Organic Biosignatures in Antarctic Sandstone
Explore the source record for details and available documents.
Antactica Microoganisms Biosignature↗
Engineering topics
Sun, H.
Publications and source records attributed to Sun, H..
Iron isotope biosignatures
The (56)Fe/(54)Fe of Fe-bearing phases precipitated in sedimentary environments varies by 2.5 per mil (delta(56)Fe values of +0.9 to -1. 6 per mil). In contrast, the (56)Fe/(54)Fe of Fe-bearing phases in igneous rocks from Earth and the moon does not vary measurably (delta(56)Fe = 0.0 +/- 0.3 per mil). Experiments with dissimilatory Fe-reducing bacteria of the genus Shewanella algae grown on a ferrihydrite substrate indicate that the delta(56)Fe of ferrous Fe in solution is isotopically lighter than the ferrihydrite substrate by 1.3 per mil. Therefore, the range in delta(56)Fe values of sedimentary rocks may reflect biogenic fractionation, and the isotopic composition of Fe may be used to trace the distribution of microorganisms in modern and ancient Earth.
NASA Center JPL↗
Alkaline Hypersaline Lakes as Analogs for Ancient Microbial Habitats on Mars
As the climate of ancient Mars became colder and drier with time, open bodies of water would have entered a regime in which evaporation exceeded input from precipitation or runoff. This would have resulted in increases in salinity and perhaps pH. The last open water on Mars was most likely found in alkaline hypersaline lakes, and these lakes would have been the last surface aquatic habitats for life on Mars. It follows, then, that the biomarkers most likely to be found in ancient sedimentary basins on Mars are those left by organisms adapted to high salt and high pH environments. We have begun to investigate the nature of biological diversity and adaptation to these environments, and the potential for biomarker preservation in them, using Mono Lake as a terrestrial analog environment. Additional information is contained in the original extended abstract.
McDonald, G. D.↗
Revised sizes and positions for the Mailyan dwarf galaxy catalog
New positions (good to +/- 15 arcsec), revised sizes, and sample cross-identifications are presented for dwarf galaxies discovered and published by Mailyan (1973, Astrofizika, 9, 33). Of the 104 originally cataloged galaxies we were able to recover only 100, despite an extensive search of the red and blue Palomar Observatory Sky Survey (POSS) prints. Over half of the recovered objects were found to correspond to previously cataloged galaxies; few if any of these are dwarf spheriodal galaxies, but rather mostly dwarf irregulars of low surface brightness.
Madore, B. F.↗
Atomization and vaporization characteristics of airblast fuel injection inside a venturi tube
This paper describes the experimental and numerical characterization of the capillary fuel injection, atomization, dispersion, and vaporization of liquid fuel in a coflowing air stream inside a single venturi tube. The experimental techniques used are all laser-based. Phase Doppler analyzer was used to characterize the atomization and vaporization process. Planar laser-induced fluorescence visualizations give good qualitative picture of the fuel droplet and vapor distribution. Limited quantitative capabilities of the technique are also demonstrated. A modified version of the KIVA-II was used to simulate the entire spray process, including breakup and vaporization. The advantage of venturi nozzle is demonstrated in terms of better atomization, more uniform F/A distribution, and less pressure drop. Multidimensional spray calculations can be used as a design tool only if care is taken for the proper breakup model, and wall impingement process.
Sun, H.↗
Revised Sizes and Positions for the Mailyan Dwarf Galaxy Cataolgue
This paper presents new positions, revised sizes, and sample cross-identifications for dwarf galaxies discovered and published by Mailyan in 1973.
galaxies Mailyan Dwarf Galaxies↗
Jet-A fuel evaporation analysis in conical tube injectors
A simple one-dimensional drop-life-history analysis and a multidimensional spray calculation using KIVA-II code are applied to the vaporization of Jet-A fuel in multiple tube injectors. Within the assumptions of the analysis, the one-dimensional results are useful for design purposes. The pressure-atomizer breakup models do not accurately predict the dropsize measured experimentally or deduced from the one-dimensional analysis. Cold flow visualization and dropsize measurements show that capillary wave breakup mechanism plays an important role in the spray angle and droplet impingement on the tube wall.
Lai, M.-C.↗
Comparison of boundary element and finite element methods in spur gear root stress analysis
The boundary element method (BEM) is used to compute fillet stress concentration in spur gear teeth. The results are shown to compare favorably with analogous results obtained using the finite element method (FEM). A partially supported thin rim gear is studied. The loading is applied at the pitch point. A three-dimensional analysis is conducted using both the BEM and FEM (NASTRAN). The results are also compared with those of a two-dimensional finite element model. An advantage of the BEM over the FEM is that fewer elements are needed with the BEM. Indeed, in the current study the BEM used 92 elements and 270 nodes whereas the FEM used 320 elements and 2037 nodes. Moreover, since the BEM is especially useful in problems with high stress gradients it is potentially a very useful tool for fillet stress analyses.
Sun, H.↗