Search NASA⌕ Search

Engineering topics

Sun, Xuhui

Publications and source records attributed to Sun, Xuhui.

Real-time interface investigation on degradation mechanism of organic light-emitting diode by in-operando X-ray spectroscopies

Understanding the chemical evolution at the interface of organic light-emitting diodes (OLEDs) under working conditions is critical for addressing device failure and further improving performance. In this work, an in-operando approach was developed employing synchrotron-based X-ray absorption spectroscopy (XAS) to investigate the electronic structures and chemical degradation mechanisms of a model tris(8-hydroxyquinoline) aluminum (Alq 3 )-based OLED device under working condition. The results identify that Mg atoms from the electrode migrate into the Alq 3 organic layer under a potential bias and replace Al atom sites, forming the unstable Mgq 3 species which lead to device degradation. Here, the findings from the classic and simple model device elucidate the degradation mechanisms occurred at the interface of OLED devices, which may facilitate the development of more efficient and stable OLED devices with complex structures.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Lithium nitrate: A double-edged sword in the rechargeable lithium-sulfur cell

Lithium nitrate (LiNO 3 ) has been the most studied electrolyte additive in lithium-sulfur (Li-S) cells, due to its known function of suppressing the shuttle effect in Li-S cells, which provides a significant increase in the cell's coulombic efficiency and cycling stability. Previous studies indicated that LiNO 3 participated in the formation of a passive layer on the lithium electrode and thus suppressed the redox shuttle of the dissolved polysulfides. However, the effects of the LiNO 3 on the positive electrode materials have rarely been investigated. By combining scanning electron microscopy, element-selective X-ray absorption spectroscopy, and electrochemical characterizations, we performed a comprehensive study of how the LiNO 3 altered the properties of the sulfur electrode/electrolyte interface in Li-S cells and thus influenced the cell performance. We found that LiNO 3 is a double-edged sword in the Li-S cell: on one hand, it increased the consumption of the active sulfur; on the other hand, it promoted the survival of the carbon matrix constituent in the sulfur electrode. These two competitive effects indicated that a proper moderate concentration of LiNO 3 is required to achieve an optimized cell performance.

25 ENERGY STORAGE↗

Atomic-scale understanding of the electronic structure-crystal facets synergy of nanopyramidal CoPi/BiVO 4 hybrid photocatalyst for efficient solar water oxidation

The observation of a spontaneous electron enrichment at the apexes of bismuth vanadate (BiVO 4 ) nanopyramidal arrays is achieved by performing synchrotron-based angular dependent X-ray absorption spectroscopy. In accordance with density function theory calculations, the formation of (112) facets enriched apexes is proposed. Such intrinsically electron-enriched (112) facets at the apexes produce a potential facilitating the diffusion of photoexcited holes, which not only mitigates the recombination with the photoexcited electrons, but also provide an active reaction site for the photoassisted selective growth of cobalt phosphate (CoPi), a well known and highly active co-catalyst for water oxidation at the apex of BiVO 4 nanopyramids. Benefiting from the element-resolved properties of synchrotron-based X-ray spectroscopy, 3d electrons on the vanadium site are directly resolved by resonant inelastic X-ray scattering measurements. Due to this unique morphology, the charge at the apex is expected to induce a strong interaction with CoPi, as a result of the metal-to-ligand charge transfer spectroscopy feature observed from the cobalt site. Substantial evidences are collected by means of comprehensive soft X-ray spectroscopy techniques with high spectral resolution revealing the atomic-scale origin and the nature of the synergy as well as the strong correlation between its unique structural properties and the electronic structure of this novel highly-ordered hybrid photocatalyst and its significantly improved photoelectrochemical performance.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Loading across the Periodic Table: Introducing 14 Different Metal Ions To Enhance Metal–Organic Framework Performance

Loading metal guests within metal–organic frameworks (MOFs) via secondary functional groups is a promising route for introducing or enhancing MOF performance in various applications. In this work, 14 metal ions (Li + , Na + , K + , Mg 2+ , Ca 2+ , Ba 2+ , Zn 2+ , Co 2+ , Mn 2+ , Ag + , Cd 2+ , La 3+ , In 3+ , and Pb 2+ ) have been successfully introduced within the MIL-121 MOF using a cost-efficient route involving free carboxylic groups on the linker. The local and long-range structure of the metal-loaded MOFs is characterized using multinuclear solid-state NMR and X-ray diffraction methods. We note Li/Mg/Ca-loaded MIL-121 and Ag nanoparticle-loaded MIL-121 exhibit enhanced H 2 and CO 2 adsorption; Ag nanoparticle-loaded MIL-121 also demonstrates remarkable catalytic activity in the reduction of 4-nitrophenol.

36 MATERIALS SCIENCE↗

Soft x-ray spectroscopy of high pressure liquid

Here, we describe a new experimental technique that allows for soft x-ray spectroscopy studies (~100-1000 eV) of high pressure liquid (~100 bars). We achieve this through a liquid cell with a 100 nm-thick Si 3 N 4 membrane window, which is sandwiched by two identical O-rings for vacuum sealing. The thin Si 3 N 4 membrane allows soft x-rays to penetrate, while separating the high-pressure liquid under investigation from the vacuum required for soft x-ray transmission and detection. The burst pressure of the Si 3 N 4 membrane increases with decreasing size and more specifically is inversely proportional to the side length of the square window. It also increases proportionally with the membrane thickness. Pressures > 60 bars could be achieved for 100 nm-thick square Si 3 N 4 windows that are smaller than 65 μm. However, above a certain pressure, the failure of the Si wafer becomes the limiting factor. The failure pressure of the Si wafer is sensitive to the wafer thickness. Moreover, the deformation of the Si 3 N 4 membrane is quantified using vertical scanning interferometry. As an example of the performance of the high-pressure liquid cell optimized for total-fluorescence detected soft x-ray absorption spectroscopy (sXAS), the sXAS spectra at the Ca L edge (~350 eV) of a CaCl 2 aqueous solution are collected under different pressures up to 41 bars.

36 MATERIALS SCIENCE↗

Amorphous MoS 3 Infiltrated with Carbon Nanotubes as an Advanced Anode Material of Sodium-Ion Batteries with Large Gravimetric, Areal, and Volumetric Capacities

The search for earth-abundant and high-performance electrode materials for sodium-ion batteries represents an important challenge to current battery research. 2D transition metal dichalcogenides, particularly MoS2, have attracted increasing attention recently, but few of them so far have been able to meet expectations. In this study, it is demonstrated that another phase of molybdenum sulfide—amorphous chain-like MoS3—can be a better choice as the anode material of sodium-ion batteries. Highly compact MoS3 particles infiltrated with carbon nanotubes are prepared via the facile acid precipitation method in ethylene glycol. Compared to crystalline MoS2, the resultant amorphous MoS3 not only exhibits impressive gravimetric performance—featuring excellent specific capacity (≈615 mA h g-1), rate capability (235 mA h g-1 at 20 A g-1), and cycling stability but also shows exceptional volumetric capacity of ≈1000 mA h cm-3 and an areal capacity of >6.0 mA h cm-2 at very high areal loadings of active materials (up to 12 mg cm-2). The experimental results are supported by density functional theory simulations showing that the 1D chains of MoS3 can facilitate the adsorption and diffusion of Na+ ions. At last, it is demonstrated that the MoS3 anode can be paired with an Na3V2(PO4)3 cathode to afford full cells with great capacity and cycling performance.

Ye, Hualin↗

Measuring inside damage of individual multi-walled carbon nanotubes using scanning transmission X-ray microscopy

The electronic structure of individual multi-walled carbon nanotubes (MWCNTs) has been probed using scanning transmission X-ray microscopy (STXM). Although transmission electron microscope (TEM) images show that the exterior of the MWCNTs are clean and straight; the inside structure of some of the MWCNTs is much less well ordered, as revealed by STXM. The amorphization of the interior tubes can be introduced in the growth or modification processes. Moreover, TEM measurement with high dose may also lead to the inside damage. Our results reveal that the structure of individual MWCNTs can be complex and suggest that electronic structure measurements are an important tool for characterizing carbon nanomaterials.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Probing the electronic structure of graphene sheets with various thicknesses by scanning transmission X-ray microscopy

The electronic structure of an aggregation of graphene sheets with various thicknesses was probed by scanning transmission X-ray microscopy. A uniform oxidation of the graphene sheets in the flat area was observed regardless of the thickness, while in the folded area the result could be strongly affected by the geometry. Moreover, thick parts of the aggregation showed strong angle-dependence to the incident X-ray, while thin parts showed less angle-dependence, which might be related to the surface wrinkles and ripples. The electronic structure differences due to the geometry and thickness suggest a complicated situation in the aggregation of graphene sheets.

74 ATOMIC AND MOLECULAR PHYSICS↗

Growth method for chalcongenide phase-change nanostructures

A method for growth of an alloy for use in a nanostructure, to provide a resulting nanostructure compound including at least one of Ge.sub.xTe.sub.y, In.sub.xSb.sub.y, In.sub.xSe.sub.y, Sb.sub.xTe.sub.y, Ga.sub.xSb.sub.y, Ge.sub.xSb.sub.y,Te.sub.z, In.sub.xSb.sub.yTe.sub.z, Ga.sub.xSe.sub.yTe.sub.z, Sn.sub.xSb.sub.yTe.sub.z, In.sub.xSb.sub.yGe.sub.z, Ge.sub.wSn.sub.xSb.sub.yTe.sub.z, Ge.sub.wSb.sub.xSe.sub.yTe.sub.z, and Te.sub.wGe.sub.xSb.sub.yS.sub.z, where w, x, y and z are numbers consistent with oxidization states (2, 3, 4, 5, 6) of the corresponding elements. The melt temperatures for some of the resulting compounds are in a range 330-420.degree. C., or even lower with some compounds.

Yu, Bin↗