Genome Sequence of the Button Mushroom Agaricus Bisporus Reveals Mechanisms Governing Adaptation to a Humic-Rich Ecological Niche
Abstract not provided
Engineering topics
Publications and source records attributed to Subramanian, V.
Abstract not provided
Phase pure (1-x)Pb(In{sub 1/2}Nb{sub 1/2})O{sub 3}-x PbTiO{sub 3} ceramics near morphotrophic phase boundary (x = 0.35) are prepared by conventional solid state reaction route, by adding 2 mol.% MgO. The dielectric properties of lead indium niobate-lead titanate ceramic are studied as a function of both temperature and frequency. For this composition the dielectric constant for 100 Hz increases from 1944 at room temperature to 1510 at Curie temperature(304 deg. C). The saturation polarization, measured at room temperature, is found to be 23.9 {mu}C/cm{sup 2} for 40 kV/cm.
The optimization of the ignition process is a crucial issue in the design of many combustion systems. Large eddy simulation (LES) of a conical shaped bluff-body turbulent nonpremixed burner has been performed to study the impact of spark location on ignition success. This burner was experimentally investigated by Ahmed et al. [Combust. Flame 151 (2007) 366-385]. The present work focuses on the case without swirl, for which detailed measurements are available. First, cold-flow measurements of velocities and mixture fractions are compared with their LES counterparts, to assess the prediction capabilities of simulations in terms of flow and turbulent mixing. Time histories of velocities and mixture fractions are recorded at selected spots, to probe the resolved probability density function (pdf) of flow variables, in an attempt to reproduce, from the knowledge of LES-resolved instantaneous flow conditions, the experimentally observed reasons for success or failure of spark ignition. A flammability map is also constructed from the resolved mixture fraction pdf and compared with its experimental counterpart. LES of forced ignition is then performed using flamelet fully detailed tabulated chemistry combined with presumed pdfs. Various scenarios of flame kernel development are analyzed and correlated with typical flow conditions observed in this burner. The correlations between, velocities and mixture fraction values at the sparking time and the success or failure of ignition, are then further discussed and analyzed. (author)
We describe the rational design of oligothiophene semiconductors to facilitate solution-based fabrication of environmentally stable organic field-effect transistors (OFETs). Ultrathin films of ?,?-distyryl quaterthiophene (DS4T), pentathiophene (DS5T), and sexithiophene (DS6T) were prepared via solution processing to probe the effect of styryl end groups, oligomer length, and thin film structure on air stability. These films were prepared via solution deposition and thermal annealing of precursors featuring thermally labile ester solubilizing groups. A detailed study of the thin film structure was performed using atomic force microscopy (AFM), near-edge X-ray absorption fine structure (NEXAFS) spectroscopy, and grazing incidence X-ray diffraction (GIXD). Functional OFETs were obtained for DS5T and DS6T and have, respectively, hole mobilities of 0.051 and 0.043 cm2/(V s) and on/off ratios of 1 x 105 to 1 x 106, whereas DS4T OFETs failed to function because of poor film continuity. The effect of both short-term and long-term exposure to air is tracked in OFETs revealing remarkable stability for both DS5T and DS6T. This stability is attributed to the elimination of reactive sites in ?,?-distyryl oligothiophenes and suggests that careful choice of end-group structure can stabilize these molecules against oxidative degradation.
Abstract not provided