Search NASA⌕ Search

Engineering topics

Tien, Jeffrey Y.

Publications and source records attributed to Tien, Jeffrey Y..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2012

Connect Global Positioning System RF Module

The CoNNeCT Global Positioning System RF Module (GPSM) slice is part of the JPL CoNNeCT Software Defined Radio (SDR). CoNNeCT is the Communications, Navigation, and Net working reconfigurable Testbed project that is part of NASA's Space Communication and Nav igation (SCaN) Program. The CoNNeCT project is an experimental dem onstration that will lead to the advancement of SDRs and provide a path for new space communication and navigation systems for future NASA exploration missions. The JPL CoNNeCT SDR will be flying on the International Space Station (ISS) in 2012 in support of the SCaN CoNNeCT program. The GPSM is a radio-frequency sampler module (see Figure 1) that directly sub-harmonically samples the filtered GPS L-band signals at L1 (1575.42 MHz), L2 (1227.6 MHz), and L5 (1176.45 MHz). The JPL SDR receives GPS signals through a Dorne & Margolin antenna mounted onto a choke ring. The GPS signal is filtered against interference, amplified, split, and fed into three channels: L1, L2, and L5. In each of the L-band channels, there is a chain of bandpass filters and amplifiers, and the signal is fed through each of these channels to where the GPSM performs a one-bit analog-to-digital conversion (see Figure 2). The GPSM uses a sub-harmonic, single-bit L1, L2, and L5 sampler that samples at a clock rate of 38.656 MHz. The new capability is the down-conversion and sampling of the L5 signal when previous hardware did not provide this capability. The first GPS IIF Satellite was launched in 2010, providing the new L5 signal. With the JPL SDR flying on the ISS, it will be possible to demonstrate navigation solutions with 10-meter 3-D accuracy at 10-second intervals using a field-program mable gate array (FPGA)-based feedback loop running at 50 Hz. The GPS data bits will be decoded and used in the SDR. The GPSM will also allow other waveforms that are installed in the SDR to demonstrate various GNSS tracking techniques.

Franklin, Garth W.↗
NASA NTRS2012

TriG: Next Generation Scalable Spaceborne GNSS Receiver

TriG is the next generation NASA scalable space GNSS Science Receiver. It will track all GNSS and additional signals (i.e. GPS, GLONASS, Galileo, Compass and Doris). Scalable 3U architecture and fully software and firmware recofigurable, enabling optimization to meet specific mission requirements. TriG GNSS EM is currently undergoing testing and is expected to complete full performance testing later this year.

Global Navigation Satellite Systems (GNSS)↗
NASA NTRS2004

Relative Sensor with 4(pi) Coverage for Formation Flying Missions

The Terrestrial Planet Finder (TPF) pre-project, an element of NASA's Origins program, is currently developing two architectures for a mission to search for earth-like planets around nearby stars. One of the architectures being developed is the Formation Flying Interferometer (FFI). The FFI is envisioned to consist of up to seven spacecraft (as many as six 'collectors' with IR telescopes, and a 'combiner') flying in precise formation within f 1 cm of pre-determined trajectories for synchronized observations. The spacecraft-to-spacecraft separations are variable between 20 m and 100 m or more during observations to support various configurations of the interferometer in the planet-finding mode. The challenges involved with TPF autonomous operations, ranging from formation acquisition and formation maneuvering to high precision formation control during science observations, are unprecedented. In this paper we discuss the development of the formation acquisition sensor, which uses novel modulation and duplexing schemes to enable fast signal acquisition, multiple-spacecraft operation, and mitigation of inherent jamming conditions, while providing precise formation sensing and integrated radar capability. This approach performs delay synthesis and carrier cycle ambiguity resolution to improve range measurement, and uses differential carrier cycle ambiguity resolution to make precise bearing angle measurements without calibration maneuvers.

formation flying sensors↗
NASA NTRS2004

Relative Sensor with 4Pi Coverage for Formation Flying Missions

The Terrestrial Planet Finder (TPF) pre-project, an element of NASA s Origins program, is currently developing two architectures for a mission to search for earth-like planets around nearby stars. One of the architectures being developed is the Formation Flying Interferometer (FFI). The FFI is envisioned to consist of up to seven spacecraft (as many as six "collectors" with IR telescopes, and a "combiner") flying in precise formation within +/-1 cm of pre-determined trajectories for synchronized observations. The spacecraft-to-spacecraft separations are variable between 20 m and 100 m or more during observations to support various configurations of the interferometer in the planet-finding mode. The challenges involved with TPF autonomous operations, ranging from formation acquisition and formation maneuvering to high precision formation control during science observations, are unprecedented. In this paper we discuss the development of the formation acquisition sensor, which uses novel modulation and duplexing schemes to enable fast signal acquisition, multiple-spacecraft operation, and mitigation of inherent jamming conditions, while providing precise formation sensing and integrated radar capability. This approach performs delay synthesis and carrier cycle ambiguity resolution to improve range measurement, and uses differential carrier cycle ambiguity resolution to make precise bearing angle measurements without calibration maneuvers.

Tien, Jeffrey Y.↗
NASA NTRS2004

Formation acquisition sensor for the Terrestrial Planet Finder (TPF) mission

The Terrestrial Planet Finder (TPF) pre-project, an element of NASA’s Origins Program, is currently investigating multiple implementation architectures for finding earth-like planets around other stars. One of the technologies being developed is the Formation Flying Interferometer (FFI). The FFI is envisioned to consist of up to seven spacecraft, each with an infrared telescope, flying in precise formation within +/- l cm of pre-determined trajectories for synchronized observations. The spacecraft to- spacecraft separations are variable between 20 m to 100m during observations to support various interferometer configurations in the planet-finding mode. The challenges involved with TPF autonomous operations, ranging from formation acquisition and formation maneuvering, to high precision formation flying during science observations are unprecedented for deep space missions. To meet these challenges, the Formation Sensor Testbed (FST) under the TPF technology program will develop and demonstrate the key technology of the formation acquisition sensor. Key performance targets for the acquisition sensor are an instantaneous 4phi-steradian field of view and simultaneous range and bearing-angle measurements for multiple spacecraft with accuracy better than 50 cm and 1 degree, respectively. In this paper, we will describe the TPF FFI mission concept, the key formation flying challenges, the acquisition sensor design, the key design challenges, and the current plan to mitigate these design challenges.

Purcell, George H. Jr.↗