Search NASA⌕ Search

Engineering topics

Thomas Reimer

Publications and source records attributed to Thomas Reimer.

Aerocapture as an Enhancing Option for Ice Giants Missions

Investigation of Uranus and Neptune, via orbiter and atmospheric probes, is required to answer pressing science questions that have been raised in previous Decadal Surveys. As the Ice Giants are the farthest planets from Earth, traditional fully-propulsive orbit insertion missions would require a large amount of propellant, leaving less mass for the scientific payload; additionally, transit time to the planetary bodies near 13-15 years. Aerocapture uses aerodynamic forces generated by flight within a planetary atmosphere to decelerate and achieve orbit insertion. Although, aerocapture has not been used in the past, recent developments in thermal protection systems, guidance and control, and navigation capabilities enable the use of rigid, heritage entry vehicle configurations already flown at other planetary bodies for Ice Giants aerocapture. With the addition of these recent capabilities, aerocapture can robustly deliver spacecraft to Ice Giant orbits, while substantially increasing on-orbit payload mass (more than 40%) and reducing the transit time by 2-5 years (15-30%) relative to fully-propulsive orbit insertion.

Soumyo Dutta↗

TPSAS-NF1676L-16463-DND

Ceramic Matrix Composites (CMCs) have been proposed for hot structures in scramjet combustors. Previous studies have calculated significant weight savings by utilizing CMCs (active and passive) versus actively cooled metallic scramjet structures. Both a C/C and a C/C-SiC material system fabricated by DLR (Stuttgart, Germany) are being considered for use in a passively cooled combustor design for HIFiRE 8, a joint Australia / AFRL hypersonic flight program, expected to fly at Mach 7 for ~ 30 sec, at a dynamic pressure of 55 kPa. Flat panels of the DLR C/C and the C/C-SiC were tested in the NASA Langley Direct Connect Rig (DCR) at Mach 5 and Mach 6 enthalpy for several minutes. Gaseous hydrogen fuel was used to fuel the scramjet combustor. The test panels were instrumented with embedded Type K and Type S thermocouples. Zirconia felt insulation was used in some of the tests to increase the surface temperature of the C/C-SiC panel ~ 350?F. The final C/C-SiC panel was tested for 3 cycles totaling over 135 sec at Mach 6 enthalpy. Slightly more erosion was observed on the C/C panel than the C/C-SiC panels, but both material systems demonstrated acceptable recession performance for the HIFiRE 8 flight.

David E Glass↗