Search NASA⌕ Search

Engineering topics

Tong, M.

Publications and source records attributed to Tong, M..

Evaluation of structural analysis methods for life prediction

The utility of advanced constitutive models and structural analysis methods are evaluated for predicting the cyclic life of an air-cooled turbine blade for a gas turbine aircraft engine. Structural analysis methods of various levels of sophistication were exercised to obtain the cyclic stress-strain response at the critical airfoil location. Calculated strain ranges and mean stresses from the stress-strain cycles were used to predict crack initiation lives by using the total strain version of the strain range partitioning life prediction method. The major results are given and discussed.

Kaufman, A.↗

Structural response of an advanced combustor liner: Test and analysis

An advanced (segmented) combustor liner supplied by Pratt and Whitney Aircraft was tested in the structural component test rig at Lewis Research Center. It was found that the segmented liner operated at much lower temperatures than the conventional liner (about 400 F lower) for the same heat flux. At the lower temperatures and low thermal gradients, little distortion to the segments was observed. The operating conditions were not severe enough to distort or damage the segmented liner.

Moorhead, Paul E.↗

Structural analysis of turbine blades using unified constitutive models

The utility of advanced constitutive models and structural analysis methods in predicting the cyclic life of an air-cooled turbine blade is assessed. Five structural analysis methods were exercised in calculating the cyclic stress-strain response at the airfoil critical location. The methods studied were a cyclic elastic finite-element analysis, nonlinear finite-element analyses based on classical inelastic models and the unified models of Bodner and Walker, and a simplified inelastic procedure. These analyses were compared in terms of computing times and of predicted crack initiation lives using the Strainrange Partitioning method.

Kaufman, A.↗