Engineering topics

Sydorenko, D.

Publications and source records attributed to Sydorenko, D..

3 records

DOE OSTI2024

Study of synchronous RF pulsing in dual frequency capacitively coupled plasma

Low-pressure multi-frequency capacitively coupled plasmas (CCPs) are used for numerous etch and deposition applications in the semiconductor industry. Pulsing of the radio-frequency (RF) sources enables control of neutral and charged species in the plasma on a millisecond timescale. The synchronous (i.e. simultaneous, in-phase) pulsing of both power sources in a dual frequency CCP is examined in this article. Due to the low gas pressure, modeling has been done using the electrostatic particle-in-cell/Monte Carlo collision method. Here, the objective of this work is to investigate the sensitivity of the plasma properties to small changes in timing during synchronous pulsing of the two RF sources. It is demonstrated that small deviations in the on and off times of the two RF sources can lead to major changes in the plasma characteristics. This high sensitivity is of concern for process repeatability but can be utilized to enable better control of the dynamics of plasma-surface interaction. In the simulations, the pulsing parameters (on and off times and ramp rates) are varied and the temporal evolution of plasma characteristics such as electron density (n e ), species current at the electrode, and electron temperature are examined. It is demonstrated that if the low-frequency (LF) source is turned off a few μs before (or after) the high-frequency source, n e during the off-state is significantly higher (or lower) due to the frequency coupling effect. Similarly, turning on the LF source with a small delay results in a sharp increase in the plasma density when the RF sources are turned on.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Particle-in-cell modeling of electron beam generated plasma

Plasmas generated using energetic electron beams are well known for their low electron temperature (T e ) and plasma potential, which makes them attractive for atomic-precision plasma processing applications such as atomic layer etch and deposition. A 2-dimensional particle-in-cell model for an electron beam-generated plasma in argon confined by a constant applied magnetic field is described here in this article. Plasma production primarily occurs in the path of the beam electrons in the center of the chamber. The resulting plasma spreads out in the chamber through non-ambipolar diffusion with a short-circuiting effect allowing unequal electron and ion fluxes to different regions of the bounding conductive chamber walls. The cross-field transport of the electrons (and thus the steady-state characteristics of the plasma) are strongly impacted by the magnetic field. T e is anisotropic in the electron beam region, but low and isotropic away from the plasma production zone. The plasma density increases and the plasma becomes more confined near the region of production when the magnetic field strengthens. The magnetic field reduces both electron physical and energy transport perpendicular to the magnetic field. T e is uniform along the magnetic field lines and slowly decreases perpendicular to it. Electrons are less energetic in the sheath regions where the sheath electric field repels and confines the low-energy electrons from the bulk plasma. Even though electron and ion densities are similar in the bulk plasma due to quasi-neutrality, electron and ion fluxes on the grounded chamber walls are unequal at most locations. Electron confinement by the magnetic field weakens with increasing pressure, and the plasma spread out farther from the electron beam region.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

2D radial-azimuthal particle-in-cell benchmark for E × B discharges

In this paper we propose a representative simulation test-case of E × B discharges accounting for plasma wall interactions with the presence of both the electron cyclotron drift instability and the modified-two-stream-instability. Seven independently developed particle-in-cell (PIC) codes have simulated this benchmark case, with the same specified conditions. The characteristics of the different codes and computing times are given. Here, results show that both instabilities were captured in a similar fashion and good agreement between the different PIC codes is reported as main plasma parameters were closely related within a 5% interval. The number of macroparticles per cell was also varied and statistical convergence was reached. Detailed outputs are given in the supplementary data, to be used by other similar groups in the perspective of code verification.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗