Engineering topics
Publications and source records attributed to Succop, G..
Single-ended notch design facilitates accurate measurements of crack progression. Novel test specimen and novel loading fixture and fracture testing of materials under Mode II, or sliding-mode, loading. Testing required for analysis of failures in structural materials, bearings, and the like.
The reported investigation was undertaken in connection with an attempt to develop procedures which would be useful in standardizing a test method for the precracked Charpy slow bend specimen. A number of alloys was studied for which valid plane-strain fracture toughness values have been established. The investigation shows that useful relations between precracked Charpy slow bend results and crack size factors can be obtained under some circumstances. However, it is not yet known what factors control these circumstances.
Data are presented concerning strength ratios which have been derived from slow bend tests on 0.25-in.-thick precracked Charpy specimens of steels, aluminum alloys, and a titanium alloy for which valid K(Ic) values have been established. The K(Ic) values considered are plane strain fracture toughness values as defined in the ASTM Method E 399-74. The strength ratios are used to develop calibration curves which could be useful in estimating K(Ic) for the purposes of alloy development or quality control.
Strength ratios are reported which were derived from slow bend tests on 0.25 inch thick precracked Charpy specimens of steels, aluminum alloys, and a titanium alloy for which valid K sub Ic values were established. The strength ratios were used to develop calibration curves typical of those that could be useful in estimating K sub Ic for the purposes of alloy development of quality control.
Description of two axial alignment fixtures that are capable of providing very low load application eccentricity in tension tests of threaded notched cylindrical specimens. The described fixtures are simple in design, very compact, and free from the effects of friction. Also, an evaluation procedure is presented that can be used to qualify any fixture for use in sharp notch tensile tests.