputs. Good predictive capability has been demonstrated for the fusion yield using a statistical mapping of simulated outcomes to experimental data [Gopalaswamy et al., Nature 565(771), 581–586 (2019)]. In this paper, a physics-based statistical mapping approach is used to extract and quantify all the major sources of degradation of fusion yield for direct-drive implosions on the OMEGA laser. Here, the yield is found to be dependent on the age of the deuterium tritium fill, the ℓ = 1 asymmetry in the implosion core, the laser beam-to-target size ratio, and parameters related to the hydrodynamic stability. A controlled set of experiments were carried out where only the target fill age was varied while keeping all other parameters constant. The measurements were found to be in excellent agreement with the fill age dependency inferred using the mapping model. In addition, a new implosion design was created, guided by the statistical mapping model by optimizing the trade-offs between increased laser energy coupling at larger target size and the degradations caused by the laser beam-to-target size ratio and hydrodynamic instabilities. When experimentally performed, an increased fusion yield was demonstrated in targets with larger diameters.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Fuel–shell mix and yield degradation in kinetic shock-driven inertial confinement fusion implosions

Fuel–shell mix in kinetic plasma conditions is probed using nuclear and x-ray self-emission in shock-driven, D 3 He-gas-filled inertial confinement fusion implosions. As initial gas fill density decreases, measured nuclear yields and ion temperatures are lower than expected as compared to radiation-hydrodynamic simulations. Spatially and temporally resolved x-ray emissions indicate significant mixing at the fuel–shell interface in implosions with low initial gas fill density. In conclusion, this observed fuel–shell mix introduces a substantial amount of shell ions into the center of the implosion prior to and during shock flash and is the key mechanism needed in the kinetic-ion simulations to match experimental nuclear yields.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

CBET-induced nonuniformity in direct-drive implosions on OMEGA [Slides]

Three dimensional polarization-dependent CBET plus beam balance and pointing are required to model nonuniformity in direct-drive implosions on OMEGA. Uniform laser energy absorption is essential for successful laser-direct-drive inertial confinement fusion but a growing body of evidence suggests OMEGA implosions are more asymmetric than predictions. By measuring the intensity and polarization of light scattered from individual beams, we have identified OMEGA’s polarization smoothing via distributed polarization rotators (DPR’s) as one previously unrealized source of nonuniformity. Polarization-dependent CBET along with beam energy balance, and beam pointing require three-dimensional modeling. Laser absorption mode 1 predictions from a fully three-dimensional CBET model correlate well with the observed direction of the core flow.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗