Search NASA⌕ Search

Engineering topics

Takayuki Hayashi

Publications and source records attributed to Takayuki Hayashi.

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2021

Application of a new X-ray reflection model to V1223 Sagittarii

In intermediate polars (IPs), the intrinsic thermal emissions from white dwarfs (WDs) have typically been studied. Few reports have analysed X-ray reflections from WDs. We recently developed an elaborate IP-reflection spectral model. Herein, we report the first application of a reflection model with an IP thermal model to the spectra of the brightest typical IP V1223 Sagittarii observed by the Suzaku and Nuclear Spectroscopic Telescope Array satellites. The model reasonably reproduces the spectra within the range of 5–78 keV and estimates the WD mass as 0.92 ± 0.02 Mꙩ. The WD mass estimated by the proposed model is consistent with that measured using an active galactic nucleus reflection model and a partial covering absorption model. However, the choice of incorrect parameter values, such as an unsuitable fitting energy band and an incorrect metal abundance, was found to introduce systematic errors (e.g. ≲0.2 Mꙩ in the WD mass) in the WD mass measurement. Our spin-phase-resolved analysis resulted in discoveries regarding the modulations of the equivalent width of the fluorescent iron K α line and the angle between the post-shock accretion column and the line of sight (viewing angle). The viewing angle anticorrelates approximately with the X-ray flux and has average and semi-amplitude values of 55° and 7°, respectively, which points towards two WD spin axis angles from the line of sight of 55° and 7°, respectively. Both estimated spin axis angles are different from the reported system inclination of 24°.

Takayuki Hayashi↗
NASA NTRS2020

Spatial distribution of the X-ray-emitting plasma of U Geminorum in quiescence and outburst

We present our analysis of the Suzaku data of U Geminorum (U Gem) from 2012 both in quiescence and outburst. Unlike SS Cygni (SS Cyg), the hard X-ray flux of U Gem is known to increase at times of optical outburst. A sophisticated spectral model and reliable distance estimate now reveal that this can be attributed to the fact that the mass accretion rate onto the white dwarf (WD) does not exceed the critical rate that causes the optically thin to thick transition of the boundary layer. From comparison of the X-ray and optical light curves, the X-ray outburst peak seems to be retarded by 2.1 ± 0.5 d, although there remains uncertainty in the X-ray peak identification, due to short data coverage. The larger delay than SS Cyg (0.9–1.4 d) also supports the lower accretion rate in U Gem. A fluorescent iron 6.4 keV emission line bears significant information about the geometry of the X-ray-emitting hot plasma and the accretion disk (AD) that reflects the hard X-ray emission. Our reflection simulation has shown that the optically thick AD is truncated at a distance of 1.20–1.25 times the white dwarf radius (RWD) in quiescence, and the accreting matter in the disk turns into the optically thin hard-X-ray-emitting plasma at this radius. In outburst, on the other hand, our spectral analysis favors the picture that the optically thick disk reaches the WD surface, although disk truncation can take place in the region of <1.012 RWD. From the profile of the 6.4 keV line, we have also discovered that the accreting matter is heated up close to the maximum temperature immediately after the matter enters the boundary layer at the disk truncation radius. This is consistent with the fact that the hard X-ray spectra of dwarf novae, in general, can be well represented with the cooling flow model.

Mai Takeo↗
NASA NTRS2020

Planning In-Flight Calibration for XRISM

The XRISM X-ray observatory will fly two advanced instruments, the Resolve high-resolution spectrometer and the Xtend wide-field imager. These instruments, particularly Resolve, pose calibration challenges due to the unprecedented combination of spectral resolution, spectral coverage, and effective area, combined with a need to characterize the imaging fidelity of the full instrument system to realize the mission’s ambitious science goals. We present the status of the XRISM in-flight calibration plan, building on lessons from Hitomi and other X-ray missions. We present a discussion of targets and observing strategies to address the needed calibration measurements, with a focus on developing methodologies to plan a thorough and flexible calibration campaign and provide insight on calibration systematic error. We also discuss observations that exploit Resolve’s spectral resolution to calibrate atomic codes, and cross-calibration between the XRISM instruments and with other observatories.

Eric D Miller↗