In Situ Optical Detection for Ultrasonic Characterization of Materials in a Mach 10 Hypersonic Wind Tunnel
Not Available
Engineering topics
Publications and source records attributed to Stolken, James S..
Not Available
This study investigates the physical processes involved in picosecond pulse (20-28 ps FWHM) laser ablation of Al 6061, 316L stainless steel, and undoped crystalline Si ($\langle$100$\rangle$) over a range of laser wavelength (355 nm and 1064 nm) and fluence (0.1-40 J/cm 2 ). Experimental measurements of material ablation rate show enhanced removal at the 355 nm wavelength, primarily due to laser-plasma interaction (LPI) within the ablative plume that approaches an order of magnitude increase over the measured removal at 1064 nm. A transition in the ablation rate at 355 nm is identified around ~10 J/cm 2 above which the removal efficiency increases by a factor of two to three. Multi-physics radiation hydrodynamic simulations, considering LPI effects and utilizing a novel mixed-phase equation of state model, show that the transition in ablation efficiency is due to the onset of melt ejection through cavitation, where laser-driven shock heating sets the depth of melt penetration and the ensuing release wave from the ablation surface drives cavitation through the imposition of tensile strain within the melt. High-speed pump-probe imaging of the ejecta and ejecta collection studies, as well as scanning electron microscopy of the ablation craters, support the proposed cavitation mechanism in the higher fluence range. The ablation process is vitally influenced by LPI effects and the thermophysical properties of the material.
In a fully coupled thermomechanical model of the nanoscale deformation in amorphous SiO 2 due to laser heating is presented. Direct measurement of the transient, nonuniform temperature profiles was used to first validate a nonlinear thermal transport model. Densification due to structural relaxation above the glass transition point was modeled using the Tool-Narayanaswamy (TN) formulation for the evolution of structural relaxation times and fictive temperature. TN relaxation parameters were derived from spatially resolved confocal Raman scattering measurements of Si–O–Si stretching mode frequencies. These thermal and microstructural data were used to simulate fictive temperatures which are shown to scale nearly linearly with density, consistent with previous measurements from Shelby et al. Volumetric relaxation coupled with thermal expansion occurring in the liquid-like and solid-like glassy states lead to residual stresses and permanent deformation which could be quantified. But, experimental surface deformation profiles between 1700 and 2000 K could only be reconciled with our simulation by assuming a roughly 2 × larger liquid thermal expansion for a-SiO 2 with a temperature of maximum density ~150 K higher than previously estimated by Bruckner et al. Calculated stress fields agreed well with recent laser-induced critical fracture measurements, demonstrating accurate material response prediction under processing conditions of practical interest.
This report summarizes key research, development, and technology accomplishments in Lawrence Livermore National Laboratory’s Engineering Directorate for FY2009.