Search NASA⌕ Search

Engineering topics

Tan, Guoqiang

Publications and source records attributed to Tan, Guoqiang.

5 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

P2-Type Moisture-Stable and High-Voltage-Tolerable Cathodes for High-Energy and Long-Life Sodium-Ion Batteries

P2-Na 0.67 Ni 0.33 Mn 0.67 O 2 represents a promising cathode for Na-ion batteries, but it suffers from severe structural degradation upon storing in a humid atmosphere and cycling at a high cutoff voltage. Here we propose an in situ construction to achieve simultaneous material synthesis and Mg/Sn cosubstitution of Na 0.67 Ni 0.33 Mn 0.67 O 2 via one-pot solid-state sintering. Here, the materials exhibit superior structural reversibility and moisture insensitivity. In-operando XRD reveals an essential correlation between cycling stability and phase reversibility, whereas Mg substitution suppressed the P2–O2 phase transition by forming a new Z phase, and Mg/Sn cosubstitution enhanced the P2–Z transition reversibility benefiting from strong Sn–O bonds. DFT calculations disclosed high chemical tolerance to moisture, as the adsorption energy to H 2 O was lower than that of the pure Na 0.67 Ni 0.33 Mn 0.67 O 2 . A representative Na 0.67 Ni 0.23 Mg 0.1 Mn 0.65 Sn 0.02 O 2 cathode exhibits high reversible capacities of 123 mAh g –1 (10 mA g –1 ), 110 mAh g –1 (200 mA g –1 ), and 100 mAh g –1 (500 mA g –1 ) and a high capacity retention of 80% (500 mA g –1 , 500 cycles).

25 ENERGY STORAGE↗
DOE OSTI2021

Visually resolving the direct Z-scheme heterojunction in CdS@ZnIn 2 S 4 hollow cubes for photocatalytic evolution of H 2 and H 2 O 2 from pure water

We report the direct Z-scheme heterojunction has been recently emerging as an appealing architecture for photocatalysts design. Its efficiency depends on the interfacial and structural features of the photocatalysts. Herein, the two-dimensional ZnIn 2 S 4 nanosheets are grown on the surface of CdS hollow cubes to construct the CdS@ZnIn 2 S 4 hierarchical hollow photocatalysts with chemically bonded interface. The visualized measurements based on spatial-resolved surface photovoltage spectroscopy, combined with other spectroscopic and simulation investigations, clearly disclose that the CdS@ZnIn 2 S 4 hollow cubes constitute a highly efficient direct Z-scheme system. This accounts for the stoichiometric generation of H 2 and H 2 O 2 from pure water observed for the CdS@ZnIn 2 S 4 sulfide-only photocatalysts under visible light irradiation with an apparent quantum efficiency of 1.63 % at 400 nm. The present work demonstrates an effective protocol to achieve comprehensive insights into the charge transfer route at semiconductor heterojunction, and offers a viable way for constructing efficient sulfide-only photocatalysts for driving water splitting reaction.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

Consolidating Lithiothermic-Ready Transition Metals for Li2S-Based Cathodes

Li 2 S holds a promising role as a high-capacity Li-containing cathode, circumventing use of metallic lithium in constructing next-generation batteries to replace current Li-ion batteries. However, progress of Li 2 S cathode has been plagued by its intrinsic drawbacks, including high activation potentials, poor rate performance, and rapid capacity fading during long cycling. In this work, a series of Li 2 S/transition metal (TM) nanocomposites are synthesized via a lithiothermic reduction reaction, and it is realized that the presence of TMs in Li 2 S matrix can transform electrochemical behaviors of Li 2 S. On the one hand, the incorporation of W, Mo, or Ti greatly increases electronic and ionic conductivity of Li 2 S composites and inhibits the polysulfide dissolution via the TM—S bond, effectively addressing the drawbacks of Li 2 S cathodes. In particular, Li 2 S/W and Li 2 S/Mo exhibit the highest ionic conductivity of solid-phase Li-ion conductors ever-reported: 5.44 × 10 –2 and 3.62 × 10 –2 S m –1 , respectively. On the other hand, integrating Co, Mn, and Zn turns Li 2 S into a prelithiation agent, forming metal sulfides rather than S 8 after the full charge. These interesting findings may shed light on the design of Li 2 S-based cathode materials.

25 ENERGY STORAGE↗