T. Shane Sowers | Search NASA

NASA NTRS2024

System Health Management for a Series/Parallel Partial Hybrid Powertrain with Distributed Electric Propulsion

Electrified aircraft powertrains contain multiple interacting subsystems, making them much more complex than traditional aircraft propulsion systems in terms of integration and control. Electrification enables aircraft to have distributed thrust-producing fans that the flight control system can leverage for enhanced maneuverability, further increasing the control complexity. A NASA concept aircraft, the SUbsonic Single Aft eNgine (SUSAN) Electrofan, is such a vehicle. SUSAN is a series/parallel partial hybrid-electric single-aisle transport aircraft that takes advantage of its electrified powertrain to provide fuel burn and emissions benefits when compared to the state-of-the-art. Achieving these benefits requires an appropriately designed control architecture that coordinates the various powertrain and flight control subsystems. As such, the SUSAN aircraft is designed with a high level of automation, allowing it to properly manage coupled subsystems and react rapidly to failures and anomalies. To do this effectively, algorithms that perform component health management, fault detection, isolation, and accommodation, and continuous optimization, must be developed and implemented. This paper describes the development of some of these algorithms for system health management applied to the powertrain of the SUSAN concept aircraft.

Electrified Aircraft Propulsion↗

NASA NTRS2023

Flight Simulator Demonstration and Certification Implications of Powertrain Failure Mitigation in a Partial Turboelectric Aircraft

The Single-aisle Turboelectric AiRCraft with Aft Boundary Layer propulsor (STARC ABL) is a concept aircraft with a partial turboelectric powertrain. The complexity and integrated nature of the partial turboelectric powertrain architecture presents failure modes and hazards not found in conventional aircraft propulsion designs. Previously, various electrical and mechanical faults and associated recovery modes were demonstrated in a dynamic model of the powertrain. It was shown that certain faults were catastrophic without recovery logic, due specifically to the interaction of the subsystems. However, in each case, the logic, known as a reversionary control mode, enabled continued operation with assumed sufficient thrust to maintain safe flight. The current work evaluates the powertrain faults and recovery strategies using a full aircraft model in a piloted flight simulator, and places it in the context of current regulatory practice. Faults initiated in flight were successfully mitigated, with the accommodated aircraft subsequently evaluated against certification requirements for three-engine aircraft, which were shown to be appropriate for the STARC-ABL configuration.

certification↗

NASA NTRS2022

Implementation Approach for an Electrified Aircraft Concept Vehicle in a Research Flight Simulator

This paper describes a process to develop a flight simulation test capability for the SUbsonic Single Aft eNgine (SUSAN) Electrofan, a subsonic regional jet transport aircraft concept that utilizes electrified propulsion to gain benefits in fuel usage, emissions, and cost. The process, which involves the integration of independently developed models and their subsequent implementation in a flight simulator, is general and can be applied to a variety of aircraft types. However, the use of electrified propulsion architectures has the potential to add complexity beyond that of a traditional aircraft, especially with regard to the pilot interface. The way the pilot interacts with the thrust producing components could vary significantly between architectures, and the information displayed to the pilot will necessarily include additional variables beyond what is normally displayed in a traditional cockpit. This paper describes the integration process in general, as well as specific accommodations made for the architecture under consideration.

flight simulation↗

NASA NTRSDate not supplied

Implementation Approach for an Electrified Aircraft Concept Vehicle in a Research Flight Simulator

•To describe the development of a dynamic model of an electrified propulsion integrated aircraft concept vehicle appropriate for implementation in a research flight simulator. •To bring up questions related to flight decks for electrified propulsion integrated aircraft. →Ultimate implementation of the model should be based on the procedure outlined here and more fully described in the paper →The flight deck requirements for a 2040 entry-into-service type vehicle with electrified propulsion need to be defined and implemented to the extent possible within the existing cockpit

flight simulation↗

NASA NTRSDate not supplied

Implementation Approach for an Electrified Aircraft Concept Vehicle in a Research Flight Simulator

A flight simulation test capability for the SUbsonic Single Aft eNgine (SUSAN) Electrofan is under development. SUSAN is a regional jet transport aircraft concept that utilizes electrified propulsion to gain benefits in fuel usage, emissions, and cost. The process, which involves the integration of independently developed models and their subsequent implementation in a flight simulator, is general and can be applied to a variety of aircraft types. However, the use of electrified propulsion adds complexity beyond that of a traditional aircraft, especially with regard to the pilot interface. The way the pilot interacts with the engines will differ from current practice, and the information displayed to the pilot will necessarily include additional variables beyond what is normally displayed in a traditional cockpit.

flight simulation↗

NASA NTRSDate not supplied

System Health Management for a Series/Parallel Partial Hybrid Powertrain with Distributed Electric Propulsion

Electrified aircraft powertrains contain multiple interacting subsystems, making them much more complex than traditional aircraft propulsion systems in terms of integration and control. Electrification enables aircraft to have distributed thrust-producing fans that the flight control system can leverage for enhanced maneuverability, further increasing the control complexity. A NASA concept aircraft, the SUbsonic Single Aft eNgine (SUSAN) Electrofan, is such a vehicle. SUSAN is a series/parallel partial hybrid-electric single-aisle transport aircraft that takes advantage of its electrified powertrain to provide fuel burn and emissions benefits when compared to the state-of-the-art. Achieving these benefits requires an appropriately designed control architecture that coordinates the various powertrain and flight control subsystems. As such, the SUSAN aircraft is designed with a high level of automation, allowing it to properly manage coupled subsystems and react rapidly to failures and anomalies. To do this effectively, algorithms that perform component health management, fault detection, isolation, and accommodation, and continuous optimization, must be developed and implemented. This paper describes the development of some of these algorithms for system health management applied to the powertrain of the SUSAN concept aircraft.

Electrified Aircraft Propulsion↗

NASA NTRSDate not supplied

System Health Management for a Series/Parallel Partial Hybrid Powertrain with Distributed Electric Propulsion

Electrified aircraft powertrains contain multiple interacting subsystems, making them much more complex than traditional aircraft propulsion systems in terms of integration and control. Electrification enables aircraft to have distributed thrust-producing fans that the flight control system can leverage for enhanced maneuverability, further increasing the control complexity. A NASA concept aircraft, the SUbsonic Single Aft eNgine (SUSAN) Electrofan, is such a vehicle. SUSAN is a series/parallel partial hybrid-electric single-aisle transport aircraft that takes advantage of its electrified powertrain to provide fuel burn and emissions benefits when compared to the state-of-the-art. Achieving these benefits requires an appropriately designed control architecture that coordinates the various powertrain and flight control subsystems. As such, the SUSAN aircraft is designed with a high level of automation, allowing it to properly manage coupled subsystems and react rapidly to failures and anomalies. To do this effectively, algorithms that perform component health management, fault detection, isolation, and accommodation, and continuous optimization, must be developed and implemented. This paper describes the development of some of these algorithms for system health management applied to the powertrain of the SUSAN concept aircraft.

Electrified Aircraft Propulsion↗