Search NASA⌕ Search

Engineering topics

Torczynski, John R.

Publications and source records attributed to Torczynski, John R..

At least 19 records

Molecular-gas-dynamics simulations of turbulent Couette flow over a mean-free-path-scale permeable substrate

Here we report flow statistics and visualizations from molecular-gas-dynamics simulations using the direct simulation Monte Carlo (DSMC) method for turbulent Couette flow in a minimal domain where the lower wall is replaced by an idealized permeable fibrous substrate representative of thermal-protection-system materials for which the Knudsen number is O(10 -1 ). Comparisons are made with smooth-wall DSMC simulations and smooth-wall direct numerical simulations (DNS) of the Navier-Stokes equations for the same conditions. Roughness, permeability, and noncontinuum effects are assessed. In the range of Reynolds numbers considered herein, the scalings of the skin friction on the permeable substrate and of the mean flow within the substrate suggest that they are dominated by viscous effects. While the regenerative cycle characteristic of smooth-wall turbulence remains intact for all cases considered, we observe that the near-wall velocity fluctuations are modulated by the permeable substrate with a wavelength equal to the pore spacing. Additionally, the flow within the substrate shows significant rarefaction effects, resulting in an apparent permeability that is 13% larger than the intrinsic permeability. In contrast, the smooth-wall DSMC and DNS simulations exhibit remarkably good agreement for the statistics examined, despite the Knudsen number based on the viscous length scale being as large as O(10 -1 ). This latter result is at variance with classical estimates for the breakdown of the continuum assumption and calls for further investigations into the interaction of noncontinuum effects and turbulence.

42 ENGINEERING↗

Bubble Behavior in a Vertically Vibrating Enclosed, Liquid-Filled Cylinder

When subjected to certain harmonic oscillations, the gas bubble in a partially liquid-filled, closed, vertical cylinder will break up. Under certain conditions, some of the gas will migrate to the bottom due to Bjerknes forces. At sufficiently large amplitudes, the bubble will break up into gas bubbles at the top and bottom ends of the cylinder. High-speed imaging captured the dynamics of bubble breakup and gas migration. Several parameters were investigated: oscillation frequency, oscillation acceleration, gas volume fraction, and liquid viscosity.

42 ENGINEERING↗

Effect of slip on vortex shedding from a circular cylinder in a gas flow

Most studies of vortex shedding from a circular cylinder in a gas flow have explicitly or implicitly assumed that the no-slip condition applies on the cylinder surface. To investigate the effect of slip, vortex shedding is simulated using molecular gas dynamics (the direct simulation Monte Carlo method) and computational fluid dynamics (the incompressible Navier-Stokes equations with a slip boundary condition). A Reynolds number of 100, a Mach number of 0.3, and a corresponding Knudsen number of 0.0048 are examined. For these conditions, compressibility effects are small, and periodic laminar vortex shedding is obtained. Slip on the cylinder is varied using combinations of diffuse and specular molecular reflections with accommodation coefficients from zero (maximum slip) to unity (minimum slip). Although unrealistic, bounce-back molecular reflections are also examined because they approximate the no-slip boundary condition (zero slip). The results from both methods are in reasonable agreement. The shedding frequency increases slightly as the accommodation coefficient is decreased, and shedding ceases at low accommodation coefficients (large slip). The streamwise and transverse forces decrease as the accommodation coefficient is decreased. Based on the good agreement between the two methods, computational fluid dynamics is used to determine the critical accommodation coefficient below which vortex shedding ceases for Reynolds numbers of 60–100 at a Mach number of 0.3. Finally, conditions to observe the effect of slip on vortex shedding appear to be experimentally realizable, although challenging.

42 ENGINEERING↗

Feasibility of the LAMMPS SPH Package for Simulating Bubble Motion in Vibrating Containers

The Smoothed Particle Hydrodynamics (SPH) package within LAMMPS is explored as a possible tool for simulating the motion of bubbles in a vibrating liquid-filled container. As an initial test case, the unphysical but computationally less intense situation of a two-dimensional single bubble rising in a quiescent liquid under the influence of gravity is considered herein. Although physically plausible behavior was obtained under certain conditions, this behavior depends strongly on the system parameters. Moreover, the large density ratio between the liquid and bubble requires extremely small timesteps, which make the simulations undesirably computationally expensive. Ultimately, it was determined that this method is not feasible for providing quantitatively accurate results for the desired application.

42 ENGINEERING↗

Gas-Induced Motion of a Piston in a Vibrated Liquid-Filled Housing

We present that models and experiments are developed to investigate how a small amount of gas can cause large rectified motion of a piston in a vibrated liquid-filled housing when piston drag depends on piston position so that damping is nonlinear even for viscous flow. Two bellows serve as surrogates for the upper and lower gas regions maintained by Bjerknes forces. Without the bellows, piston motion is highly damped. With the bellows, the piston, the liquid, and the two bellows move together so that almost no liquid is forced through the gaps between the piston and the housing. This Couette mode has low damping and a strong resonance: the piston and the liquid vibrate against the spring formed by the two bellows (like the pneumatic spring formed by the gas regions). Near this resonance, the piston motion becomes large, and the nonlinear damping produces a large rectified force that pushes the piston downward against its spring suspension. A recently developed model based on quasi-steady Stokes flow is applied to this system. A drift model is developed from the full model and used to determine the equilibrium piston position as a function of vibration amplitude and frequency. Corresponding experiments are performed for two different systems. In the two-spring system, the piston is suspended against gravity between upper and lower springs. Lastly, in the spring-stop system, the piston is pushed up against a stop by a lower spring. Model and experimental results agree closely for both systems and for different bellows properties.

42 ENGINEERING↗