Search NASA⌕ Search

Engineering topics

Strouse, Geoffrey F.

Publications and source records attributed to Strouse, Geoffrey F..

Cooling Mixed A-Site Halide Perovskites: Impact of Temperature on Optical and Structural Properties

The widespread utilization of perovskite-based photovoltaics requires probing both the structural and optical properties under extreme operating conditions to gain a holistic understanding of the material behavior under stressors. Here, in this study, we investigate the temperature-dependent behavior of mixed A-site cation lead triiodide perovskite thin films (85% methylammonium and 15% formamidinium) in the range from 300 to 20 K. Through a combination of optical and structural techniques, we find that the tetragonal-to-orthorhombic phase transition occurs at similar to 110 K for this perovskite composition, as indicated by the change in the diffraction pattern. With decreasing temperature, the quantum yield increases with a concurrent elongation of the carrier lifetimes, indicating suppression of nonradiative recombination pathways. Interestingly, in contrast to single A-site cation perovskites, an additional optical transition appears in the absorption spectrum when the phase transition is approached, which is also reflected in the emission spectrum. We propose that the splitting of the optical absorption and emission is due to local segregation of the mixed cation perovskite during the phase transition.

36 MATERIALS SCIENCE↗

Plasmon-Induced Hot-Carrier Excited-State Dynamics in Plasmonic Semiconductor Nanocrystals

The variance of carrier relaxation pathways for WO 3–x plasmonic semiconductor nanocrystals (PSNCs) is monitored by transient absorption spectroscopy following excitation of the localized surface plasmon resonance (LSPR) versus the optical band gap (E g,opt ). Excitation of the LSPR leads to efficient hot carrier population above the Fermi level in WO 3–x via Landau damping, in analogy to noble metal LSPR relaxation mechanisms. Hot carrier depopulation occurs on the femtosecond timescale, observed as the concomitant recovery of an LSPR bleach with the appearance of discrete interband and intraband photoinduced absorption features. Further, by comparison, the direct excitation of E g,opt results in trion recombination at donor–acceptor sites within the WO 3–x NC, consistent with exciton decay dynamics observed for typical wide-band-gap semiconductor NCs. From the analysis of pump power dependency data, a hot-carrier electron–phonon coupling constant of 1.47 × 10 11 J K –1 s –1 cm –3 is extracted. The direct comparison of the decay dynamics following E g,opt versus LSPR excitation confirms that the observed plasmon in trioctylphosphine oxide passivated, spherical WO 3–x is a resonance state in which hot carriers are generated only from excitation on resonance with the LSPR frequency. This study on WO 3–x PSNCs provides a toolset that can be used to evaluate the role of hot carriers following LSPR excitation of n-type, plasmonic transparent conducting oxide NCs, where enhancement of photocatalysis, photovoltaic performance, and optical enhancement has been reported.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Cool carriers: triplet diffusion dominates upconversion yield

Perovskites have gained popularity both as the active material in photovoltaics and as bulk triplet sensitizers for solid-state triplet–triplet annihilation upconversion (TTA-UC). Prior to widespread implementation into commercial photovoltaics, an in-depth understanding of the environmental influences on device performance is required. To this point, the temperature-dependent structure–function properties of TTA-UC within methylammonium formamidinium lead triiodide (MAFA)/rubrene UC devices are explored. A strong temperature dependence of the underlying UC dynamics is observed, where the maximum UC efficiency is achieved at 170 K, reflecting the competition between triplet diffusion length, diffusion rate, and triplet–triplet encounter events. Furthermore, a combination of spectroscopic and structural methods and theoretical modelling illustrates that despite the significantly increased carrier lifetime of the perovskite at low temperatures, the TTA-UC dynamics are not governed by the underlying sensitizer properties but rather limited by the underlying triplet diffusion.

Sullivan, Colette M.↗

Surface Doping Boosts Triplet Generation Yield in Perovskite-Sensitized Upconversion

Triplet–triplet annihilation-based photon upconversion (TTA-UC) can efficiently generate higher energy photons at low relative fluences. Bulk metal halide perovskites have offered promise in efficiently sensitizing molecular triplet states in the solid state, necessary for the integration of TTA-UC into device-based applications. Recent work focused on TTA-UC from a rubrene triplet annihilator sensitized by perovskite thin films has established relatively efficient charge extraction from the perovskite, forming the triplet exciton in rubrene. Yet, the specifics underpinning charge transfer at the perovskite/rubrene interface are not fully elucidated. Here, to improve device performance and study the properties governing charge transfer at the interface, various organic solvents are explored to treat the perovskite surface. Scanning tunneling microscopy and spectroscopy show a difference in the electronic band structure, where both n- and p-type terminated perovskite surfaces are observed depending on the solvent used. Supported by optical spectroscopy, the impact of the perovskite electronic structure is monitored, indicating that n-type perovskite sensitizers feature higher TTA-UC efficiencies due to favorable band bending resulting in efficient hole-mediated triplet formation. Overall, the tuning of the electronic structure of the perovskite sensitizer through solvent treatment is shown to be a key force in tuning the mechanism of efficient triplet generation.

36 MATERIALS SCIENCE↗

Ultrafast Triplet Generation at the Lead Halide Perovskite/Rubrene Interface

Triplet sensitization of rubrene by bulk lead halide perovskites has recently resulted in efficient infrared-to-visible photon upconversion via triplet-triplet annihilation. Notably, this process can occur under solar relevant fluxes, potentially paving the way toward integration with photovoltaic devices. In order to further improve the upconversion efficiency, the fundamental photophysical pathways at the perovskite/rubrene interface must be clearly understood to maximize charge extraction. Here, we utilize ultrafast transient absorption spectroscopy to elucidate the processes underlying triplet generation at the perovskite/rubrene interface. In this work, our results point to a triplet generation mechanism based on hot carriers; thermally excited charge carriers in the perovskite cool more rapidly in the presence of rubrene, suggesting rapid extraction of these thermally excited carriers on the picosecond time scale. Subsequent triplet formation in rubrene is observed on a subnanosecond time scale.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Direct Measurement of the Selective Microwave-Induced Heating of Agglomerates of Dipolar Molecules: The Origin of and Parameters Controlling a Microwave Specific Superheating Effect

Agglomerates of polar molecules in nonpolar solvents are selectively heated by microwave radiation. The magnitude of the selective heating was directly measured by using the temperature dependence of the intensities of the Stokes and anti-Stokes bands in the Raman spectra of p-nitroanisole (pNA) and mesitylene. Under dynamic heating conditions, a large apparent temperature difference (ΔT) of over 100 °C was observed between the polar pNA solute and the nonpolar mesitylene solvent. This represents the first direct measurement of the selective microwave heating process. The magnitude of the selective microwave heating was affected by the properties of the agglomerated pNA. As the concentration of the pNA increases, the magnitude of the selective heating of the pNA was observed to decrease. This is explained by the tendency of the pNA dipoles to orient in an antiparallel fashion in the aggregates as measured by the Kirkwood g value, which decreased with increasing concentration. This effect reduces the net dipole moment of the agglomerates, which decreases the microwave absorption. After the radiation was terminated, the effective temperature of the dipolar molecules returned slowly to that of the medium. The slow heat transfer was modeled successfully by treating the solutions as a biphasic solvent/solute system. Based on modeling and the fact that the agglomerate can be heated above the boiling temperature of the solvent, an insulating layer of solvent vapor is suggested to form around the heated agglomerate, slowing convective heat transfer out of the agglomerate. Furthermore, this is an effect unique to microwave heating.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Ligand-Mediated Modification of the Electronic Structure of CdSe Quantum Dots

X-ray absorption spectroscopy and ab initio modeling of the experimental spectra have been used to investigate the effects of surface passivation on the unoccupied electronic states of CdSe quantum dots (QDs). Significant differences are observed in the unoccupied electronic structure of the CdSe QDs, which are shown to arise from variations in specific ligand-surface bonding interactions.

x-ray absorption spectroscopy, quantum dot, electr↗