Search NASASearch

Engineering topics

Stuart, J. W.

Publications and source records attributed to Stuart, J. W..

Fuselage ventilation due to wind flow about a postcrash aircraft

Postcrash aircraft fuselage fire development, dependent on the internal and external fluid dynamics is discussed. The natural ventilation rate, a major factor in the internal flow patterns and fire development is reviewed. The flow about the fuselage as affected by the wind and external fire is studied. An analysis was performend which estimated the rates of ventilation produced by the wind for a limited idealized environmental configuration. The simulation utilizes the empirical pressure coefficient distribution of an infinite circular cylinder near a wall with its boundary later flow to represent the atmospheric boundary layer. The resulting maximum ventilation rate for two door size openings, with varying circumferential location in a common 10 mph wind was an order of magnitude greater than the forced ventilation specified in full scale fire testing. The parameter discussed are: (1) fuselage size and shape, (2) fuselage orientation and proximity to the ground, (3) fuselage-openings size and location, (4) wind speed and direction, and (5) induced flow of the external fire plume is recommended. The fire testing should be conducted to a maximum ventilation rate at least an order of magnitude greater than the inflight air conditioning rates.

Stuart, J. W.

Global enclosure fire modeling with applications

A brief review of LERC (Limiting Energy Release Criteria) is presented. Application of LERC to JSC/Boeing ignition source full-scale tests and to JSC/Dacfir math-model validation tests is outlined. It is concluded that: (1) a complete LERC application to the JSC/Boeing tests verifies the fuel load criterion as the limiting constraint; (2) the variability of magnitude and form of the results of repeated tests with and without small variations in parameters emphasizes the significance of the local flow, species concentration, and heat transfer distribution; and (3) weight loss measurements of recent JSC tests show consistent results with prior methods, fuel load constrained.

Stuart, J. W.

Fuselage ventilation under wind conditions

To determine realistic fuselage ventilation rates for post-crash fires and full-scale fire tests, the effects on wind-about fuselage ventilation rate of various parameters were studied. The parameters investigated were fuselage size and shape, fuselage orientation and proximity to ground, fuselage-opening and location, and wind speed and direction.

Stuart, J. W.

Integrating-sphere coating

Sodium chloride, used with proper solvent-dispersant combination, forms very durable reflective coatings. Several other inorganic salts, such as barium sulfate, barium carbonate, sodium fluoride, potassium chloride, sodium hexafluorosilicate, and aluminum oxide, are also suitable. Sodium chloride may also be used with other formulations to produce same type of coating.

Stuart, J. W.

Improved fire-resistant coatings

Water-base coatings containing potassium silicate show improvement in areas of quick air-drying, crack, craze, and abrasion resistance, adherence, and leach resistance. Coatings are useful as thermal-barrier layers in furnaces, and as general purpose fire resistant surfaces where vapor impermeability is not a requirement.

Hutt, J. B.

Improved reflective coating for integrating spheres

Inorganic salts or oxide material is transparent in single-crystal form, has high refractive index, smooth cleavage, and chemical stability, is stable to radiations of interest, partially soluble and easily dispersed in liquid for spraying, and readily dried /cured/ with reasonable cohesion and adhesion, and has good mechanical stability.

Stuart, J. W.