Search NASA⌕ Search

Engineering topics

Tamagno, J.

Publications and source records attributed to Tamagno, J..

Premixed shock-induced combustion studies in the hypulse facility

Engine performance calculations strongly suggest that the oblique detonation-wave engine can outperform the diffusive-burning scramjet engine in the high hypervelocity flight regime; i.e., at flight Mach numbers exceeding about 14. Research is described that examines and characterizes the behavior of oblique detonation waves (ODW). The effort is both computational and experimental, the latter utilizing the NASA Hypulse expansion tube. The experimental work is hampered by preignition of the hydrogen-oxygen-helium mixtures in either the intermediate or acceleration sections of the facility. The experiments are described and possible causes of this preignition are discussed. Initial results obtained from a parallel computation effort indicate that temporally steady ODW are achievable in the Hypulse facility.

Chinitz, W.↗

Effects of oxygen dissociation on hypervelocity combustion experiments

Results are presented of a comparative experimental study conducted to measure the effects of the test gas oxygen dissociation produced in reflected shock tunnels on hypervelocity combustion. An identical combustor model was tested in a reflected shock tunnel with test gas containing about 50 pct by mass of oxygen in dissociated form, as either nitric oxide or atomic oxygen, and in an expansion tube with test gas having negligible dissociated oxygen. Comparisons are made at two test conditions that are energy equivalent to flight conditions at Mach 13.5 and 17.

Bakos, R. J.↗

Mixing, ignition and combustion studies using discrete orifice injection at hypervelocity flight conditions

Testing at hypervelocity test conditions continues in the Hypulse expansion tube. A newly-calibrated Mach 13 operating point has been achieved, and hydrogen injection studies were performed at this test condition. The experiments were conducted in a 2-in x 1-in combustor model employing three injector configurations: a single flush-wall circular orifice; two such orifices on opposite walls (the 'dual' injector configuration); and two orifices on the upper and the lower walls (the 'quad' injector configuration). The quad injectors were distinctly superior to the other two configurations in promoting mixing, ignition, and combustion. The single injector, however, proved to be superior to the dual injectors, supporting the concept that the aspect ratio of the 'injection cell' plays a large role in promoting the processes required to achieve high combustion efficiency.

Bakos, R.↗

Hypersonic Mixing and Combustion Studies in the GASL HYPULSE Facility

Hydrogen-air mixing and combustion experiments at air velocities approaching 17,000 ft/s have been conducted in the expansion tube in CASL's HYPULSE facility. The data were obtained in the facility's sub-millisecond steady flow test period. The results proved to be repeatable and indicated increasing extent of reaction as the fuel-air ratio was increased from stoichiometric to three times stoichiometric. Comparisons were made with the results from a one-dimensional, finite-rate chemistry code and from one-dimensional cycle codes which assume equilibrium chemistry. These comparisons indicate that the magnitudes and trends of the measured longitudinal pressure distributions are predicted by the one-dimensional codes provided that the relevant physical phenomena are accounted for in the computations.

Bakos, R. J.↗