Search NASA⌕ Search

Engineering topics

Tran, N.

Publications and source records attributed to Tran, N..

28 records · Page 2

Criticality safety administration in legacy waste management - 14613

Canadian Nuclear Laboratories (CNL) is Canada's largest nuclear science and technology laboratory, with a long history in developing and progressing in the field of nuclear science. In the early years of nuclear science and technology development, there were practices used for nuclear material storage and management that have led to recent challenges in meeting current regulatory (Canadian Nuclear Safety Commission) safety requirements. There are over 900 storage locations where significant amounts of experimental fuel and operations fuel are stored, with varying degrees of administrative rigor being applied over the last 60+ years. To determine the safety of the stored materials, it was impracticable to examine every location to determine the status of fissile material composition. A risk graded approach was developed to first administratively determine the locations that were at risk, followed by comparison to upper subcritical limits. This narrowed the area of concern from >900 locations to approximately >70 locations. Locations of concern were then modeled with more accurate geometry, reflection and moderation conditions to further narrow down the selection area. This further narrowed the locations of concern to 32. Reducing overall risk, this small selection of locations have been selected for non-destructive imaging/examination and further analysis to confirm geometry to ensure criticality safety in all the storage locations. (authors)

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Design and testing of the first 2D Prototype Vertically Integrated Pattern Recognition Associative Memory

An associative memory-based track finding approach has been proposed for a Level 1 tracking trigger to cope with increasing luminosities at the LHC. The associative memory uses a massively parallel architecture to tackle the intrinsically complex combinatorics of track finding algorithms, thus avoiding the typical power law dependence of execution time on occupancy and solving the pattern recognition in times roughly proportional to the number of hits. This is of crucial importance given the large occupancies typical of hadronic collisions. The design of an associative memory system capable of dealing with the complexity of HL-LHC collisions and with the short latency required by Level 1 triggering poses significant, as yet unsolved, technical challenges. For this reason, an aggressive R&D program has been launched at Fermilab to advance state of-the-art associative memory technology, the so called VIPRAM (Vertically Integrated Pattern Recognition Associative Memory) project. The VIPRAM leverages emerging 3D vertical integration technology to build faster and denser Associative Memory devices. The first step is to implement in conventional VLSI the associative memory building blocks that can be used in 3D stacking, in other words, the building blocks are laid out as if it is a 3D design. In this paper, we report on the first successful implementation of a 2D VIPRAM demonstrator chip (protoVIPRAM00). The results show that these building blocks are ready for 3D stacking.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Study of C-coated LiFe{sub 0.33}Mn{sub 0.67}PO{sub 4} as positive electrode material for Li-ion batteries

Commercial C-LiFe{sub 0.33}Mn{sub 0.67}PO{sub 4} positive electrode material has been investigated by {sup 57}Fe Moessbauer Spectroscopy (MS), X-ray Photoelectron Spectroscopy (XPS) and X-ray Absorption Spectroscopy (XAS). The combined use of these experimental techniques provides a better understanding of the electrochemical reaction involved during cycling. {sup 57}Fe MS is very efficient to directly follow oxidation state of Fe in the electrode, and gives surprisingly indirect information on the oxidation state of Mn as observed by XAS and XPS. The electrochemical mechanism is proposed based from in situ and operando investigations using both MS and XAS, and is consistent with XPS surface studies. XPS analysis of the electrodes at the end of charge (4.4 V) reveals enhanced electrode/electrolyte interface reactivity at this high potential. Aging of C-LiFe{sub 0.33}Mn{sub 0.67}PO{sub 4}/Li cells after 50 cycles at 60 Degree-Sign C indicates a rather good electrochemical behavior (low capacity fading) of the electrode material. Both {sup 57}Fe MS and XPS (Mn 2p and Fe 2p) clearly show no modification on Fe and Mn oxidation state compared to fresh electrode confirming the good electrochemical performances. - Graphical abstrct: Quantitative evaluation of the Fe{sup 3+} and Mn{sup 3+} content during the first charge/discharge cycle obtained from K-edge XANES spectra of C-LiFe{sub 0.33}Mn{sub 0.67}PO{sub 4} recorded upon cell operation at RT with C/10 rate. During the charge co-existence of Fe and Mn oxidation is observed between points 2 and 4 of the potential curve. At the end of the charge the cut-off voltage limits the oxidation at about 93%. Highlights: Black-Right-Pointing-Pointer C-LiFe{sub 0.33}Mn{sub 0.67}PO{sub 4} electrode material upon cycling vs. metallic lithium. Black-Right-Pointing-Pointer {sup 57}Fe Moessbauer spectroscopy is a (in)direct probe for Fe(Mn) oxidation state. Black-Right-Pointing-Pointer Both K-Fe and K-Mn edges XAS show a simultaneous oxidation of Fe{sup 2+} and Mn{sup 2+} in a small range of compositions. Black-Right-Pointing-Pointer Surface analysis from XPS allows reveals slight differences at the surface of the electrode with respect to the bulk.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Combining TOPEX and SeaWinds Data to Refine Models for Ocean Surface Emissivity: Wind Vector Signatures at 18, 21 and 37 GHz

TOPEX Microwave Radiometer (TMR) brightness temperature observations at 18, 21, and 37 GHz have been collocated with near-simultaneous SeaWinds wind vector data as well as with a monthly SST climatological product. The combined data set allows us to study the dependence of ocean surface emissivity (at each frequency) upon both wind speed. Results show clear two-branch wind speed dependence; weak and linear below 6 m/s with an abrupt increase in sensitivity above that point. The analysis also shows that the zenith-directed ocean surface emissivity is polarization dependent above wind speeds of 5-6 m/s with an azimuthal variation related to the wind direction. This last result accords with recent polarimetric radiometer observations collected from aircraft. Implications of these observations to water vapor retrieval algorithms, nadir-viewing polarimetry, and ocean emission modeling will be discussed.

Vandemark, D.↗

The Dependence of Ocean Surface Emissivity on Wind Vector as Measured with TMR

Global TMR brightness temperature observations at 18, 21, and 37 GHz have been colocated with near-simultaneous SeaWinds wind vector data as well as with a monthly SST climatological product. The combined data allow us to study the dependence of ocean surface emissivity, at each frequency, upon both wind speed and direction. Results show a clear two-branch wind speed dependence; weak and linear below 6 m/s with an abrupt increase in sensitivity above that point. Our analysis also shows that the nadir-view ocean surface emissivity depends on the angle between the wind direction and TMR's antenna polarization orientation.

Tran, N.↗