Search NASA⌕ Search

Engineering topics

Taniguchi, T.

Publications and source records attributed to Taniguchi, T..

63 records · Page 4

Field effect in the quantum Hall regime of a high mobility graphene wire

In graphene-based electronic devices like in transistors, the field effect applied thanks to a gate electrode allows tuning the charge density in the graphene layer and passing continuously from the electron to the hole doped regime across the Dirac point. Homogeneous doping is crucial to understand electrical measurements and for the operation of future graphene-based electronic devices. However, recently theoretical and experimental studies highlighted the role of the electrostatic edge due to fringing electrostatic field lines at the graphene edges [P. Silvestrov and K. Efetov, Phys. Rev. B 77, 155436 (2008); F. T. Vasko and I. V. Zozoulenko, Appl. Phys. Lett. 97, 092115 (2010)]. This effect originates from the particular geometric design of the samples. A direct consequence is a charge accumulation at the graphene edges giving a value for the density, which deviates from the simple picture of a plate capacitor and also varies along the width of the graphene sample. Entering the quantum Hall regime would, in principle, allow probing this accumulation thanks to the extreme sensitivity of this quantum effect to charge density and the charge distribution. Moreover, the presence of an additional and counter-propagating edge channel has been predicted [P. Silvestrov and K. Efetov, Phys. Rev. B 77, 155436 (2008)] giving a fundamental aspect to this technological issue. In this article, we investigate this effect by tuning a high mobility graphene wire into the quantum Hall regime in which charge carriers probe the electrostatic potential at high magnetic field close to the edges. We observe a slight deviation to the linear shift of the quantum Hall plateaus with magnetic field and we study its evolution for different filling factors, which correspond to different probed regions in real space. We discuss the possible origins of this effect including an increase of the charge density towards the edges.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Carbon nanotube quantum dots on hexagonal boron nitride

We report the fabrication details and low-temperature characteristics of carbon nanotube (CNT) quantum dots on flakes of hexagonal boron nitride (hBN) as substrate. We demonstrate that CNTs can be grown on hBN by standard chemical vapor deposition and that standard scanning electron microscopy imaging and lithography can be employed to fabricate nanoelectronic structures when using optimized parameters. This proof of concept paves the way to more complex devices on hBN, with more predictable and reproducible characteristics and electronic stability.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Observations of thermally excited ferromagnetic resonance on spin torque oscillators having a perpendicularly magnetized free layer

Measurements of thermally excited ferromagnetic resonance were performed on spin torque oscillators having a perpendicularly magnetized free layer and in-plane magnetized reference layer (abbreviated as PMF-STO in the following) for the purpose of obtaining magnetic properties in the PMF-STO structure. The measured spectra clearly showed a large main peak and multiple smaller peaks on the high frequency side. A Lorentzian fit on the main peak yielded Gilbert damping factor of 0.0041. The observed peaks moved in proportion to the out-of-plane bias field. From the slope of the main peak frequency as a function of the bias field, Lande g factor was estimated to be about 2.13. The mode intervals showed a clear dependence on the diameter of the PMF-STOs, i.e., intervals are larger for a smaller diameter. These results suggest that the observed peaks should correspond to eigenmodes of lateral spin wave resonance in the perpendicularly magnetized free layer.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Electronic transport in graphene-based heterostructures

While boron nitride (BN) substrates have been utilized to achieve high electronic mobilities in graphene field effect transistors, it is unclear how other layered two dimensional (2D) crystals influence the electronic performance of graphene. In this Letter, we study the surface morphology of 2D BN, gallium selenide (GaSe), and transition metal dichalcogenides (tungsten disulfide (WS{sub 2}) and molybdenum disulfide (MoS{sub 2})) crystals and their influence on graphene's electronic quality. Atomic force microscopy analysis shows that these crystals have improved surface roughness (root mean square value of only ∼0.1 nm) compared to conventional SiO{sub 2} substrate. While our results confirm that graphene devices exhibit very high electronic mobility (μ) on BN substrates, graphene devices on WS{sub 2} substrates (G/WS{sub 2}) are equally promising for high quality electronic transport (μ ∼ 38 000 cm{sup 2}/V s at room temperature), followed by G/MoS{sub 2} (μ ∼ 10 000 cm{sup 2}/V s) and G/GaSe (μ ∼ 2200 cm{sup 2}/V s). However, we observe a significant asymmetry in electron and hole conduction in G/WS{sub 2} and G/MoS{sub 2} heterostructures, most likely due to the presence of sulphur vacancies in the substrate crystals. GaSe crystals are observed to degrade over time even under ambient conditions, leading to a large hysteresis in graphene transport making it a less suitable substrate.

36 MATERIALS SCIENCE↗

Reconfigurable p-n junction diodes and the photovoltaic effect in exfoliated MoS{sub 2} films

Realizing basic semiconductor devices such as p-n junctions are necessary for developing thin-film and optoelectronic technologies in emerging planar materials such as MoS{sub 2}. In this work, electrostatic doping by buried gates is used to study the electronic and optoelectronic properties of p-n junctions in exfoliated MoS{sub 2} flakes. Creating a controllable doping gradient across the device leads to the observation of the photovoltaic effect in monolayer and bilayer MoS{sub 2} flakes. For thicker flakes, strong ambipolar conduction enables realization of fully reconfigurable p-n junction diodes with rectifying current-voltage characteristics, and diode ideality factors as low as 1.6. The spectral response of the photovoltaic effect shows signatures of the predicted band gap transitions. For the first excitonic transition, a shift of >4{sub kB}T is observed between monolayer and bulk devices, indicating a thickness-dependence of the excitonic coulomb interaction.

14 SOLAR ENERGY↗

Ballistic transport in graphene grown by chemical vapor deposition

In this letter, we report the observation of ballistic transport on micron length scales in graphene synthesised by chemical vapour deposition (CVD). Transport measurements were done on Hall bar geometries in a liquid He cryostat. Using non-local measurements, we show that electrons can be ballistically directed by a magnetic field (transverse magnetic focussing) over length scales of ∼1 μm. Comparison with atomic force microscope measurements suggests a correlation between the absence of wrinkles and the presence of ballistic transport in CVD graphene.

36 MATERIALS SCIENCE↗

Two-current spin-dependent conduction in polycrystalline LaMnO{sub 3} produced under oxygen gas flow

We have studied two-current spin-dependent conduction in polycrystalline LaMnO{sub 3} (LMO) produced under the oxygen gas flow (OGF). The polycrystalline La{sub 1−x}Sr{sub x}MnO{sub 3} (LSMO) samples were prepared with x = 0, 0.1, 0.125, 0.15, 0.175, 0.2 by use of a solid-state-reaction method. The LMO sample produced under the OGF showed large electrical conduction due to the self-hole-doping caused by the excess oxygen ions in it. The electrical resistivity and magnetoresistance (MR) of the LSMO samples were measured as a function of temperature (4K-300K). With increasing the temperature, we have observed that the MR ratios of the LSMO samples with x ≠ 0 have one maximum, while that of LMO sample has two maxima. The temperature at the maximum of the MR ratio corresponds to the magnetic phase transition temperature. The existence of two MR maxima for the LMO sample is considered to imply that the LMO sample has two regions with different doping levels; the one is the crystalline grain region with low doping and the other is the amorphous-like grain-boundary region with high doping.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗