Engineering topics
Publications and source records attributed to Szabo, B. A..
The computation of engineering data from finite element solutions based on the virtual work formulation is discussed. It is shown that, using specially chosen virtual displacement functions, it is possible to compute certain functionals from the virtual work expression with much greater efficiency than would be possible by direct methods.
Formulation of hierarchic sequences of finite element models for beams, arches, plates and shells based on the principle of virtual work is described. The exact solutions corresponding to models in the hierarchic sequence converge to the exact solution of the fully three-dimensional problem of linear elasticity. The stopping criterion is that the functionals of interest must be substantially independent of the choice of the model. This process is closely related to p-extensions. Aspects of implementation are discussed in connection with axisymmetric shells and an example is presented. An application of superconvergent extraction methods for the computation of stress resultants is demonstrated.
The existence of local a posteriori error indicators for the p-version of the finite element method is demonstrated through numerical examples. It is shown that it is possible to construct reliable error indicators from the residuums and tractions which have the same rate of convergence as the strain energy. The error indicators contribution of an element can be estimated by considering only the element and its immediate neighbors. The optimal sequence of p-distributions can be closely followed by the indicators even when there are only a very few elements, the elements vary greatly in size, the polynomial orders vary, the mesh grading is poor, and the smoothness indices and relative errors vary between wide limits.
The implementation of a computer code CONE (for C(1) continuity) based on the p-version of the finite element method is described. A hierarchic family of triangular finite elements of degree p 5 is used. This family enforces C(1)-continuity across interelement boundaries, and the code is applicable to fourth order partial differential equations in two independent variables, in particular to the biharmonic equation. Applications to several benchmark problems in plate bending are presented. Sample results are examined and compared with theoretical predictions. In particular the analysis of the bending of a rhombic plate shows a significant improvement over othr published results.
An assessment of the potential impact of adaptive finite element technology on the analysis part of the aircraft structural synthesis process is presented. The main conclusion is that adaptive application of the p-version of the finite element method based on indirect error estimation procedures results in substantial cost reduction and increased reliability of the computed data. Adaptivity based on direct a posteriori error estimation has the potential for additional savings.
The results of numerical experiments are presented in which a posteriori estimators of error in strain energy were examined on the basis of a typical problem in linear elastic fracture mechanics. Two estimators were found to give close upper and lower bounds for the strain energy error. The potential significance of this is that the same estimators may provide a suitable basis for adaptive redistribution of the degrees of freedom in finite element models.
An approch to the finite element method which utilizes families of conforming finite elements based on complete polynomials is presented. Finite element approximations based on this method converge with respect to progressively reduced element sizes as well as with respect to progressively increasing orders of approximation. Numerical results of static and dynamic applications of plates are presented to demonstrate the efficiency of the method. Comparisons are made with plate elements in NASTRAN and the high-precision plate element developed by Cowper and his co-workers. Some considerations are given to implementation of the constraint method into general purpose computer programs such as NASTRAN.