Engineering topics

Tam, Tim C.

Publications and source records attributed to Tam, Tim C..

4 records

NASA NTRS1992

30 degree injectors at hypervelocity conditions

Results are presented of the first high-speed propulsion-related experiments performed in the NASA-Ames 16-Inch Shock Tunnel, designed to simulate combustor inlet conditions at approximately Mach 14. Results demonstrate the capability of the tunnel for high-speed propulsion testing and yield data on the performance of 30-deg flush wall injectors tested in the tunnel. The experimental results are compared with those of a CFD analysis.

Loomis, Mark P.↗

NASA NTRS1992

Flow characterization in the NASA Ames 16-inch Shock Tunnel

Flow characteristics of NASA's 16-Inch Shock Tunnel are determined for purposes of providing hypersonic propulsion simulation capability. The key tunnel operating parameters are the incident shock speed and reservoir pressure and enthalpy. Flow characteristics of concern are the nozzle exit pressure, temperature, Mach number, Reynolds number, chemical composition, and flow uniformity. Surface mounted gages (for pressure and heat transfer) and nonintrusive optical flow diagnostics (emission and absorption spectroscopy and holographic interferometry) are used to verify tunnel conditions. Experimental measurements are used to validate computational analysis for predicting facility performance, and CFD is used to interpret the free stream optical diagnostic measurements.

Cavolowsky, John A.↗

NASA NTRS1992

A method of analyzing holographic interferograms of ballistic models in hypersonic free-flight

The objective of this research was to develop a method to extract integrated flowfield density information from finite-fringe interferograms produced with a laser holographic interferometer. This method was applied to two sets of holograms. An aeroassist flight experiment model flown in a mixture of 50 percent air - 50 percent argon and a blunt slender cone flown in air were flown at Mach 14.5 into freestream static pressures of 0.04 and 0.08 atm, respectively. The method of analysis can be separated into two main divisions. The first step is to identify fringes inside the wake in terms of the fringes in the freestream. This is important because refraction effects have obscured the region near the shock such that fringes cannot be followed into the wake region. The second step is to extrapolate the freestream fringes into the wake to determine the location of disturbance-related fringe shifts. Coupled with assumptions about the shape of the wake region, the locations of the disturbance-related fringe shifts can be related to the integrated density.

Kieffer, Douglas L.↗

NASA NTRS1991

Holographic interferometry at the NASA-Ames Hypervelocity Free-Flight Aerodynamic Facility

A laser holographic interferometer has been designed and developed to improve flow visualization for models in free-flight at high velocities and low freestream static pressures. Of special interest is the flow structure due to high-temperature effects in the post-shock region of models traveling at hypervelocity. A dual-plate technique with a double-pass, Michelson-type configuration has been incorporated in an existing hypervelocity ballistic range. Holograms of 5-deg blunt conical models traveling at 5 km/sec in air at a freestream static pressure of 0.08 atm have been made. Finite- and infinite-fringe interferograms were reconstructed from the holograms and provided qualitative flowfield results. In addition, a digital scanning technique was also used to produce a 'synthetic' infinite-fringe interferogram from the analysis of an experimental finite-fringe interferogram. A 'synthetic' infinite-fringe interferogram shows detail in the wake region not found in the experimental interferograms.

Tam, Tim C.↗