Engineering topics

Thomas, P. C.

Publications and source records attributed to Thomas, P. C..

24 records · Page 2

NASA NTRS1987

Titania's opposition effect - Analysis of Voyager observations

Voyager 2 obtained images of Titania over phase angles ranging from 0.8 to 150 deg and at sufficient resolution to investigate the photometric behavior of different surface units. The large, relatively narrow opposition surge detected from earth was confirmed and can be successfully modeled with Hapke's (1986) photometric theory. Opposition effects do not vary greatly between bright areas (craters and ejecta) and dark areas, but the brightness of the brighter areas decreases more slowly with increasing phase angle than that of the dark areas. Thus the fresher craters and their ejecta become less prominent in relation to the background as opposition is approached. This effect is best explained by a modest difference in single-scattering albedo.

Thomas, P. C.↗

NASA NTRS1984

Glass on the surfaces of Io and Amalthea

The results of laboratory tests of the spectral reflectances of sulfur and sulfur-silicate glasses are compared with Voyager UV and IR spectral data of Io and Amalthea. Sulfur glasses, without the S8 allotrope, are formed when molten sulfur is quickly quenched to temperatures below 150 K. The trials involved heating sulfur to temperatures from 430-700 K, then quenching and recording the color that resulted. It was observed that the insulating properties of sulfur are so high that the glasses would probably only form in volcanic plumes, yielding particles in the 10-100 micron diameter range. Fumarole droplets could impact cold ground and leave 1 mm glass particles. Basalt-sulfur specimens heated to 1400 K to melt the basalt, then cooled, produced glasses of a color which matches the color of darker areas detected on Io. The surface colors of Amalthea, although definitely contaminated with particles from Io mass loss, exhibited only a few color matches with the basalt-sulfur glasses. More refined spectra of Amalthea are required if the surface constituents are to be identified.

Gradie, J.↗

NASA NTRS1982

Wind streaks in Tharsis and Elysium - Implications for sediment transport by slope winds

Detailed maps of wind streaks in Tharsis and Elysium have been compiled from Viking Orbiter observations spanning one complete Martian year. The streak pattern is controlled by slope winds on the central volcanoes and on the flanks of the Tharsis bulge, while the global circulation dominates in Elysium. Dust erosion by downslope winds occurs over much of Tharsis and in the vicinity of Elysium Mons; this process is effective even at the low atmospheric pressures found near the summits of the large volcanoes. Erosional streaks are largely absent in Elysium Planitia; net deposition of dust might have occurred during the period of the observations. Surface properties such as slope, thermal inertia, and roughness may influence the efficiency of slope wind production sufficiently to account for the pronounced differences in streak types and patterns present in these two regions.

Lee, S. W.↗

NASA NTRS1980

Near-surface flow of volcanic gases on Io

Significant near-surface flow of gas several hundred kilometers from Pele (Plume 1) on Io is indicated by a series of bright, elongate albedo markings. Particles produced at small, local vents are apparently carried as much as 70 km farther 'downwind' from Pele. The gas densities and velocities necessary to suspend 0.1 to 10 micron particles at such a distance imply mass flow rates of 10 to the 7th - 10 to the 9th g/sec. Such flow rates are consistent with other estimates of mass transport by the plume. The large flow rates so far from the source allow an estimate of the rate of resurfacing of Io by lava flows and pyroclastics that is independent of estimates based on meteorite flux or on the amount of solids carried within the plumes themselves.

Lee, S. W.↗

NASA NTRS1978

Phobos: Photometry and origin of dark markings on crater floors

High resolution photographs of Phobos taken during close flybys of Viking Orbiter 1 reveal many dark patches on the floors of several craters. The apparently dark material is only prominent at large phase angles. Analysis of the photometric properties indicates that the dark patches represent areas of unusually rough textures whose reflectance near zero phase is similar to that of the mean surface (approximately 6 percent in the visible), but whose phase curve is much steeper. The contrast of such areas is less than 10 percent zero phase but approaches 100 percent near phase angles of 90 degrees. It is proposed that these intricately textured deposits represent patches of vesticular impact melt.

Goguen, J.↗

NASA NTRS1977

The origin of the grooves on Phobos

Various theories for the long, linear depressions on the surface of Phobos are reviewed. Imagery from Viking Orbiters is used to map the surface distribution of the grooves, study their morphology, and date them by means of the density of superimposed impact craters. Data is presented which tends to support the hypothesis that the deep-seated fracturing was caused by a large, nearly catastrophic cratering event. It is suggested that the grooves were produced during the creation of the Stickney crater, rather than as the result of tidal stresses induced by Mars or by drag forces during the hypothetical capture of the satellite by Mars.

Thomas, P. C.↗