Engineering topics

Stygar, W. A.

Publications and source records attributed to Stygar, W. A..

7 records

DOE OSTI2024

Opportunities in Pulsed Magnetic Fusion Energy

Fusion is a potentially transformational energy technology, which promises limitless clean energy. Yet, it requires continued scientific and technological development to realize its potential. The conditions necessary for fusion energy gain in terms of the product of plasma pressure P and confinement time $\tau$ have been known for many decades. An underappreciated fact is that pulsed magnetic fusion has demonstrated P $\tau$ performance on par with laser-driven ICF and tokamaks despite receiving only a small fraction of investment relative to those concepts. In light of this demonstrated performance, well-established scaling relations, and opportunities for further innovations, here we advocate for pulsed magnetic fusion as the most attractive path towards commercialization of fusion energy.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Power flow in magnetically insulated transmission lines with ion backscatter effects

Ion backscattering off of surfaces in magnetically insulated transmission lines (MITLs) is often ignored in kinetic simulations of MITL power flow. Backscattering reduces ion current losses and the surface impact heating, which dictates the rate at which surface-adsorbed contaminants are liberated into the anode–cathode gap. Backscatter probabilities are difficult to implement in a kinetic code because there are limited data for incident ion energies less than a few keV. This paper presents an analytic model based on the Rutherford scattering formula that reproduces the measured backscatter probabilities at high incident energies and transitions to the highly reflective behavior expected at low incident energies. The backscatter model is implemented in power flow simulations, which are validated with current loss experiments conducted on the 0.4 TW Mykonos accelerator at Sandia National Laboratories. This simulation setup is then used in a high-current Z-machine shot. In conclusion, backscatter effects are found to be unimportant in the low-current Mykonos regime but significantly reduce current losses at the Z-machine scale.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Sirius I: prototype of a prime-power source for future 1 - 10 GJ fusion-yield experiments

We have designed, assembled, and tested a prototype coaxial impedance-matched Marx generator (IMG). An IMG is a pulsed-power device that achieves electromagnetic-power amplification by triggered emission of radiation. Hence an IMG is a pulsed-power analog of a laser, with an energy efficiency of 90%. We have demonstrated that the prototype performs as predicted theoretically, thereby proving the IMG concept. We propose that a system of IMGs drive a next-generation pulsed-power accelerator that delivers 90 MA to a physics load. Such a machine would attain thermonuclear-fusion yields as high as 1 – 10 GJ, and revolutionize high energy-density-physics experiments in support of the national-security mission.

42 ENGINEERING↗

DOE OSTI2022

Increased Ion Temperature and Neutron Yield Observed in Magnetized Indirectly Driven $\mathrm{D_2}$-Filled Capsule Implosions on the National Ignition Facility

Here, the application of an external 26 Tesla axial magnetic field to a D 2 gas-filled capsule indirectly driven on the National Ignition Facility is observed to increase the ion temperature by 40% and the neutron yield by a factor of 3.2 in a hot spot with areal density and temperature approaching what is required for fusion ignition. The improvements are determined from energy spectral measurements of the 2.45 MeV neutrons from the D(d, n) 3 He reaction, and the compressed central core B field is estimated to be ~4.9 kT using the 14.1 MeV secondary neutrons from the D(T, n) 4 He reactions. The experiments use a 30 kV pulsed-power system to deliver a ~ 3 μs current pulse to a solenoidal coil wrapped around a novel high-electrical-resistivity AuTa 4 hohlraum. Radiation magnetohydrodynamic simulations are consistent with the experiment

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

The Magnetized Indirect Drive Project on the National Ignition Facility

A new project is underway at the National Ignition Facility with the goal of applying a seed magnetic field to the fusion fuel in an indirect drive hohlraum implosion and quantifying the effect on the hot-spot temperature, shape and neutron yield. Magnetizing fusion fuel is calculated to reduce heat loss from the implosion core by constraining the motion of electrons and fusion-generated alpha particles; this can improve the chances of achieving high-gain fusion in a laboratory plasma. Here, we describe the goals of this project and the significant scientific and technological challenges which must be overcome for this project to succeed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Transient magnetic field diffusion considerations relevant to magnetically assisted indirect drive inertial confinement fusion

We report application of a magnetic field to an indirect drive inertial confinement fusion target requires diffusion of the field through the high-Z and electrically conducting Hohlraum. The onset of the external field generates eddy currents in the Hohlraum wall that result in (1) a reduction of the peak field at the capsule, (2) heating of the Hohlraum wall through Ohmic dissipation, and (3) wall movement due to the inward force from the eddy current interacting with the field. Heating of the wall causes an increase in blackbody radiation which can preheat the capsule and frozen deuterium–tritium fuel, while wall motion leads to potential misalignment of the lasers at the Hohlraum wall. Limiting these detrimental effects sets requirements on the tolerable magnitude of each effect. We present a nonlinear model for B-field diffusion through an infinitely long thin-walled cylinder with a temperature dependent resistivity, to show that a 15 μm thick wall of pure gold fails to meet these requirements. A new Hohlraum material made from an alloy of Au and Ta has a measured resistivity of ≥60 times that of Au and is shown with the nonlinear model to meet the requirements for magnetization. We compare the nonlinear model to simulations of the actual Hohlraum target using a finite element code which includes temperature-dependent Hohlraum resistivity.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Pulsed power indirect drive approach to inertial confinement fusion

Herein we propose an approach to Inertial Confinement Fusion (ICF) that could potentially lead to high levels of thermonuclear burn in the laboratory. The proposal is based upon the concept of pulsed power X ray driven hohlraums together with indirectly-driven ICF capsule designs that are scaled up in size from those typically used in laser indirect-drive ICF experiments at the National Ignition Facility (NIF). We propose that near-term NIF experiments can be used to explore some important aspects of the X ray driven hohlraum ICF concept.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗