Search NASA⌕ Search

Engineering topics

Thind, Arashdeep S.

Publications and source records attributed to Thind, Arashdeep S..

Giant Modulation of Refractive Index from Picoscale Atomic Displacements

Abstract It is shown that structural disorder—in the form of anisotropic, picoscale atomic displacements—modulates the refractive index tensor and results in the giant optical anisotropy observed in BaTiS 3 , a quasi‐1D hexagonal chalcogenide. Single‐crystal X‐ray diffraction studies reveal the presence of antipolar displacements of Ti atoms within adjacent TiS 6 chains along the c ‐axis, and threefold degenerate Ti displacements in the a – b plane. 47/49 Ti solid‐state NMR provides additional evidence for those Ti displacements in the form of a three‐horned NMR lineshape resulting from a low symmetry local environment around Ti atoms. Scanning transmission electron microscopy is used to directly observe the globally disordered Ti a–b plane displacements and find them to be ordered locally over a few unit cells. First‐principles calculations show that the Ti a – b plane displacements selectively reduce the refractive index along the ab ‐plane, while having minimal impact on the refractive index along the chain direction, thus resulting in a giant enhancement in the optical anisotropy. By showing a strong connection between structural disorder with picoscale displacements and the optical response in BaTiS 3 , this study opens a pathway for designing optical materials with high refractive index and functionalities such as large optical anisotropy and nonlinearity.

36 MATERIALS SCIENCE↗

Formation of Mn-rich interfacial phases in Co 2 Fe x Mn 1-x Si thin films

Here, we report the formation of Mn-rich regions at the interface of Co 2 Fe x Mn 1-x Si thin films grown on GaAs substrates by molecular beam epitaxy (MBE). Scanning transmission electron microscopy (STEM) with electron energy loss (EEL) spectrum imaging reveals that each interfacial region: (1) is 1–2 nm wide, (2) occurs irrespective of the Fe/Mn composition ratio and in both Co-rich and Co-poor films, and (3) displaces both Co and Fe indiscriminately. We also observe a Mn-depleted region in each film directly above each Mn-rich interfacial layer, roughly 3 nm in width in the x = 0 and x = 0.3 films, and 1 nm in the x = 0.7 (less Mn) film. We posit that growth energetics favor Mn diffusion to the interface even when there is no significant Ga interdiffusion into the epitaxial film. Element-specific X-ray magnetic circular dichroism (XMCD) measurements show larger Co, Fe, and Mn orbital to spin magnetic moment ratios compared to bulk values across the Co 2 Fe x Mn 1-x Si compositional range. The values lie between reported values for pure bulk and nanostructured Co, Fe, and Mn materials, corroborating the non-uniform, layered nature of the material on the nanoscale. Finally, SQUID magnetometry demonstrates that the films deviate from the Slater-Pauling rule for uniform films of both the expected and the measured composition. The results inform a need for care and increased scrutiny when forming Mn-based magnetic thin films on III-V semiconductors like GaAs, particularly when films are on the order of 5 nm or when interface composition is critical to spin transport or other device applications.

36 MATERIALS SCIENCE↗

Polymorphism in the Ruddlesden–Popper Nickelate La 3 Ni 2 O 7 : Discovery of a Hidden Phase with Distinctive Layer Stacking

We report the discovery of a novel form of Ruddlesden–Popper (RP) nickelate that stands as the first example of long-range, coherent polymorphism in this class of inorganic solids. Rather than the well-known, uniform stacking of perovskite blocks ubiquitously found in RP phases, this newly discovered polymorph of the bilayer RP phase La 3 Ni 2 O 7 adopts a novel stacking sequence in which single-layer and trilayer blocks of NiO 6 octahedra alternate in a “1313” sequence. Crystals of this new polymorph are described in space group Cmmm, although we note evidence for a competing Imam variant. Transport measurements at ambient pressure reveal metallic character with evidence of a charge density wave transition with an onset at T ≈ 134 K. In conclusion, the discovery of such polymorphism could reverberate to the expansive range of science and applications that rely on RP materials, particularly the recently reported signatures of superconductivity in bilayer La 3 Ni 2 O 7 with T c as high as 80 K above 14 GPa.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Colossal Optical Anisotropy from Atomic-Scale Modulations

Materials with large birefringence (Δn, where n is the refractive index) are sought after for polarization control (e.g., in wave plates, polarizing beam splitters, etc.), nonlinear optics, micromanipulation, and as a platform for unconventional light–matter coupling, such as hyperbolic phonon polaritons. Layered 2D materials can feature some of the largest optical anisotropy; however, their use in most optical systems is limited because their optical axis is out of the plane of the layers and the layers are weakly attached. This work demonstrates that a bulk crystal with subtle periodic modulations in its structure—Sr 9/8 TiS 3 —is transparent and positive-uniaxial, with extraordinary index n e = 4.5 and ordinary index n o = 2.4 in the mid- to far-infrared. The excess Sr, compared to stoichiometric SrTiS 3 , results in the formation of TiS 6 trigonal-prismatic units that break the chains of face-sharing TiS 6 octahedra in SrTiS 3 into periodic blocks of five TiS 6 octahedral units. The additional electrons introduced by the excess Sr form highly oriented electron clouds, which selectively boost the extraordinary index n e and result in record birefringence (Δn > 2.1 with low loss). The connection between subtle structural modulations and large changes in refractive index suggests new categories of anisotropic materials and also tunable optical materials with large refractive-index modulation.

36 MATERIALS SCIENCE↗

Epitaxial Thin Films of a Chalcogenide Perovskite

Chalcogenide perovskites have emerged as a new class of optoelectronic materials, especially for photovoltaic applications, but fundamental properties and applications of chalcogenide perovskites remain limited due to the lack of high-quality thin films. In this paper, we report direct epitaxial thin film growth of BaZrS 3 , a prototypical chalcogenide, by pulsed laser deposition. X-ray diffraction studies show that the films are strongly textured out-of-plane and have a clear in-plane epitaxial relationship with the substrate. Electron microscopy studies confirm the presence of epitaxy for the first few layers of the film at the interface, even though away from the interface, the films are polycrystalline with many extended defects, suggesting the potential for further improvement in growth. X-ray reflectivity and atomic force microscopy show smooth film surfaces and interfaces between the substrate and the film. The films show strong light absorption near the band edge and photoluminescence in the visible region, validating BaZrS 3 as a suitable candidate for ultrathin front absorbers in tandem solar cells. The photodetector devices show fast and efficient photo response with the highest ON/OFF ratio reported for BaZrS 3 films thus far. Our study opens up opportunities to use high quality thin films of chalcogenide perovskites to probe fundamental physical phenomena in thin films and heterostructures and also in photovoltaic and optoelectronic applications.

36 MATERIALS SCIENCE↗

High frequency atomic tunneling yields ultralow and glass-like thermal conductivity in chalcogenide single crystals

Crystalline solids exhibiting glass-like thermal conductivity have attracted substantial attention both for fundamental interest and applications such as thermoelectrics. In most crystals, the competition of phonon scattering by anharmonic interactions and crystalline imperfections leads to a non-monotonic trend of thermal conductivity with temperature. Defect-free crystals that exhibit the glassy trend of low thermal conductivity with a monotonic increase with temperature are desirable because they are intrinsically thermally insulating while retaining useful properties of perfect crystals. However, this behavior is rare, and its microscopic origin remains unclear. Here, we report the observation of ultralow and glass-like thermal conductivity in a hexagonal perovskite chalcogenide single crystal, BaTiS 3 , despite its highly symmetric and simple primitive cell. Elastic and inelastic scattering measurements reveal the quantum mechanical origin of this unusual trend. A two-level atomic tunneling system exists in a shallow double-well potential of the Ti atom and is of sufficiently high frequency to scatter heat-carrying phonons up to room temperature. While atomic tunneling has been invoked to explain the low-temperature thermal conductivity of solids for decades, our study establishes the presence of sub-THz frequency tunneling systems even in high-quality, electrically insulating single crystals, leading to anomalous transport properties well above cryogenic temperatures.

36 MATERIALS SCIENCE↗

Demonstration of nearly pinhole-free epitaxial aluminum thin films by sputter beam epitaxy

Superconducting resonators with high quality factors have been fabricated from aluminum films, suggesting potential applications in quantum computing. Improvement of thin film crystal quality and removal of void and pinhole defects will improve quality factor and functional yield. Epitaxial aluminum films with superb crystallinity, high surface smoothness, and interface sharpness were successfully grown on the c-plane of sapphire using sputter beam epitaxy. This study assesses the effects of varying substrate preparation conditions and growth and prebake temperatures on crystallinity and smoothness. X-ray diffraction and reflectivity measurements yield extensive Laue oscillations and Kiessig thickness fringes for films grown at 200 °C under 15 mTorr Ar, indicating excellent crystallinity and surface smoothness; moreover, an additional substrate preparation procedure which involves (1) a modified substrate cleaning procedure and (2) prebake at 700 °C in 20 mTorr O 2 is shown by atomic force microscopy to yield nearly pinhole-free film growth while maintaining epitaxy and high crystal quality. The modified cleaning procedure is environmentally friendly and eliminates the acid etch steps common to conventional sapphire preparation, suggesting potential industrial application both on standard epitaxial and patterned surface sapphire substrates.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Amorphization and Plasticity of Olivine During Low-Temperature Micropillar Deformation Experiments

Experimentally quantifying the viscoplastic rheology of olivine at the high stresses and low temperatures of the shallow lithosphere is challenging due to olivine's propensity to deform by brittle mechanisms at these conditions. In this study, we use microscale uniaxial compression tests to investigate the rheology of an olivine single crystal at room pressure and temperature. Pillars with nominal diameters of 1.25 μm were prepared using a focused ion beam milling technique and were subjected to sustained axial stresses of several gigapascal. The majority of the pillars failed after dwell times ranging from several seconds to a few hours. However, several pillars exhibited clear evidence of plastic deformation without failure after 4–8 hr under load. The corresponding creep strain rates are estimated to be on the order of 10-6 to 10 -7 s -1 . The uniaxial stresses required to achieve this deformation (4.1–4.4 GPa) are in excellent agreement with complementary data obtained using nanoindentation techniques. Scanning transmission electron microscopy observations indicate that deformation occurred along amorphous shear bands within the deformed pillars. Electron energy loss spectroscopy measurements revealed that the bands are enriched in Fe and depleted in Mg. We propose that inhomogeneities in the cation distribution in olivine concentrate stress and promote the amorphization of the Fe-rich regions. Finally, the time dependence of catastrophic failure events suggests that the amorphous bands must grow to some critical length scale to generate an unstable defect, such as a shear crack.

58 GEOSCIENCES↗

Significantly Enhanced Emission Stability of CsPbBr 3 Nanocrystals via Chemically Induced Fusion Growth for Optoelectronic Devices

Lead–halide perovskite nanocrystals (PNCs) have attracted much attention in recent years due to their outstanding optical properties. We report here a new chemical route for triggering postsynthetic growth of CsPbBr 3 PNCs at room temperature via intentional depletion of stabilizing ligands, resulting in an immediate fusion growth of the as-synthesized PNCs. Upon fusion, the CsPbBr 3 PNCs can grow from ca. 8 nm to ca. 60 nm in lateral dimensions in 48 h, reaching about 14 nm in thickness. More importantly, it was found that the fused PNCs have significantly enhanced optical properties. They showed an exceptionally higher stability to photodegradation. They also displayed sharper emission lines and a higher quantum yield, contrary to the fact that the nanocrystals are much larger. The much-improved optical properties are attributed to the Ruddlesden–Popper (RP) planar faults formed during the fusion process and observed using atomic resolution scanning transmission electron microscopy, which are predicted to result in quantum confinement based on density-functional theory calculations. The newly grown nanocrystals with RP defects are expected to significantly improve light emission properties of the PNCs and find applications in light-emitting diodes and other optoelectronic devices.

36 MATERIALS SCIENCE↗