Engineering topics

Tentzeris, Manos M.

Publications and source records attributed to Tentzeris, Manos M..

3 records

NASA NTRS2007

Characteristics of a Linearly Tapered Slot Antenna (LTSA) Conformed Longitudinally Around a Cylinder

The family of tapered slot antennas (TSA s) is suitable for numerous applications. Their ease of fabrication, wide bandwidth, and high gain make them desirable for military and commercial systems. Fabrication on thin, flexible substrates allows the TSA to be conformed over a given body, such as an aircraft wing or a piece of clothing for wearable networks. Previously, a Double Exponentially Tapered Slot Antenna (DETSA) was conformed around an exponential curvature, which showed that the main beam skewed towards the direction of curvature. This paper presents a Linearly Tapered Slot Antenna (LTSA) conformed longitudinally around a cylinder. Measured and simulated radiation patterns and the direction of maximum H co-polarization (Hco) as a function of the cylinder radius are presented.

Jordan, Jennifer L.↗

NASA NTRS2004

Excitation of Coupled Slotline Mode in Finite Ground CPW with Unequal Ground Plane Widths

The coupling between the desired CPW mode and the unwanted coupled slotline mode is presented for finite ground coplanar waveguides with unequal ground plane widths. Measurements, quasi-static conformal mapping, and Finite-Difference Time-Domain analysis are performed to determine the dependence of the slotline mode excitation on the physical dimensions of the FGC line and on the frequency range of operation. It is shown that the ratio of the slotline mode to the CPW mode can be as high as 18 dB. The use of airbridges is shown to reduce the slotline mode by 15 dB, but that the slotline mode fully reestablishes itself after 2000 microns. Furthermore, these results are independent of frequency.

Ponchak, George E.↗

NASA NTRS2003

Coupling Between Microstrip Lines With Finite Width Ground Plane Embedded in Thin Film Circuits

Three-dimensional (3D) interconnects built upon multiple layers of polyimide are required for constructing 3D circuits on CMOS (low resistivity) Si wafers, GaAs, and ceramic substrates. Thin film microstrip lines (TFMS) with finite width ground planes embedded in the polyimide are often used. However, the closely spaced TFMS lines a r e susceptible to high levels of coupling, which degrades circuit performance. In this paper, Finite Difference Time Domain (FDTD) analysis and experimental measurements a r e used to show that the ground planes must be connected by via holes to reduce coupling in both the forward and backward directions. Furthermore, it is shown that coupled microstrip lines establish a slotline type mode between the two ground planes and a dielectric waveguide type mode, and that the via holes recommended here eliminate these two modes.

Ponchak, George E.↗