Search NASA⌕ Search

Engineering topics

Thomas, Sarah A

Publications and source records attributed to Thomas, Sarah A.

6 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2021

Shock Hugoniot of forged and additively manufactured 304L stainless steel

The purpose of this research was to measure the equation of state for additively manufactured (AM) and forged 304L stainless steel using a novel experimental technique. An understanding of the dynamic behavior of AM metals is integral to their timely adoption into various applications. The Hugoniot of the AM 304L was compared to that of the forged 304L at particle velocities where the material retains a two-wave structure. This comparison enabled us to determine the sensitivity of the equation of state to microstructure as varied due to processing. Our results showed that there was a measurable difference in the measured shock velocity between the AM and forged 304L. The shock wave velocities for the AM 304L were found to be ~3% slower than those for the forged 304L at similar particle velocities. To understand these differences, properties such as densities, sound speeds, and texture were measured and compared between the forged and AM materials. Our results showed that no measurable difference was found in these properties. Additionally, it is possible that differing elastic wave amplitudes may have an effect on shock velocity.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Dynamic Properties of FeCrMnNi, a High Entropy Alloy

High entropy alloys (HEAs) represent a new class of materials that potentially possess an ideal combination of high strength and ductility and may be candidate materials that can withstand high amounts of damage before failure, especially under extreme conditions. To this end, a series of shock/spall loading experiments were conducted on an Fe/Cr/Mn/Ni HEA to assess not only its equation of state (EOS) but also its resistance to damage and failure. A single-stage light gas gun was used to conduct a series of flyer plate symmetric impact experiments coupled with recovery of the samples for post-mortem microstructural analysis to obtain fundamental understanding regarding the damage morphology. Our results show that the measured EOS for this alloy was in reasonable agreement with an estimated Hugoniot value. Additionally, the spall strength of these alloys was found to vary between 1.4 and 1.9 GPa within the same plate but was comparable to other iron-based conventional alloys. DOE/NV/03624--1059

36 MATERIALS SCIENCE↗