Search NASA⌕ Search

Engineering topics

Thompson, S. A.

Publications and source records attributed to Thompson, S. A..

Detonation Soot: A New Class of Ice Nucleating Particle

Abstract Temperatures and pressures from high explosive detonations far exceed atmospheric conditions in typical combustion reactions, and consequently, detonation soot forms with physiochemical properties distinct from soot formed by combustion. In this study, samples of detonation soot from two high explosives, PBX 9502 and Composition B‐3, were analyzed. Ice nucleation experiments on soot collected after controlled detonations were conducted in the laboratory to probe immersion and contact mode freezing. Samples nucleated ice at temperatures warmer than commercially available nanodiamonds, which has a mean nucleation temperature of −20.7°C. Ice nucleation rate coefficients increase rapidly by two to three orders of magnitude below −20°C for every sample. Size‐selected 137 μm diameter particles produced during detonation in an ambient air atmosphere yield bimodal distributions of freezing temperature with primary and secondary nucleation modes centered at −20°C and −13°C, respectively. The presence of a secondary mode allows for enhanced ice nucleation rate coefficients (one to two orders of magnitude greater than samples without a secondary mode) at temperatures outside the influence of the primary mode (>−17°C). Given the observed onset nucleation temperatures of −9.2°C, our results imply that detonation soot of the type studied here would only need to reach an altitude of approximately 4 km to facilitate ice formation.

54 ENVIRONMENTAL SCIENCES↗

Unsteady surface pressure distributions on a delta wing undergoing large amplitude pitching motions

Wind tunnel experiments were performed on a 70-deg-sweep delta wing to determine the effect of a sinusoidal pitching motion on the pressure field on the suction side of the wing. Pressure taps were placed from 35-90 percent of the chord, at 60 percent of the local semi-span. Pressure coefficients were measured as functions of Reynolds number and pitch rate. The surface pressure distribution was seen to vary at the same frequency as the pitching frequency, though distortion due to the vortex breakdown was observed. Comparing the upstroke (angle of attack increasing) and downstroke (angle of attack decreasing) pressures for a specific angle of attack, a time lag in the pressure distribution was observed. The downstroke pressures were slightly larger at the forward chord locations. Vortex breakdown was seen to have the most significant effect at the 40-45-percent chord location, where an increase in local pressure was apparent, as well as a distortion of the periodic pressure fluctuation.

Thompson, S. A.↗

Delta wing surface pressures for high angle of attack maneuvers

A wind tunnel experiment was performed on a delta wing with a leading edge sweep of 70 deg. Unsteady pressures were measured on the suction surface of the wing as it was oscillated from 0-30 deg, and 2-60 deg angle-of-attack. Pressure coefficients were measured at different surface locations for two pitch rates. Static pressure measurements were also obtained for comparison with the dynamic results. The Reynolds number was fixed at 420,000, based on the centerline chord length. Pressure measurements were made from 35-90 percent of the chord, along a ray from the apex at 60 percent of the local semispan. Spanwise measurements were also made at a constant chord location, x/c = 75 percent from the apex. The unsteady pressure data over the 0-30 deg angle-of-attack range showed pressures fluctuating in phase with model motion, and little overshoot from the static values. The pressures for the large amplitude motion showed large overshoots from the static values. In addition, during the high angle-of-attack portion of the motion, the upstroke (angle of attack increasing) pressure coefficients were typically much lower than the downstroke values. For the lower pitch rate, there was little difference between upstroke and downstroke pressures at the low angles of attack.

Thompson, S. A.↗

The separated flow field on a slender wing undergoing transient pitching motions

The flow field surrounding a delta wing undergoing a transient pitching motion was studied experimentally. Of particular importance was the location of the leading edge vortices over the surface of the wing. The study was conducted on a 70-deg sweep flat-plate delta wing pitched about its one-half chord position. It is found that the maximum pitch rate is the key factor involved in the amount of lag experienced by the vortex breakdown during the transient pitching motion.

Thompson, S. A.↗